過流閥 的英文怎麼說

中文拼音 [guòliúfá]
過流閥 英文
excess flow valve
  • 過 : 過Ⅰ動詞[口語] （超越） go beyond the limit; undue; excessiveⅡ名詞（姓氏） a surname
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 閥 : 名詞1 （指在某方面有支配勢力的人物或家族） established house or power group; a powerful person or...
  1. Our main products are micro barometer low pressure gauge low pressure capsule gauge vacuum pressure with low pressure gauge pressure gauge with electrical contact shock - proof electric contact gauge stainless steel pressure gauge dry and glycerin filled pressure gauge normal pressure gauge freon pressure gauge oxygen - acetylene pressure gauge stainless steel vacuum pressure gauges series diaphragm seal pressure gauge diaphragm pressure gauge with electrical contact pp diaphragm seal pressure gauge shock - proof pressure gauge with electrical contact diaphragm seal pressure gauge explosion - proof electric contact pressure gauge minitype pressure gauge accurate pressure gauge test pressure gauges as well as pressure gauge switch pressure separator tube pressure gauge radiator double - metal thermometer all the products can meet both national and international stands,

    一般壓力表氣壓表抗震壓力表充油壓力表全不銹鋼壓力表膜盒微壓表電接點壓力表冷媒壓力表真空壓力表壓力真空表隔膜壓力表微型壓力表差壓表微差壓表絕壓表精密壓力表耐高溫壓力表蒸氣壓力表汽車燃氣壓力表醫用壓力表遠傳壓力表衛生型壓力表壓力表緩沖管壓力表冷凝散熱器壓力表翅片散熱器壓力表開關不銹鋼連接彎管不銹鋼連接軟管轉換接頭油壓連接頭壓力表針閥節流閥及過壓保護附件濾油網加油口油溫油麵計雙金屬溫度計等。
  2. Analysis is made on structure characteristics of the finned - tube, and analysis has been made on the special heat and mass transfer principle of every micro - unit under both dry and wet conditions. appropriate hypothesis is made and based on the energy, mass and momentum equivalent, the evaporator models of dynamic distributed parameters are set up. in addition, the gascooler and internal exchanger models of dynamic and distributed parameters, the throttling valve models and the compressor models are set up, too

    本文的內容如下： 1對翅片管蒸發器的結構特點進行分析，選取適當的微元體，對于干、濕工況下每個微元分別進行傳熱傳質分析，通過適當的假設，利用質量守恆方程、能量守恆方程和動量守恆方程建立了蒸發器的分佈參數數學模型；對回熱器劃分微元建立了分佈參數數學模型；對氣體冷卻器建立了分佈參數數學模型；對壓縮機建立了數學模型；建立了節流閥的數學模型，為系統模擬奠定了基礎。
  3. The making of the slurry valve with high chromium white cast iron

    應用新型高鉻白口鑄鐵製造渣漿閥過流件
  4. Water shutoff agent dsz - a is composed of inorganic particle. its specialities are low cost, easily flow, high strength and long valid period. the agent suits non - selective water shutoff in sand formation. dsz - a not only can plug high water - bearing formation, but also can plug case leakage. dsz - a has been applied on site and gotten good effect. it is a agent which has wide prospect

    井下護泵除砂裝置主要用於產液氣量高，出砂能力大，利用常規裝置、常規方法很難治理的井.它的設計是建立在丟手封隔器卡封的基礎上，將液體攜砂能力由地層進入泵管轉變為先過濾（雙層激光割縫篩管部分） ，再在除砂器內靜態沉澱、由單流閥排入井底等一系列除砂護泵優點.本文著重介紹了井下護泵除砂裝置的工作原理與應用情況
  5. Specification for spill valves for use in marine tank liquid overpressure protections applications

    船上儲罐液體過壓保護裝置溢流閥規范
  6. Standard specification for spill valves for use in marine tank liquid overpressure protections applications

    船上儲罐液體過壓保護裝置用溢流閥
  7. Here are three parts in this thesis : building steady state model and transient model for water hydraulic valves. research on the property of flow field inside water hydraulic valves. analysis of the force on water hydraulic valves

    論文主要包含三部分的內容：水壓閥穩態模型和瞬態模型的建立；水壓閥內流場過流特性的研究；作用於水壓閥閥芯及閥體上的力特性分析。
  8. Q41f - 10c catena pad fluorine valve, q41f - 10cf catena pad fluorine valve, j41f - 16 pad fluorine end - valve, j44f - 16 angle form pad fluorine end - valve, sj41f - 10c pad fluorine inspect - lens, the connect form is flange, the passing parts of valve - body lumen and valve - cover valve - core etc. are all metal pad fluorine plastic inside, rotproof excellently

    Q41f - 10c系列襯氟球閥， q41f - 10cf系列襯氟放料閥， j41f - 16系列襯氟截止閥， j44f - 16系列襯氟角式截止閥， sj41f - 10c襯氟視鏡，連接形式為法蘭式，閥體內腔及閥蓋閥芯等過流部件均為金屬內襯氟塑料，耐腐蝕性能優異。
  9. The catena products design for stsrting closing controling of diversified strong corrosive medium, configuration form is float through form, connect form is flange, the passing parts of valve - body lumen and valve - cover valve - staff etc. are all metal pad fluorine plastic inside, rotproof excellently. the product have son - catena j41f - 16 pad fluorine end - valve and j44f - 16 angle form pad fluorine end - valve choosing to use

    本系列產品是為各種強腐蝕性介質的啟閉控制而設計，結構形式為直通式和角式，連接形式為法蘭，閥體內腔及閥蓋閥桿等過流部件均為金屬內襯氟塑料，耐腐蝕性能優異。
  10. According to theoretical analysis and experiments on the throttle control system, the quantitative relationship among the speed of executive element, the flow area of the throttle and the load is determined

    本文通過對進油路節流調速系統的理論分析與試驗研究，闡明了執行元件的運行速度與節流閥的通流面積以及負載之間的定量關系。
  11. Abstract : according to theoretical analysis and experiments on the throttle control system, the quantitative relationship among the speed of executive element, the flow area of the throttle and the load is determined

    文摘:本文通過對進油路節流調速系統的理論分析與試驗研究，闡明了執行元件的運行速度與節流閥的通流面積以及負載之間的定量關系。
  12. Air filtration portfolio, air filters, valve, oil mist machine, filter valve, oil mist separator, micro - mist separator, stability activated solenoid valve, pressure gauge, micro - valve and vacuum valves, links the release of the closure - pressure valves, and pipe connection, a one - way valve, t - shelves, shelves, brackets, diaphragm - type flow switches, blades type flow switches, further growth actuator, the valve lock, precision valve, pressure switches, mechanical pressure switches, pneumatic control ratio positioning devices, and electric - gas ratio positioning devices, and telecommunications - pressure converters, electro - pneumatic proportional valve, filter valve, shuttle valve, gas - electric relay and gas indicator, delay pneumatic valve and cylinder fcl, plumbing fcl, mufflers and exhaust cleaner, the excess flow valve with silencer, a one - way valve, rapid valve, rapid joints, rapid valve with fcl, rapid joint sub - cluster gas, micro joints, gas pipes, pipe from the devices, and helical coils, pipes, channels, scissors, multiple fastener, high - speed rotary joint, 10000 threaded joints, and insert the tube joints, rotary joints began, 68. 25 rapid joints and hoses, hose fittings and rapid non - electrostatic

    空氣過濾組合空氣過濾器減壓閥油霧器過濾減壓閥油霧分離器微霧分離器穩定啟動電磁閥壓力表微型減壓閥減壓氣閥三通釋放式截流閥壓力開關管接頭單向閥t型隔板隔板托架膜片型流量開關漿葉型流量開關增速繼動器鎖定閥精密減壓閥壓力開關機械式壓力開關氣控比例定位器電-氣比例定位器電訊號-氣壓轉換器電-氣比例閥過濾減壓閥梭動閥氣-電繼電器氣源指示器氣動延時閥氣缸限流器管道限流器消聲器排氣潔凈器限流閥帶消聲器單向止回閥快速排氣閥快速接頭快速排氣閥帶限流器快速接頭集束分氣微型接頭氣喉管喉管脫離器螺旋管排管管道剪刀多管扣件高速旋轉接頭萬用螺紋接頭插入式管接頭旋式緊鎖接頭難燃性快速接頭和軟管不帶靜電快速接頭和軟管
  13. Filters should be installed with by - pass and block valves to permit by - passing the filter during element changes if the stream cannot be shut down to allow element changes

    假如在更換濾芯時不能關閉液流，就應該在過濾器上安裝旁通閥和斷流閥，以便在更換濾芯期間使液流從旁路繞過過濾器。
  14. I used nose attitude instead of modulating engine thrust to control airspeed during the climb to 15, 000 feet

    在爬升至15 ， 000英尺高度的過程中我用機首的高度代替發動機節流閥來控制飛行速度。
  15. The relationship between the flow capacity and inner structure is the guidance to the structure design and fluid road design, so the change of the structure is of importance

    清洗液閥的內部結構和過流能力的一般關系是通過大量的有限元計算而得出的，對各類閥門的結構和流道設計有指導作用，因此清洗液閥的改型具有重要的意義。
  16. This paper discussed the relationship of the flow capacity and the inner structure, completed the numerical simulation of flow field and the characteristic of resistance, set up the finite element model and done the finite element calculation of the existing component and the improvement component of the cleaning valve, and done the experimentation manner

    對清洗液閥門現在的型號和改進的型號的流道形狀建立有限元模型，進行有限元分析計算，獲得相應的過流能力的值，並進行比較，提出提高過流能力的新方案，並針對理論計算提出實驗系統方案。
  17. This type of strainer is usually installed upstream of most of the devices in the system including the meters, backflow preventers ( or detector check valves ) and flow alarms, in order to protect these devices from damage caused by large particles

    這種類型的過濾器通常安裝在系統內大多數設施的上游，包括儀表，防迴流閥（或檢測止回閥）和水流警報裝置等，從而保護這些設施不會被大顆粒損壞。
  18. The simulation shows that the valve throttle area should be little as possible but must be more than 40 % of pipe section area ; when the total length of pipe is same, and the flow quantity is enough, pipe before primary valve should be thin and long, and the pipe after primary valve should be thick and short, the upriver and downriver small pressure fluctuation will badly lead to waterdrammer pressure rising, and spending more time in establishing pressure and flow quantity

    模擬表明，閥門過流面積在滿足大於管道截面積40 %的條件下應盡可能小;在管道總長一定並滿足流量要求的條件下，主閥前應採取長而細的管道，閥后則應採用短而粗的管道;上下游微小的壓力波動都會嚴重增大開關閥門引起的水擊，並使壓力、流量的建立需要更長的時間。
  19. A strainer should be installed as shown, ahead of backflow preventer to prevent disc from unnecessary fouling

    應該如圖所示安裝過濾器，使其位於防迴流閥之前，防止閥瓣產生不必要的積垢。
  20. Air braking systems - charging valves

    氣壓制動系統.過流閥
分享友人
分享到 Line

分享到臉書