道流板 的英文怎麼說
中文拼音 [dàoliúbǎn]
道流板
英文
repeller-
Abstract : apply computer simulation to the distribution pattern of air - flow without considering the cold condition of the combustion and compare the flow patterns under different designed circumstances. and the effect of the design of the partition in the air way of the burner on the flow and mixture of gas and air is especially studied. the result shows that the design of partition plays a very important role in strengthening the mixture of gas and air, but increases the loss of the resistance in the air way and the total pressure of the air way in same working conditions needs increasing
文摘:應用計算機模擬的方法,在不考慮燃燒的冷態情況下,研究了熱風爐燃燒室內的氣流分佈規律.在此基礎上,比較了2種不同設計方案的氣流流動特徵,尤其是研究了燃燒器空氣通道內阻流板的設置與否對空氣和煤氣的流動和混合的影響.結果表明,阻流板的設計對加強空氣和煤氣的混合有著極為重要的作用,同時也增加了空氣管道的阻力損失,在同樣的工況條件下需要提高管道系統的總壓力Firstly, simulate flow field of rear smoke channel, plot velocity magnitude and ash concentration distribution in section of entry of heat pipe air preheater, compare with data which were measured in guiyang power station, verify simulation to be reasonable and right. secondly, simulate all kinds of factors which affect flow field ' s uniformity such as length, thickness, location of diffluent board, ash concentration, ash diameter, and so on, find the chiefly factors. thirdly, install guide board in curve channel in rear smoke channel, then simulate its " flow field, plot velocity magnitude and ash concentration distribution
在此基礎上模擬在冬夏兩季不同情況下,不同流速對熱管空氣預熱器壁面溫度的影響;然後對影響整個流場分佈的各種因素:包括分流板長度、厚度、偏離中心流道位置的偏離度、飛灰濃度、飛灰粒徑等因素進行數值模擬;最後提出在分流煙道轉彎處加裝導流板,並模擬加裝導流板后的流場分佈,得到下級空氣預熱器出口、熱管空氣預熱器進口處的斷面速度場分佈、濃度場分佈,以論證加裝導流板能達到流場均勻化的作用。Numerical simulation of intermediate flow field of confined pipeline with duple orifice
有壓管道雙孔板過流流場的數值模擬Nevertheless, the quality of hong kong music is still uninspiring, with manufactured pop, formulaic ballads and lacklustre covers ruling the roost
不過,香港音樂的素質還是令人無法領教,粗製濫造的流行歌、老掉牙的情歌以及死板的口水歌仍舊當道。Installed in the water - world are several sets for water - sports, such as high - platform speed - changing slide, rocking slide, 45 sliding - board and massaging pond, etc
在水上時間里設有數組水上游樂項目,其中有高臺變速滑道、搖滾滑道、 45奔流沖浪滑板,還有按摩池等項目。The research object of this thesis is a chip - array that is fixed on one of printed circuit boards ( pcb ), which are located in a forced air field ( forced convection ) in an electronic case ; and from the essential equations of airflow we can deduce the mathematical model of the turbulent flow ; then we can establish the finite element algorithm and apply the fe software to work out the equations of turbulent flow, finally we can use the software to display and analyse the field of flow and temperature
本文以處于強迫空氣對流流場中的某pcb板及其板上的電子元件陣列作為研究對象,推導了紊流流場的數學模型,並建立了相應的有限元求解格式,應用有限元法分析軟體對該系統的紊流流場和溫度場進行了模擬分析:解算出pcb板上各電子元件的溫度分佈;並提出了用於求解系統風道特性曲線的cfd方法。Graphite packing, carbonized packing, kevlar packing, ptfe packing ningbo sinklan industry trade co., ltd. is mainly engaged in producing three kinds of sealing products, packing series, gasket series, packing gasket sheet series. such as various fiber packingmetallic gasket, non - metallic gasketssheet gasket material, and reinforced composite sheet sealing material. packing series : expanded graphite packing, reinforced graphite packing, die - formed graphite ring packing expanded graphite molded packing, carbonized fiber packing, kevlar fiber packing, pure ptfe packing, ptfe graphite packing, ramie fiber braided packing, asbestos packing, ptfe graphite packing aramid corners, graphite ptfe packing inter aramid, acrylic fiber packing, novolid fiber with ptfe packing, carbon fiber packing, ptfe filament packing, ptfe lubricant packing, cotton with oil packing, e - glass fiber packing etc
公司生產出口各類流體密封材料及製品,主要有密封盤根,密封墊片和密封材料三大系列產品,如石墨盤根芳綸盤根,碳纖維盤根, ptfe盤根,各種金屬墊片,纏繞墊片石墨增強墊片石墨切割墊片, ptfe墊片石棉墊片,非石棉墊片,各種墊片板材,卷材,四氟介面密封帶,閥桿填料,盤根線等等,廣泛應用於石化煉油電力鋼鐵造船海洋工程等行業不但解決了國內許多電廠煤氣廠化工廠等泵浦閥件管道在各種氣體化學流體輸送中的密封泄露問題,已為眾多知名企業所指定和選用而且已大量出口到歐洲中東南美洲以及東南亞等許多國家和地區。Graphite packing, carbonized packing, kevlar packing, ptfe packing ningbo sinklan industry trade co., ltd. is mainly engaged in producing three kinds of sealing products, packing series, gasket series, packing gasket sheet series. such as various fiber packingmetallic gasket, non - metallic gasketssheet gasket material, and reinforced composite sheet sealing materialpacking series : expanded graphite packing, reinforced graphite packing, die - formed graphite ring packing expanded graphite molded packing, carbonized fiber packing, kevlar fiber packing, pure ptfe packing, ptfe graphite packing, ramie fiber braided packing, asbestos packing, ptfe graphite packing aramid corners, graphite ptfe packing inter aramid, acrylic fiber packing, novolid fiber with ptfe packing, carbon fiber packing, ptfe filament packing, ptfe lubricant packing, cotton with oil packing, e - glass fiber packing etc
公司生產出口各類流體密封材料及製品,主要有密封盤根,密封墊片和密封材料三大系列產品,如石墨盤根芳綸盤根,碳纖維盤根, ptfe盤根,各種金屬墊片,纏繞墊片石墨增強墊片石墨切割墊片, ptfe墊片石棉墊片,非石棉墊片,各種墊片板材,卷材,四氟介面密封帶,閥桿填料,盤根線等等,廣泛應用於石化煉油電力鋼鐵造船海洋工程等行業不但解決了國內許多電廠煤氣廠化工廠等泵浦閥件管道在各種氣體化學流體輸送中的密封泄露問題,已為眾多知名企業所指定和選用而且已大量出口到歐洲中東南美洲以及東南亞等許多國家和地區A research into the effect of funnel mcp on the relationship between current gain and noise figure
擴口微通道板對電流增益和噪聲因子關系的影響Heat accumulating floor with hae of porous material 15 cubic meter, inside the floor there are perforated pipes of 35 sm in diameter to supply hot air from hss and pss. - the heating amount - 66228 kwh h for 6500 degree - days of heating period
溫室地板鋪15平方米的蓄熱地板,地板使用多孔蓄熱材料,地板內還布有多孔管道,綜合太陽能系統和被動太陽能系統加熱后的空氣就從這些管道流到地板。Based on analysing all kinds of sediment silting basins and their suitable conditions, the traditional sedimentation basin has been improved in three aspects, i. e., setting an adjusting flow board in the fore of setting basin, adding a spillway trough along the flow direction, and redesigning the flush gallery by adding auxiliary flushing facilities
摘要在對各種類型沉沙池及適用條件進行分析的基礎上,通過在沉沙池的首部加調流板、在溢流堰上沿水流方向設溢流槽、對沖沙廊道進行改進並設置輔助沖沙設施這3個方面對傳統沉沙池進行了改進。The results indicated with the re raising, the rectangle channel ' s heat transfer enhanced gradually, which channel installed the baffle on its above and below
實驗結果表明,上下壁面安裝折流板的矩形通道中,隨著來流雷諾數re的增加,通道換熱效果逐步增強。The obtained results indicate that the concentrations of reactants in the catalyst layers in front of t he current collectors are very low, that reduce the utility of catalyst ; the current density at the edges of the channels is many times greater than the mean current density
計算了電池內反應物濃度的分佈、電流密度分佈、甲醇竄流以及電壓-電流特性曲線等。結果表明:集流板前的催化層內反應物濃度非常低;流道邊緣附近電流密度比平均電流密度大許多倍。When in experiment, the air was heated by the film heater installed on the above and below surface of channel, adopting various air velocity of flow, test import ' s and export ' s temperature, wall temperature, fluid flux and the drop of pressure, and the other parameter. adopting nu and nu0 to analyze the baffle ' s situation of heat transfer and fluid flow, which baffle was holed various diameters
實驗時,通過矩形通道上下壁面敷設的電加熱膜加熱通道空氣,改變空氣流速,測試不同工況時的進出口溫度、壁面溫度、流體流量和壓力損失等參數,並採用無量綱努謝爾特準則數nu 、 nu _ 0等分析了設置不同開孔折流板的換熱與流動情況。The full flow field characteristics of a supersonic inlet are illustrated at design conditions ; the influence of attack angle on flow field of the inlet is investigated ; b - spline theory is used to model the inlet with attack angle
給出了設計狀態下進氣道內外流場特徵;分析了攻角變化對進氣道流場的影響;以數值模擬結果為基礎,利用b樣條理論建立了反映攻角、馬赫數及可調斜板角度變化的超聲速進氣道數學模型。Standard and non - standard hot runner system, dies, nozzles, valves style nozzles, streaming panels, temperature controls, timing controls
熱流道模具噴嘴閥式噴嘴分流板溫度控制器時序控制器This paper focuses on the use of cae in solving the problems of melt lines and bright spots, which can be found on the wind channel mold of haier washer machine. and the problems are successfully solved on the rheological theory
利用cae技術研究了海爾洗衣機風道蓋板模具中出現的熔接痕和亮斑問題,並在流變學理論的指導下成功地設計出了符合實際生產需要的解決方案。Meet with the chef to review daily specials ; update board throughout shift. ensure that staffs are aware of such
每天與廚師溝通,查詢每日特色,並在班前更新在交流板上保證所有員工知道。We studied its characteristics of enhanced heat transfer and flow resistance. this article analyzed the influence of some parameters on channel ' s enhanced heat transfer and flow resistance. such as re, the hole ' s diameter with no unit d / 1, level center distance with no unit sl / 1 and vertical center distance s2 / l etc. and compared the characteristics with the no hole baffle
本文對通道內設置多種開孔折流板的換熱與流動阻力特性進行了實驗研究,討論分析了雷諾數re以及通道內設置開孔折流板的無量綱孔徑d w 、無量綱水平中心距s1 w和無量綱垂直中心距s2 w等多個參數對通道強化換熱與流動阻力特性的影響。This study got a lot of test data about the characteristic of enhanced heat transfer and flow resistance. it has reference value to the different kind of heat exchanger
本文得到了大量的設置折流板通道的有關強化傳熱與流動阻力特性的實驗數據,對各類換熱器的強化研究具有一定的參考價值。分享友人