酸浸處理 的英文怎麼說

中文拼音 [suānjìnchǔlǐ]
酸浸處理 英文
acid leach treatment
  • 酸 : 酸構詞成分。
  • 浸 : Ⅰ動詞1 （泡在液體里） soak; steep; immerse 2 （液體滲入） soak; saturate; steep Ⅱ副詞[書面語] （...
  • 處 : 處名詞1 （地方） place 2 （方面; 某一點） part; point 3 （機關或機關里一個部門） department; offi...
  • 理 : Ⅰ名詞1 （物質組織的條紋） texture; grain （in wood skin etc ） 2 （道理;事理） reason; logic; tru...
  1. Ferrous sulphate treatment improves the erosion rate of the alubrass. the corrosion rates observed are however higher than that obtained with mexel 432

    硫酸亞鐵處理改善鋁黃銅的浸蝕率，然而其腐蝕率仍高於m . 432處理。
  2. To study the determination of sulfite in food by pararosaniline hydrochloric spectrophotometry, then according to the sample characteristic, the treatment select soak, ultrasonic and distill

    摘要通過對測定食品中亞硫酸鹽過程進行研究，根據樣品的特性不同對所採集的樣品採用浸泡、超聲和蒸餾三種前處理方法。
  3. The experiments results showed that when concentration of solid substance of the waste aqueous solution was condensated to 13 % ( w / v ) on vacuum, 95 % alcohol ( 1 : 1, v / v ) was added to the condensated solution to sedimentate polysaccharose, sedimentation was centrifugalized, repeated above treatment, and filtrate was collected and condensated on vacuum, then chlorogenic acid crystal of 76 % purity was obtained

    多次實驗結果表明，浸提液濃縮到固形物含量在13 %時，加入浸提濃縮液體積1倍量的95 %的乙醇沉澱並過濾掉多糖，反復處理兩次，濾液再經真空濃縮得到純度76 %左右的綠原酸。
  4. The physical methods include mechanical scarification, low and high temperature, hydration - dehydration, irradiation, high pressure and other physical treatments, and the chemical ones include acid scarification, alkali solution soaking and other organic chemical treatments

    物理方法有機械損傷、低溫和高溫處理、干濕交錯處理、輻射和高壓處理等；化學方法有酸蝕、堿液浸泡和有機溶劑等處理。
  5. Therefore, the above two areas were chosen to select five maternal plants, then branches collected from the five maternal plants were used to carry out cutting seedling test, results showed as the follows : when one - year - age branches without treating were applied in cutting seedling test, the average survival rate reached to 88 %

    從以上2個片區選取了5個優良母株插條進行?插試驗，結果表明： 1年生幼年枝未經任何處理?插平均成活率達到88 % ；成年枝?插，經過吲哚乙酸浸泡處理比無處理平均成活率顯著提高，達到68 % ，而無處理平均成活率僅有29 . 2 % 。
  6. Abstract : this paper introduces a kind of special technology to treat low grade molybdate and sodium molybdate which makes frist ammonium leaching of molybdenum up to above 96 %, and frist bases leaching of molybdenum up to above 97 %, with the 0. 5 % 1. 0 % of total molybdenum amount washed away and the less than 4 % of molybdenum amount thrown away. consequently, the solution and product has gained arise of high purity

    文摘:介紹了處理低品位鉬精砂生產鉬酸銨及鉬酸鈉的工藝，鉬的一次氨浸率達96 %以上，一次堿浸率達97 %以上，隨同廢液流失的鉬占總投入鉬量的0 . 5 % 1 . 0 % ，棄渣含鉬小於4 % ，所得溶液及產品純度高。
  7. Results there were 3 pathological characteristics in alhe : massive hyperplasia of capillaries in the dermis ; the endothelial cells proliferated and swelled, projecting into vascular cavity like tombstones ; mixed infiltration of lymphocytes and eosinocytes in the vessels

    結果伴嗜酸性粒細胞增多性血管淋巴樣增生在病理學上有其特徵，形態學上的改變主要表現在以下3個方面：真皮內大量毛細血管增生；血管內皮細胞增生腫大，似「墓碑」狀突入血管腔；病變處有淋巴細胞、嗜酸性粒細胞混合浸潤。
  8. Prepare the spotting slides soak the cover slides in chromic acid solution for more than 12hrs, wash to clean, soak in naoh, in acetone, in arm molecule solution for connecting, roast to fix the groups, ready for use

    基片的處理和制備取蓋玻片，鉻酸洗液中浸泡過夜，洗凈， naoh浸泡，丙酮化，手臂分子連接，清洗，烘烤固定，醛基修飾。
  9. The pretreatment, effect of bath compositions and operation conditions such as temperature, currenty and time on compactness of the zinc and cu / ni / cr coatings have been investigated. the relationship of operation conditions to thickness of the coatings was studied by weight method. the specimens have been pickled in nacl or sulfate acid solution to evaluate the porosity of the coating

    研究了鎂合金電鍍前處理工藝，電鍍鋅、電鍍銅/鎳/鉻工藝配方及其施鍍溫度、電流密度和時間對鍍層緻密性的影響;採用稱重法研究施鍍工藝與鍍層厚度的關系，利用nacl溶液和硫酸溶液浸泡試樣來考察鍍層孔隙率，採用劃痕試驗和熱震試驗檢驗鍍層的結合力，採用金相顯微鏡和掃描電子顯微鏡觀察鍍層表面形貌。
  10. Aluminium and aluminium alloys - anodizing - assessment of quality of sealed anodic oxidation coatings by measurement of the loss of mass after immersion in phosphoric acid chromic acid solution with prior acid treatment

    鋁和鋁合金.陽極氧化.測定預先酸處理的浸入磷酸鉻酸溶液后質量損失評估密封陽極氧化鍍層質量
  11. Aluminium and aluminium alloys - anodizing - assessment of quality of sealed anodic oxidation coatings by measurement of the loss of mass after immersion in phosphoric acid chromic acid solution without prior acid treatment

    鋁和鋁合金.陽極氧化.測定未預先酸處理的浸入磷酸鉻酸溶液后質量損失以評估密封陽極氧化鍍層質量
  12. Aluminium and aluminium alloys. anodizing. part 6 : assessment of quality of sealed anodic oxidation coatings by measurement of the loss of mass after immersion in phosphoric acid chromic acid solution without prior acid treatment

    鋁和鋁合金.陽極化.第6部分:通過未預先進行酸處理的情況下浸入到磷酸鉻酸溶液中的質量損失的測量對密封陽極氧化層質量的評估
  13. Aluminium and aluminium alloys - anodizing - part 7 : assessment of quality of sealed anodic oxidation coatings by measurement of the loss of mass after immersion in phosphoric acid chromic acid solution with prior acid treatment

    鋁和鋁合金.陽極化處理.第7部分:通過測量預先經過酸處理的磷酸和鉻酸溶液浸漬后的質量損失評估密封陽極氧化鍍層的質量
  14. This article is about the polymer separator full of holes, we research the performance of the separator, including making two kinds separters that produce wth complete different methods : spreading the separator, pvdf as the basic material, dbp as the plasticizing agent, nm sio2 as the inorganic addition and acetone as the solvent, and make separator on the special machine ; dipping in the separator so that intensify the seprater, its dip liquor is as the liqure as the spreading separator, and dip the base material pp / pe / pp into the liquor for more than 2 hours

    本文對多孔聚合物電解質隔膜進行了綜合研究。以聚偏氟乙烯（ pvdf ）為基體，鄰苯二甲酸二丁酯（ dbp ）為增塑劑，納米sio2為無機添加劑，丙酮為溶劑，在流延機上塗布得到了聚合物電解質隔膜。以流延法制備隔膜的漿料為處理液，將基體材料pp / pe / pp浸泡在處理液中2h以上，制備出強化電解質隔膜。
  15. Determination of cadimium in cucumber with four types of sample preparation methods, i. e. digestion using nitric acid and perchloric acid, microwave digestion using nitric acid, digestion using sulfuric acid and hydrogen peroxide and extraction using hydrochloric acid were compared

    摘要本文通過比較研究了濕式消解法、微波消解法、硫酸過氧化氫快速消解發、鹽酸浸提法等四種前處理方法測定黃瓜中鎘含量。
  16. Micro - discharge of acid liquid in the clean production of chitin and sewage discharge

    甲殼質清潔生產中酸浸廢液的處理與綜合污水達標排放
  17. Aldononitrile acetates and alkaline nitrobenzene oxidations were used to analyze the change of structuia1 polysaccharides and composition of lignin in 80 % ethanol - extracted rice straw treated with sodium hydroxide, ammonium bicarbonate, or urea

    摘要以氫氧化鈉、碳酸氫銨和尿素處理的稻草為研究對象，採用糖腈乙酰酯法和堿性硝基苯氧化法，分別測定了化學預處理前後稻草用80 %乙醇浸提殘渣中結構性多糖和木質素組分的變化。
  18. After dipped in amino trimethylene phosphonic acid ( atmp ) solution, anodic oxide films are annealed in pipe stove. the influences of concentration and temperature of atmp solution and annealing temperature on rising time, withstanding voltage and specific capacitance of anodic oxide films are studied. after hydration, anodic oxide films treated with atmp or not are analyzed by ft - ir

    2 .將化成箔在氨基三甲叉膦酸（ atmp ）溶液中浸漬，取出烘乾后再進行熱處理，研究了atmp溶液濃度、浸漬溫度和熱處理溫度對氧化膜升壓時間、比容、耐電壓的影響，找到其最佳耐水合處理工藝;採用ft - ir對水合作用后的atmp處理氧化膜和未經耐水合處理氧化膜進行了分析。
  19. The coating adhesion was detected by scribe - grid test and thermal shock test. the morphology of the coating was charactered by metallographic microscopy and sem. the research results of the experiments show that : 1

    研究結果表明: 1 .採用草酸酸洗、堿性活化、配合劑鉀鹽浸鋅液浸鋅的前處理獲得的后鍍層質量高。
  20. The effect of different dose of manganese mixed with seeds is not obvious on the soybean bleeding sap and content of nitrate - nitrogen and amino acid ; proper dose of manganese spraying on the leaf can improve the content of nitrate - nitrogen in bleeding sap obviously, to ck and the high dose of manganese treatment

    不同濃度錳浸種對大豆傷流液中硝態氮與氨基酸含量影響不是很明顯；適量錳葉面噴施可明顯促進大豆傷流液中硝態氮與氨基酸含量，使其高於對照與高濃度錳處理。
分享友人
分享到 Line

分享到臉書