金屬損耗 的英文怎麼說

中文拼音 [jīnzhǔsǔnhào]
金屬損耗 英文
lost metal
  • 金 : Ⅰ名詞1 （金屬） metals 2 （錢） money 3 （古時金屬制的打擊樂器） ancient metal percussion instrum...
  • 屬 : 屬名詞1 （類別） category 2 [生物學] （生物分類系統上所用的等級之一） genus 3 （家屬; 親屬） fami...
  • 損 : Ⅰ動詞1 （減少） decrease; lose 2 （損害） harm; damage 3 [方言] （用尖刻的話挖苦人） speak sarcas...
  • 耗 : Ⅰ動1 （減損; 消耗） consume; cost 2 [方言] （拖延） waste time; dawdle Ⅱ名詞1 （壞的音信或消息） ...
  • 金屬 : metal
  • 損耗 : 1. （損失消耗） loss; wear and tear; deterioration; waste 2. [商業] wastage; spoilage
  1. Zmd catena of self inhale magnetic force pumps adopt structure of electrical engine direct link form, by centernog prop up, the structure is tightly, teardown and maintenance is convenient, adopt high - powered magnetism stuff nd fe boron to make inside and outside magnet. isolationsheath assembled make of import nonmetallic material, avoid magnetism backset ullage of the run - of - mill pumps have drastically

    Zmd系列自吸磁力泵採用電機直聯式結構，由中間支架支撐，結構緊湊，拆卸維護方便，採用高性能磁性材料「釹鐵硼」製造內外磁體，隔離套採用進口非金屬材料，徹底消除了一般磁力泵具有的磁渦流損耗，可輸送高濃度，密度大於1 . 84 t m
  2. The exterior and the install sizes all in the light of iso international criterion to design and make, the whole structure adopt after pull pattern of electrical engine direct link my companys patent, by centernog prop up, the structure is tightly, teardown and maintenance is convenient the bound of capability is broad the alnico of passing wrestdistance uses of advanced thulium material permanent magnet nd fe boron to make inside and outside magnet ; uses of the most streampadd nonmetallic material pad f46 inside to be made - up isolationsheath assembled and its provided with high strength dynam capability

    ，整體結構採用電機直聯的后拉式我公司專利，由中間支架支撐，結構緊湊，拆卸維護方便，性能范圍寬傳遞扭矩的磁鋼選用先進的稀土材料永磁體「釹鐵硼」製造內外磁體，使用最新型非金屬材料內襯f46製成的隔離套組合具有高強度的力學性能，徹底消除了一般磁力泵具有的磁渦流損耗，提高了整機的效率。
  3. Because the cross - section of the oversized rib waveguide we fabricated by wet - etching was trapeziform, we analyzed the transmission of oversized rib waveguide by combining effective refractive - index method. the influence of some factors on the optical transmission loss, such as material structure, the height of rib waveguide, and the thickness and refractive index of waveguide layer and up - layer of polymer material, was analyzed

    因為濕法腐蝕工藝製作的反脊波導橫截面是梯形狀的，因此論文中採用了一種簡單有效的方法，即有效折射率法，對梯形反脊波導的光傳輸損耗特性進行了分析，同時考慮金屬電極產生熱場對脊波導傳播特性的影響。
  4. The polarization - dependent diffraction characteristics of the metallic echelle and the total internal reflection ( tir ) types of diffraction gratings are studied, and optimal design method based on the hybrid diffraction method is presented

    針對目前衍射光柵器件在損耗、偏振敏感性等方面的不足，本文對金屬反射型以及內全反射型凹面光柵的偏振相關的衍射特性進行了矢量分析，並基於混合衍射方法提出了更為準確有效的優化設計方法。
  5. In this modulator, coplanar strips ( cps ) are used as electrodes for they support balance mode propagation of microwave, and this is a desired merit for common optical modulator. due to the miniaturized dimensions, the metallization thickness is in the order of skin depth and the conductor losses are not negligible

    雖然由於金屬的趨膚效應，電場將集中在金屬表面，但在40g以上的頻率條件下，金屬的厚度和趨膚深度在一個量級，而且此時調制器帶寬受到限制的最大根源來源於金屬電極的微波損耗。
  6. Calculation of the current rating of electric cables. part 1 : current rating equations 100 % load factor and calculation of losses. section 2 : sheath eddy current loss factors for two circuits in flat formation

    電纜載流量計算.第1部分：載流量公式100 %負荷因數和損耗計算.第2節：雙迴路平面排列電纜金屬套渦流損耗因數
  7. How to research stray losses and temperature rise on metal parts caused by leakage flux is difficult task for transformer design

    如何研究由於漏磁引起的附加損耗以及在金屬構件中的溫升是變壓器設計的難題。
  8. Because the contact resistance between the metal contacts and the superconducting films has large impact on the performance of superconducting filters, we experimental techniques. after annealing the optimum temperature and, we got the minimum contact resisitivity. we also further studied the interaction between ag and ybco films after annealing at a certain temperature and attempted to give an explanation and discussion

    金屬接觸電極與超導薄膜之間的接觸電阻對超導濾波器的插入損耗有很大影響，因此，本文通過多種實驗方法，系統的研究了ag與ybco超導薄膜之間的接觸電阻問題，得到了最佳退火溫度，並對退火時ag與ybco超導薄膜之間相互作用的機理進行了研究和探討。
  9. There is integrated theoretic calculation, simple field, eliminate the reference of tan to rs, but the result comes from two samples without the conclusion of the conductor loss of cylindrical cavity

    但是這種方法的測試結果是兩片超導膜的平均值，而且未考慮到金屬腔的導體損耗和其它一些因素引入的誤差。
  10. Next is that wear consumption capacity is more low and more good. 3

    其次是在經濟合理的基礎上保證金屬磨損消耗量越低越好。
  11. Research and summary for stray losses and overheating control on metal parts caused by leakage flux of transformer has been given by author in this article through a lot of tests on site, meanwhile, the analysis has been given by electrical - magnetic theory also

    本文運用變壓器電磁學理論，通過進行大量探索性試驗，研究並總結出如何控制由於變壓器漏磁引起的附加損耗以及金屬構件中的溫升。
  12. There are a lot of advantages when inner trachea applied in air pre - heater, such as the improvement of the temperature of pipe, the low consumption of metal, except for the increment of flow resistance. according to many related papers, it is more proper inner trachea with the structure of short distant between two whorls and shallow depth of whorl. it can enhance heat transfer with smaller flow loss

    內螺紋管是一種異形管，和光管相比，管內側的換熱系數大大增強了，應用於空氣預熱器可以起到提高總傳熱系數、節約受熱面金屬消耗量的目的；同時提高了管壁溫度，能夠減輕低溫腐蝕的程度和速度；不足之處是帶來了更大的阻力損失。
  13. The loss of metal has been reduced to less than 20 %

    金屬損耗減少到百分之二十以下。
  14. The heating speed is quick, the loss is less, controlling the chemical composition is easy, the quality of the product or is high, the chimney is less and the operation is convenient

    本公司生產的中頻感應熔爐，具有加熱速度快，金屬損耗小，化學成分容易控制，產品質量高，煙塵小，便於操作等優點。
  15. Cls21 - i metallized polypropylene capacitors have low dissipation factor, stable capacitance, puny thermoguotiety. they can steadily work on logic control circuits & integral circuits and phase etc of instruments

    型金屬化聚碳酸酯電容器損耗小，電容量穩定，溫度系數小，能穩定地工作在精密儀器、儀表的邏輯控制電路，積分電路等場合。
  16. Cls21 - ii metallized polypropylene capacitors have low dissipation factor, stable capacitance, puny thermoguotiety. they can steadily work on logic control circuits & integral circuits and phase etc of instruments

    Ii型金屬化聚碳酸酯電容器損耗小，電容量穩定，溫度系數小，能穩定地工作在精密儀器、儀表的邏輯控制電路，積分電路等場合。
  17. To mitigate the impact of the cost increase, the group has taken steps to enhance production efficiency and to lower wastage rates, as well as to stock up such key materials as titanium which are experiencing acute price surges

    原材料價格上漲亦對集團的毛利構成壓力，集團已積極提升生產效益，減少損耗，同時亦為價格升幅較急的原材料如鈦金屬等增加儲備，以穩定成本。
  18. The first part of this thesis includes the following information : ( 1 ) the significance of materials and the progress in every fields of material science in recent years ; ( 2 ) the history of magnetic material and the classification of magnetic material ; ( 3 ) the emergency and the classification of organic magnetic materials as well as the significant progress in the field of ferrocene polymeric magnet recently ; ( 4 ) introducing die development and the status quo of dielectric polymer and discussing the four parameters which are used to characterize the dielectric beheaviour of material, these parameters mclude dielectric constants dielectric loss ^ electric conductivity and breakdown strength

    本文在開頭部分簡單講述了以下內容了： （ 1 ）材料的重要性以及近些年來材料業各個領域的發展； （ 2 ）磁性材料的發展史以及磁性材料的分類； （ 3 ）有機磁性材料的出現、有機磁性材料的分類和近些年來有機金屬磁性材料尤其是二茂鐵高分子磁體領域所取得的重要進展； （ 4 ）高分子介電材料的發展與現狀，對表徵材料介電性能的四個重要參數即介電常數、介電損耗、電導率和擊穿強度做了比較詳盡的論述。
分享友人
分享到 Line

分享到臉書