金屬粉末混合 的英文怎麼說

中文拼音 [jīnzhǔfěnmòhúngě]
金屬粉末混合 英文
mixing of metal powders
  • 金 : Ⅰ名詞1 （金屬） metals 2 （錢） money 3 （古時金屬制的打擊樂器） ancient metal percussion instrum...
  • 屬 : 屬名詞1 （類別） category 2 [生物學] （生物分類系統上所用的等級之一） genus 3 （家屬; 親屬） fami...
  • 粉 : Ⅰ名詞1 （粉末） powder 2 （用澱粉製成的粉條或粉絲） noodles or vermicelli made from bean potato o...
  • 末 : Ⅰ名詞1 （東西的梢;盡頭） tip; terminal; end 2 （非根本、非重要的事物） nonessentials; minor detai...
  • 混 : 混形容詞1. （渾濁） muddy; turbid2. （糊塗; 不明事理） foolish; stupid
  • 合 : 合量詞（容量單位） ge, a unit of dry measure for grain （=1 decilitre）
  • 金屬 : metal
  • 粉末 : powder; flour; stive; smalls
  • 混合 : （攙雜在一起） mix; blend; mingle; admix; mixture; mix up; interfusion; commixture; blending; cre...
  1. The authour investigate the dosing conditions and effect of the pac to the huanghe water - source, which includes the following four parts : the selection of the pac ; the confirmation of dosing scheme and effect of the pac ; the research of application of potassium permanganate in combination with pac ; the research of the pac ' s modification and the modified effectiveness. the experiment is mainly carried out on the pilot system in the jieyuan water plan of tianjin. the results of the reseach include the following : l ) the pac from zunhua plant is selected as the better carbon for the source water of tianjin through the experiment ; 2 ) through the pilot experiment we conclude that the pac ' s best adding point is the mixing tank and the better dose is 10mg / l, on which the codmn of filtered water can be decreased to 40 % and the effluent have no problem of odour and color ; 3the adsorbing experiment show that pac mainly adsorb the organic matters which molecular wt., distribution between 500 and 3000, and can adsorb organic matters whose molecular wt., distribution are bigger than 6000 if the dose of it is adequent ; 4 ) pac together with potassium permanganate can remove the organic matter more effectively than each of them alone, and reduce the rising trend of turbidity of the flotation ' s effluent due to adding pac ; 5 ) the thesis made a research on the surface properties and the adsorbing capability of the modified carbon by oxidizer : the modified carbon with 20 % h2o2 can remove more organic pollutants than the untreated one by 12 % when we add a higher dose of coagulant ; 6 ) the modification of reduction and loading metal ions are also sttldied, and drow the following conclusions : the modified carbon with 5 % ammonia can enhance the organic matter ' s removal effectiveness by 10 % to the tianjin source water than the untreated one, and the modified one with loading metal ion remove the organic matters from the tianjin source water better ( 8 % ) than the untreated one due to the strong affinity betwween the humic acid and copper ion

    本文的實驗主要是在天津芥園水廠的中試系統上完成的，論文的成果和結論主要包括： 1 ）通過靜態實驗選定河北遵化活性炭廠生產的煤質炭為適合天津原水的炭種； 2 ）中試實驗確定粉末活性炭的較佳投加點為混合池投加，較佳投加量為10mg l ，此時可使濾后水的cod _ （ mn ）降低40 ，且可較好地控制濾后水的嗅味和色度； 3 ）初步確定粉末活性炭對原水中有機物的吸附主要集中在分子量在500 - 3000范圍內，投量增大時可吸附部分分子量大於6000的有機物4 ）中試實驗表明：粉末活性炭與高錳酸鉀聯用可取得較兩者單獨應用時對有機物更好的去除效果，且對因投加粉末活性炭而造成的氣浮出水濁度升高有一定的改善作用； 5 ）研究並初步確定氧化改性對粉末活性炭表面性質和有機物的去除效果的影響：粉末活性炭的氧化改性會使其表面的酸性官能團大量增強，表面極性增加；經20的過氧化氫改性的活性炭在增大混凝劑投加量（ fecl _ 3投量為15mg l ）時對有機物的總體去除效果較原活性炭提高12 ， 1次氯酸鈉改性活性炭對有機物的去除效果較原活性炭提高6 ； 6 ）研究並初步確定還原改性、負載金屬離子對原水中有機物的去除效果的影響：經5氨水改性的活性炭可提高天津源水中有機物的去除率達到10 ；負載銅離子后的活性炭可提高對腐殖酸類物質的去除能力，一般可提高8左右。
  2. In this paper, aluminum foams with 40 % - 80 % porosity. 2 - 5mm pore diameter, and 0. 4 - 0. 6 restive density, were produced by the p / m method, i. e. by mixing 6061 powders and blowing agents and pressing them to densification, then foaming

    本論文闡述了粉體發泡法制備泡沫鋁的工藝，即把少量的發泡劑（ tih _ 2粉末）和6061鋁合金粉末混合均勻，然後壓製成試樣，再進一步熱壓，最後在金屬基體熔點附近發泡。
  3. Lubricated metal - powder mixes - determination of lubricant content - modified soxhlet extraction method iso 13944 : 1996 ; german version en iso 13944 : 2006

    含潤滑劑的金屬粉末混合物.潤滑劑含量測定.改進的索格
  4. In this thesis, the sls molding properties of some metal - base composite powders composed of metal powder mixed by several regularly used polymers " powder were studied, on the basis of which, a new sls composite material made by 316 stainless steel powder mixed by epoxy powder was developed and produced. the molding technics and adherent mechanism of the material in sls process was analyzed and studied, and the high temperature sintering technics of the green parts of the material was discussed as well

    本文主要針對快速成型的sls方法，研究比較了幾種常用的聚合物粉末添加到金屬粉末中所構成的金屬基復合粉末的成型性，並且研製開發了316不銹鋼粉末與環氧樹脂粉末共混復合粉末作為成型材料，對其sls過程的成型工藝、聚合物粘接機理以及型坯的高溫燒結工藝進行了研究論述，並進一步對型坯的高溫燒結過程、燒結中的收縮變形和燒結后的強度作了分析研究。
分享友人
分享到 Line

分享到臉書