鋪膜機 的英文怎麼說
中文拼音 [pūmójī]
鋪膜機
英文
film dispenser-
Aiming at the problem that the seeds picked up by the suction plate of the seed metering device cannot accurately fall into the seed pit opener as well as into the seed pit, an innovated seed metering device on which the seed dropping angle can be adjusted within a certain range and a new testing stand have been developed in accordance with the mathematical calculation model that had " in accordance with the mathematical calculation model that had been established previously. then an experimental study is conducted and the seed dropping law has been found out through the study
本論文根據2bqm - 2型氣吸式精量鋪膜播種機的結構和工作原理,針對該機在實際播種中,吸種盤吸出的種子不能滿足準確地落入在膜上滾動開穴的鴨嘴內,並及時地排入到鴨嘴所成的穴孔內的設計要求,進行了一定的試驗研究,利用已建立的計算數學模型,設計新的試驗臺,改進排種器,使排種器的落種角度可以在一定的范圍內調整。The testing result shows that there is a difference actual seed dropping angle and the one acquired by calculation, therefore, a formula for the calculation of seed dropping angle even closely suited to production practice has been driven out and a theoretical basis for the application of 2bqm - 2 model plastic film mulch pneumatic precision planter in practical production is advanced in this paper
通過試驗,找出種子的落種位置規律。通過試驗結果分析,找出種子的實際的落種角度和計算的落種角度之間的差別,推導出更適合實際生產中所需要的落種角度,為2bqm - 2型氣吸式精量鋪膜播種機在實際生產中的應用提供了一定的理論基礎。In order to overcome the disadvantage of 2bps - 2 plastic film mulch seeder with watering apparatus that the operation speed is limited and the moisture evaporation loss is great, according to the theoretic analysis of water movement in soil, this paper offers another watering project - hidden watering under film, designs three different types of watering devices, meanwhile conducts test research with different watering devices in different position the change of the soil moisture content
本課題針對2bps - 2型坐水鋪膜播種機坐水后,土壤水分蒸發損失大和機組作業速度低的突出問題,通過對水在土壤中運動的理論分析,提出了在行間膜下的暗道式施水方案,圍繞此方案設計了三種坐水部件,並就不同坐水部件在不同施水位置施水后,種子帶土壤含水量的變化進行了試驗研究。It includes adding means, compaction means, cutting means, film system, heating means and the assistant setups such as guiding the direction, orientation etc. the paper has discussed and compared three projects from the setup ' s component, designed the setup by the best project
纖維鋪放頭機構主要包括加料裝置、施壓裝置、剪切裝置、保護膜系統、加熱裝置以及諸如導向、定位等輔助機構等。本文從機構的構成討論了三個方案並加以比較,根據最優方案進行了設計。分享友人