錨固滑移 的英文怎麼說
中文拼音 [máogùgǔyí]
錨固滑移
英文
anchor slip-
The content of the paper is nonlinear analysis of complete response process for t, l - shaped and " + " shaped section r. c. columns under axial compression and biaxial bending. on the basis of related papers, the full path of stress - strain relation of concrete and the sliding of longitudinal reinforcement anchoring are all considered, simultaneously, the restriction effect for concrete by thickening of stirrups is also included
本論文主要內容是對鋼筋混凝土異形截面雙向壓彎柱（包括l形、 t形、十字形柱）進行非線形全過程分析，在有關文獻基礎上考慮了受拉縱筋和周圍混凝土的錨固滑移和混凝土應力?應變關系曲線的下降段，同時考慮到在箍筋加密區箍筋對混凝土的約束影響。6. the sectional cross - sectional discrete yield - sruface model is used to spandrel deep beams, the effect of the shear deformation to shear force on ( he m ~ terial nonlinearity is considered, ( he bond slip in anchorage zones is regarded as the houndaty nonlinearity of a member. except the geometric nonhineaicty. consideration of double nonlinearities about materials an
6 、將分段截面離散的屈服面模型法應用於裙梁，考慮剪力剪切變形對材料非線性的影響，將錨固區鋼筋的粘結滑移看成構件的邊界非線性，不考慮幾何非線件，建立了裙梁考慮村料、邊界雙重非線性的空間滯回曲線分析模型。S. consideration of interaction on the nonlinearity about the material, the geometry, and the boundary of the columns subject to axial force. biaxial hending, and torsion, an analytical model of hysteretic curve of columns is presented, based on the sectional cross - sectional discrete yieldsurface inodel, the bond slip in anchorage zones regarded as the boundary nonlinearity of a memher. and the iterative procedure of displacement of inner nodes on the basis of the hamonization of displacement
5 、根據構件分段截面離散的屈服面模型法，把錨固區粘結滑移看成構件的邊界非線，以及基於位移協調的內結點位移迭代法，建立了能考慮構件壓（拉） 、雙彎、扭的材料、邊界、幾何非線性相互影響的柱空間滯回曲線分析模型。3. a space bond slip relation of reinforcements in either end of a member is proposed, based on one - dimensional bond slip model of reinforcements proposed by teng zhiniirmg from tsinghua university, the first - time loaded ascending stage ? curve of which model is modified as the line which parameters are not changed so as to simply the computation. the bond, slip is regarded as the boundary nonlinearity of a member
3 、採用清華大學滕智明建議的一維鋼筋粘結滑移恢復力模型，但從簡化計算的角度出發，將首次加載的上升段曲線改為直線，並假定構件端部的諸多縱向鋼筋的滑移服從平截面假定，考慮由節點錨固區粘結滑移引起的構件端截面軸向和兩轉角附加變形。Consideration of the additional axial, two angular deformations generated by the bond slipping in anchorage zones of joints, the assumption is made, that the plane section of either end of a member before bond slipping of reinforcements remains afler bond slipping of reinforcements. additional deformations * contribution to stif ? nesses of plastic sub - elements is formed from the boundary nonlinearity of plastic stabelements. the space bond slip relation can truly compute bond slip in anchorage zones, additional def ? rmatinns, and their contribution to the space nonlinearity of a niember, has used iii space nonlinear analysis of columns and spandrel beams in this dissertation
附加變形對塑性子區域的剛度貢獻，看作是塑性子區域的邊界非線性，建立了構件端部子區域基於構件邊界非線性的鋼筋與砼之間的空間粘結滑移關系，能較真實地求得錨固區的粘結滑移、附加變形以及他們對構件空間非線性性能的貢獻，並運用於柱、裙梁的空間非線性分析之中。However, along with the increasing of construction quantity of the infrastructure of irrigation works, traffic, communication etc., newer and higher requirement of geotechnical anchoring are made in slope, major dam, bridge, tunnel, deep foundation ditch engineering and the construction engineering such as anti - capsize, anti - float, anti - slippage engineering of the buildings. for example, self - intension of rock and soil is required to exploit better ; carrying capacity of anchor increase according to anchoring length ; anchor should be sufficiently lasting and should not influence the exploitation of adjoining stratum
但另一方面，隨著我國水利、交通、通訊等基礎設施建設力度的加大，邊坡、大壩、橋梁、隧洞、深基坑以及建築結構物的抗傾倒、抗浮力、抗滑移等建設工程將對巖土錨固提出一些新的和更高的要求：如要求進一步調用巖土體的自身強度，錨桿應具有足夠的耐久性，錨桿的使用應不影響周邊地層的開發等。According to the test result, the mechanism of inorganically post - installed bars with cone - shaped heads was analyzed. and then the anchor intensity formula was formulated. the inorganically post - installed bars with cone - shaped head was carried on the finite element analysis on the spatial axial symmetry model
根據試驗結果，對帶錐頭無機植筋的受力機理進行了理論分析，推導出帶錐頭無機植筋的錨固強度公式，並利用空間軸對稱模型對帶錐頭無機植筋進行了有限元分析，提出了利用桿單元模擬鋼筋與混凝土之間的粘結滑移關系的方法。The numerical simulation of the push - out test specimens were conducted with the ansys program, the simulation results were in good agreement with the experimental results, based on which a series of src beam specimens experimented before were also numerically simulated with the ansys program and compared with the experimental results, from these a set of methods to simulate the src structures with the ansys program, which including the establishment of the fem model, solution of the fem model, solution results analysis and so on was finally established
）程序對推出試驗進行了數值模擬，並與試驗結果進行了對比分析，然後對型鋼混凝土梁進行了ansys ~ （ ? ）程序有限元分析，最終形成了一套型鋼混凝土構件ansys ~ （ ? ）程序有限元分析的建模、計算和分析方法，並根據本文的粘結滑移基本性能研究提出了型鋼混凝土粘結錨固可靠度分析方法和錨固設計建議。In this paper, on the foundation of synthesizing engineering practice and study result of planted bar technique by chemistry glue on the domestic and international, embedded experiment study and theories analysis are done about bonded anchor behavior of chemistry planted bar anchorage behavior in this paper, the experimental results of 32 pulling resistance test ( meiya z3530 ) are given, considering some factors to affect bonded anchor behavior of chemistry planted bar such as the strength of concrete anchorage lengths diameter of steel bar and holes thickness of the protecting layer confecting circumstance of the hoop bar and quantity of construction especially which is very easy to be neglected and so on, and bonded anchor mechanism failure mode load carrying capacity and slide behavior are analyzed in - depth
本文在綜合國內外化學膠植筋技術的工程實踐和研究成果的基礎上，對化學植筋的粘結錨固性能作了較深入的試驗研究和理論分析。文中通過32個化學膠（美亞z3530 ）植筋試件的拉拔試驗研究，考慮混凝土強度、錨固長度、鋼筋植筋、鉆孔孔徑、保護層厚度、箍筋配製情況及施工質量等因素對植筋粘結性能的影響，特別是植筋的施工質量對粘結性能的影響是比較容易被忽視的因素，對化學植筋的粘結錨固機理、破壞形態、承載力及滑移性能作了比較深入的剖析。This paper analyzed the mechanism of bond between the steel shape and concrete in the src ( steel reinforced concrete ) structures. by a series of src push - out tests, both the bond strength and the relations between the bond stresses and slip, which was usually called bond - slip constitutive relations, were analyzed and studied to solve the problem on bond - anchoring design and the problem on numerical simulation of the bond - slip in fem ( finite element method ) analysis of src structures
本文分析探討了型鋼混凝土中型鋼與混凝土之間的粘結滑移機理，並通過型鋼混凝土推出試驗（ push - outtest ）研究了型鋼混凝土粘結強度、粘結應力-滑移相互關系（粘結滑移本構關系） ，以解決型鋼混凝土結構中的粘結錨固問題和有限元分析中的粘結滑移模擬問題。Works are accomplished as follows in this paper : firstly, according to the real condition of the fourth pier, through analysis of several generally - used anti - slipping schemes, new method has been put forward to substitute anchored column pile with the foundation of drilled shafts so as to prevent cofferdam from slipping
為此本文主要做了以下工作：首先根據4 #墩基礎的具體條件，通過對現有常用的幾種抗滑方案的綜合比較分析，提出了以工程本身的鉆孔樁基礎代替錨固柱樁防止鋼圍堰滑移的方案。In order to determine the relations between the four main bond - anchoring factors - concrete strength, concrete cover thickness, steel shape embedment length and the ratio of the transverse hoops - and the bond strength, and establish the bond - slip constitutive relations, 16 standard push - out test specimens were designed, and 4 comparison specimens were additionally designed to find the difference of the bond performance between the web, inside and outside of flanges the steel shape
設計了16個型鋼混凝土標準推出試件，以考察混凝土強度、型鋼的混凝土保護層厚度、型鋼埋置長度及橫向配箍率四個主要錨固條件與粘結強度的相互關系和型鋼混凝土粘結滑移本構關系；設計了4個對比試件，以考察型鋼翼緣內側、外側和腹板與混凝土粘結性能的區別。With the help of this program, this paper does research on the moved backwards of the slide surface, lengthening the anchor section, the soil nail ' s total force, gets conclusion about relations between the soil nail ' s length and the slope ' s grade, height, soil ' s mechanical parameter ; relations between soil nail ' s total force and coulomb soil pressure. with the help of the large multiuse finite element program ansys, this paper analyzes the soil nailing in one - step ' s slopes, in two - steps " slopes, puts the emphasis on the axis force ' s distributing along the soil nail at each rows, the effect of both the excavating mode and the original slope figure to the axis force of the soil nail, the one another effect between the upper - step slope and the nether - step slope in the soil nail ' s axis force, gets conclusion about the design of soil nail at the first low, different slope body is the same with different excavating mode, the original slope figure has more effect to some than others because of the slope body, the reasonably design of the step width in two - steps slopes, the two - steps excavating and retaining has more virtue than the one - step ' s. through soil pressure analysis this paper does research on the differences and the links between the coulomb soil pressure theory and the rankin ' s, the vertical pressure at the slope surface when the slope surface is inclined and the retaining wall is rough, the soil pressure ' s distributing behind the panel, gets conclusion about the effect of both the slope body inner stability and the slope surface local stability to the soil pressure
通過分析比較，論證了對數螺旋線型比圓弧形作為邊坡的假設滑裂面具有較多的工程優點，並為此編制了一個採用極限平衡法分析土釘支護的fortran語言程序，以此作工具對滑裂面的后移、土釘錨固段的超長、土釘總力的大小等方面作了研究，得出了有關土釘的長度與邊坡的坡角、坡高、土體力學參數的關系、土釘總力與庫侖土壓力間的關系等結論；採用大型通用有限元數值分析程序ansys分別對採用土釘支護的一階邊坡、二階邊坡進行分析，重點是研究各排土釘的軸力分佈規律、開挖方式及原始邊坡形態對土釘的軸力的影響、上下階邊坡在土釘軸力方面的相互作用，得出了有關第一排土釘的設計問題、不同類型的土體應適用於特定的開挖方式、原始開挖出的邊坡形態對一些類型坡體的邊坡土釘支護有較大的影響而對另外一些影響不大、二階邊坡臺階寬度的合理確定、二階開挖及支護比一階時具有較多的工程優點等結論；通過土壓力分析對朗肯、庫侖兩種經典土壓力理論的區別與聯系、坡面傾斜及墻背有摩擦時的坡面豎向應力分佈、面板背土壓力的分佈形態作了研究，得出了邊坡支擋土壓力受坡體內部穩定與坡面局部穩定兩個方面的影響、土釘支護面板背土體中卸荷拱的存在對面板受力有利等結論。分享友人