中文拼音 [zhù]
Ⅰ動詞(鑄造) cast; coin; make Ⅱ名詞1. (古國名) zhu, a state in the zhou dynasty2. (姓氏) a surname
  1. When the whole melting was complete it was held in abeyance for a few minutes to facilitate the separation of foreign substances.

  2. The operation principle and device to produce acetin and hydroxyethyl acetate for foundry firming agent were analyzed in the paper, and the choice of esterification catalyst and dehydrated agent in the esterifying process also were analyzed theoretically, and finally, the better producing operation device, catalyst and dehydrated agent were obtained

  3. The fabrication of casting sample of normal male canine prostatic duct and acinus system

  4. Antimony adds to the rigidity of the casting.

  5. The flight paths of the aeroplanes crossed, with fatal results.

  6. There are many large - size air hammers, blast furnaces and costing equipment including all sorts of heat treatment equipment, costing equipment including all sorts of heat treatment equipments

  7. In our company we have forging, costing and heat treatment workshops with advanced producing equipments. all the tasks which refused by the other companies will be done well here. there are many large - size air hammers, blast furnaces and costing equipment including all sorts of heats treatment equipment, costing equipment including all sorts of heat treatment equipments

  8. The welding performance of homemade wear - resistant cast steel has been studied base on the weldability tests, the repair welding procedures of wean - resistant cast steel ( abrasion - plates ) have been made up, the results show that satisfying repair welding quality can be attained with such welding conditions as the low hydrogenous alkalescent welding rod, preheating and slow cooling, strictly maintaining the interbedded temperature of 250 ~ 300 and controlling welding technique

    通過對其焊接性能的試驗研究,制定了該類鋼件(磨耗板)的補焊工藝:低氫型堿性焊條,預熱與緩冷相結合的工藝措施,嚴格控制層間溫度( 250 ~ 300 )及焊接工藝規范,可獲得滿意的修復質量。
  9. Casting technique of permanent alnico magnets

  10. Alumina carbon refractory products for continuous casting

  11. Casting aluminium bronze

  12. The metals most frequently cast are iron, steal, aluminum and so on.

  13. Specification for cast and wrought galvanic zinc anodes

  14. These companies did not have the know-how to cast grids of lower antimony content.

  15. Installation of ductile - iron water mains and their appurtenances

  16. In fact in the die casting process, when the liquid metal have not solidified completely, in order to break arborescent structures which have already solidified and then proceed fine - crystal intensification, we apply a deforming force, so the mechanical properties of parts produced by liquid combination process of die casting and forging will be improved significantly

  17. Archaeologists have discovered ancient bronze swords and other weapons, made by casting in this manner.

  18. Arteriovenous cast of the thorax and abdomen

  19. Note 1 : elements heavier than iron are produced by the capture of neutrons by atomic nuclei

    注1 :重的元素比鐵製作的捕獲中子的原子核
  20. 1. no state shall enter into any treaty, alliance, or confederation ; grant letters of marque and reprisal ; coin money ; emit bills of credit ; make any thing but gold and silver coin a tender in payment of debts ; pass any bill of attainder, ex post facto law, or law impairing the obligation of contracts, or grant any title of nobility. 2