間質液及基質 的英文怎麼說

中文拼音 [jiānzhíyèjíjīzhí]
間質液及基質 英文
interstitial fluids and ground substance
  • 間 : 間Ⅰ名詞1 （中間） between; among 2 （一定的空間或時間里） with a definite time or space 3 （一間...
  • 質 : Ⅰ名詞1 （性質; 本質） nature; character; essence 2 （質量） quality 3 （物質） matter; substance;...
  • 液 : 名詞（液體） liquid; fluid; juice
  • 及 : Ⅰ動詞1 （達到） reach; come up to 2 （夠得上; 比得上） can compare with; be comparable; be up to ...
  • 間質 : mesenchyme; mesenchyma
  1. By comparing the dry plate pressures drop and distributions of velocities simulated on single valve with those of double valves, it was found that there was intense turbulence in the flow fields around fixed - valve, there were eddy areas between valve side orifices and tray wall, there were eddies above the valves too, these led to the complex behaviors of gas perforating valve, these had a great effect on the gas - liquid mass transfer process. at the same time, in order to prevent the disadvantageous effect of gas between one valve with another on the gas - liquid mass transfer, it was very effective to change the fields of gas perforating valve by folding the edges of valve

    通過對數值模擬得出的單閥和雙閥塔板的干板壓降及流場速度分佈分析對比后發現，固定閥周圍流場存在較強的湍動，閥側孔與塔板壁面區域以及閥體的上方空間存在明顯的渦流區，使氣體穿閥后的行為變得復雜，並對氣液傳質過程產生重大影響；模擬結果表明，為防止和削弱固定閥間的對沖造成的「死區」對傳質帶來的不利影響，通過折邊來改變氣體的氣路是非常有效的，模擬值與實驗值基本得到吻合。
  2. Based on the close analysis of the influence factors of the vertical bearing capacity, circular aperture extension theory is employed to establish the computing formulas for the pile vertical stress and the foundation vertical bearing capacity, respectively. moreover, with analyzing the features of the calculation parameters such as materials of gunite mortar, jet pressure, diameter of the jet pipe, pile length, pile layout, a design theory for chemical churning pile composite foundation is proposed. then, the variation of the pipe deformation with loads, the deformation coordination of pile and soil are studied

    在此基礎上深入探討了旋噴樁的樁土受力特性及其復合地基的加固機理，從影響旋噴樁復合地基豎向承載力的因素入手，基於圓孔擴張理論給出了樁體豎向應力及旋噴樁復合地基的豎向承載力計算公式;通過對噴射漿液、噴射壓力選取、噴射直徑估算、樁長及樁位設計等各種計算參數的深入分析和研究，提出了一套相應的旋噴樁復合地基設計計算方法;通過計算分析，深入探討了旋噴樁復合地基變形隨荷載變化規律、樁和樁間土變形協調關系、樁土應力比及復合地基壓縮模量的確定，並提出相應的設計方法和修正參數;此外，結合工程應用，對旋噴樁復合地基的施工技術及其現場質量檢測方法進行了較全面的探討。
  3. By applying the theory and method of geological anomaly, it is focused on the analysis of the characters of major geological anomalies and their effect of mineralization in daye - jiurui region. the analysis result shows that the basement fault anomalies control a few major large hidden batholiths and their associated orefields ; that the anomalies of cover structure confine most cu - au deposits and fe - cu deposits within their scope ; that the geochemical anomalies and lithofacies - paleogeographical anomalies are major geological factors leading to trataboundness of some cu - au deposits ; that the anomalies of rock operties provide the favorable chemical and physical conditions for the ore - forming process, including the seepage, circulation, convergence and deposit of ore - bearing hydrothermal solution ; that the anomalous ctive stage of mesozoic magmatite is almost consistent with the major mineralization epoch of the fe, cu deposits, and the structure of multi - levels, and the zoning in magmatic system determine the spatial distribution of the mineralization system. then, based on the above analysis, a comprehensive variate, geological combination entropy, is brought forward for reflecting the complex degree of the combination of geological ore - controlling factors. after circumscribing the anomalies of geological combination entropy, the relations between the anomalies and ore deposits are determined

    從地質異常的角度，重點分析了大冶九瑞地區主要地質異常的特徵及其對成礦的影響.由分析可知：基底斷裂異常控制了本區若干重要規模較大的隱伏巖基及伴生礦田，而蓋層構造異常控制銅金礦床和鐵銅礦床的空間位置；地層的地球化學異常和巖相古地理異常是造成一些銅金礦床層控性的主要地質因素；蓋層的巖性異常為含礦熱液的滲流、循環、聚集和礦質沉澱等一系列成礦作用提供了有利的物理和化學條件；中生代巖漿巖的異常活動期也是本區主要的鐵銅成礦期，巖漿巖系統的多層分枝和分帶性結構控制了本區成礦系統的三維空間分佈.在上述分析的基礎上，構置了地質組合熵作為反映控礦地質因素組合系統結構復雜程度的綜合變量，並圈定出組合熵異常，由此確定了綜合地質異常與礦床的關系
  4. In order to study the direct relation between oil - base drilling fluid performance and cement job quality, a new developed evaluation method ( artificial core method ) was adopted ; the effects of the oil - base drilling fluid system and its main components on the shear cementing strengths of the first and second interfaces in cementing operation were investigated ; and those of the different mix slurry ratios on the gel strength, initial set time, final set time of slurry and the compressive strength of bond cement were examined too

    摘要為了研究油基鉆井液性能和固井質量之間的直接關系，採用新建立的評價方法人工巖心法，考察了油基鉆井液體系及其主要組分對固井作業中第一、第二界面剪切膠結強度的影響規律，以及不同混漿比例下對水泥漿膠凝強度、初凝時間、終凝時間和水泥石抗壓強度的影響規律。
  5. The common method used by domestic and foreign scientists is removing the cobalt from the surface of the substrate by etching substrate using thin acid solution at room temperature. but the internal co will still overflow during mpcvd

    為降低成核及成膜過程中鈷的副作用，國內外通常採用的方法是將硬質合金基體在室溫下用稀酸溶液浸泡一定時間，從而除去基體表面的鈷。
  6. By using ec membrane material as column packing, double - distilled water as mobile phase, the retention times ( tr " ) are measured with suitable inorganic and organic compound as solutes. 3. complying with the retention times, the partition coefficient of the solute ( ka " ) and the ratio of the surface excess concentration of solute ( ) with the concentration of the parent fraction ( cab ) are calculated

    利用物理改性的方法研製了乙基纖維素（ ethylcellulose ，簡稱ec ）膜材料，並將其作為高效液相色譜柱的固體填料，以高效液相色譜模擬反滲透實驗平衡條件，以水為流動相，選擇合適的無機物和有機物作為溶質，測定乙基纖維素對它們的相對保留時間及平衡分配常數k _ a 。
  7. We specialize in the production of fine chemical compounds. these includes many pharmaceutical intermediate compounds, liquid crystal compounds, electrochemical, photosensitive materials, photo - chromic material and other related specialty light sensitive compounds

    我司是一家能生產幾十種醫藥中間體及液晶化學品，電子化學品，感光及光質變色材料，光司發劑等特殊精細化學品的生產基地。
  8. The test is based on the detection of the genetic material, namely rna, of the sars - coronavirus in blood. it accurately determines the amount of virus carried by the patient, while requiring only a small quantity of blood and a short period of analysis time

    新方法測試sars冠狀病毒的基因物質rna ，只需少量血液樣本及用極短化驗時間，已能極準確地掌握病者的病毒分量（ virus load ） 。
  9. The paper consider bone tissue as an biphasic porous medium, which is composed of solid bone matrix and liquids as extracellular fluid. on the other hand, bone tissue can produce electric potential when it is subjected to outside force. so dynamic governing equations can be established through combining the biphasic porous medium model and the streaming potential model, which describe the coupling between the distortion and fluid flow as well as the streaming potential

    論文首先考察了骨組織的生理形態結構及其組成，據此將骨組織模型化為一種由固體骨基質和由細胞外液和血液等組成的液體所構成的兩相飽和多孔介質，並進一步假設固體骨質為各向同性彈性介質，而孔間流體為理想流體；另一方面，骨組織在受到應力作用變形后能夠產生電位。
  10. The analytic results of the effects on the micromorphological structure of the film by the electrochemical condition ' s showed that the carbon is apt to improve the boundary combination between the scfs and the surface of the cathode and the seperation of the films, and that the micromorphological structure of the mpgcfs is greatly affected by the dring and the power voltage, which remarkably affluence ion move in swelling cathode film, and that higher temperature and concentration of cu2 + in the medium solution are also advanagable to the deposition of cu in scfs. the plot of deformation behavior of mpgcfs showed that the maximum strench ratio decreases and the brittleness increases due to the existence of the metal phase, and that the strengh trend of the composite films is fistly up and down followed with the content of metal phase because of the change of the role of the metal phase from acting as the physical cross - linking to weakening the films due to destroying the whole structure of the polymer

    另外它作為基體的另一個突出的優點是制備的溶脹復合膜（ scf ）中的溶劑與電解液中的溶劑相同都是水，克服了以前膜內外不同溶劑之間擴散的問題，結果使得電流最終趨於一種穩態，因此可以更好實現用電化學條件來控制mpgcf的形態結構；硬質石墨材料的多孔的結構和石墨本身的結構性能特點使得碳作為陰極材料時有利於溶漲復合膜（ scf ）與電極表面的結合以及膜的剝離，因此是作為陰極的理想材料；電化學條件中的乾燥程度和電壓能夠明顯的影響離子在膜內的遷移，從而對mpgcf的形態結構造成較大的影響；而提高反應溫度和增大電解液中銅離子的濃度也有利於銅在膜中的沉積生長。
  11. The oxidizing parameters of the anodization in the following experiments were preferred on the basis of measuring the dependence of pl properties ( peak position, and max intensity, etc. ) on anodization conditions, such as the anodizing current density, the time of the anodization, the concentration of the solution ( mainly of hf ), and on the doping level of the substrate

    刻蝕時間、刻蝕液配比及襯底電阻率對pl發光強度、峰值波長等性質的影響。在此基礎上優化出制備多孔硅的具體參數。對不摻sb與摻sb的snci 。
分享友人
分享到 Line

分享到臉書