阻值誤差 的英文怎麼說

中文拼音 [zǔzhíwùchā]
阻值誤差 英文
resistance value error
  • 阻 : 動詞（阻擋; 阻礙） block; hinder; impede; obstruct
  • 誤 : Ⅰ名詞（錯誤） mistake; error Ⅱ動詞1 （弄錯） mistake; misunderstand 2 （耽誤） miss 3 （使受損害...
  • 差 : 差Ⅰ名詞1 （不相同; 不相合） difference; dissimilarity 2 （差錯） mistake 3 [數學] （差數） differ...
  • 誤差 : error
  1. The pressure drop of the compound tray can be regarded as consisting of dry plate pressure drop, clear liquid resistance, liquid surface tension resistance, and packing pressure drop. the model that has established can fairly predict the pressure drop of the compound tray, the value calculated by the model compared with that detected by experiment is less than 20 %

    復合塔板的壓降可認為由干板壓降、清液層阻力、填料層壓降和克服液體表面張力的壓降四部分組成，所建立的壓降計算模型，能較好地預測復合塔板的壓降，計算值與實驗值誤差在20以內，可用於工程設計。
  2. It creates the model of layer soil by using the cdegs software, analyses the resistance error which is measured by traditional three - poles way, measures the grounding grids resistance and soil resistance rate of hejin power plant, creates the electromagnetic model of layer soil and grounding grids model of hejin power plant, calculates the step voltage > touch voltage n voltage distribution of earth surface in fault of hejin power plant. in the end, it compares the measuring value and calculating value of grounding grids resistance in hejin power plant

    本文利用cdegs軟體建立分層土壤接地模型，對傳統三極法測量接地電阻誤差進行分析；對河津電廠接地網接地電阻和土壤電阻率進行測量；建立河津電廠分層土壤電磁模型和接地網模型；計算河津電廠接地網電阻和事故狀態下跨步電壓、接觸電壓和地表電位分佈；最後對河津電廠接地網電阻實測值與計算值進行比較分析。
  3. Based on analyzing causes of formation of system error, random error and gross error, together with their influences to observation values, method that examine whether there is system error in apparatus by using temperature values of unbonded elastic wire resistance type meters is studied

    在對系統誤差、隨機誤差、過失誤差成因及對監測數據的影響分析基礎上，研究了利用差動電阻式儀器的伴測溫度測值來檢驗儀器是否存在系統誤差的方法。
  4. 1. method that controls quality of field observation values of unbonded elastic wire resistance type meters is studied. methods that examine system error of different types in observation values are discussed

    主要研究內容如下： （ 1 ）研究了差動電阻式儀器現場觀測值的質量控制方法；探討了對監測數據中不同類型的系統誤差進行檢驗的控制圖法和連檢定法。
  5. Error analysis of resistance indication of earth - continuity tester

    接地導通電阻測試儀電阻示值誤差分析
  6. The meaning of cqc ( t ) algorithm is the difference in time domain between the peak value location in time axis of input earthquake and model response of structure, which is called delay time. through the delay time calculating of a series of oscillators with different damp ratio and natural vibration frequency, it is found that it will bring biggish error if the cqc algorithm applied on the structure which has long period, and the time dependent cqc ( t ) algorithm could solve the problem easily

    Cqc （ t ）方法的意義在於輸入地震動峰值與結構模態響應峰值在時間軸上的時間差，我們稱之為延遲時間，通過計算具有不同周期和阻尼比結構的延遲時間，發現對于自振周期比較長的結構， cqc方法會帶來比較大的誤差，而基於時程的cqc （ t ）方法能夠解決這個問題。
  7. By use plc, system can complete function as follow : this auto - control system be applicable to the temperature and smoke and dust the deal the variety quick, control the process is difficult with the operation is ; by the temperature controlor can automatically follow to the wet tower " exit temperature, error in the ? 3 v including ; by to automatically spray fog to lower the electric resistance, with the function for full the electricity equipment accepting the dust ; because of adopting feedback closed loop, and come to a to respond to the speed quick, constant temprature control the accuracy is high ; because of adopting the sensors, and make the system circumstance to leak water quick ; system have many control parameter can set exit control temperature and adjust value low limit by key ; can communication with remote computer and have remote control

    通過使用plc ，使該自控系統可以完成如下功能：適用於溫度及煙塵量變化快、控制過程難以操作的場合；通過溫控表自動跟蹤增濕塔出口溫度，誤差達到3以內；通過自動噴霧來降低粉塵比電阻，以此充分發揮電收塵器的作用；由於採取了閉環反饋迴路，達到了響應速度快，恆溫控制精度高；通過使用各種檢測傳感器，使得異常情況泄水快；該自控系統具有多套控制參數，增濕塔出口控制溫度及調節閥下限值可通過按鍵設定；可與上位機通訊，具有「現控遠控」功能。
  8. In this topic, the error characteristic of resistance voltage sensor was analyzed in theory, by using electric circuit analysis, the reasons which affected its error were gotten. based on theory analyses, initial structure was designed. then by using fem ( finite element method ) of simple resonance field, several structures electromagnetic field was calculated, and their amplitude errors, phase errors, maximum of electric field intensity and frequency characteristic of amplitude error were contrasted

    本文從理論上分析了電阻式電壓傳感器的誤差，用電路分析法定性的研究了影響電阻分壓器誤差的因素；在理論分析的基礎上進行了電阻分壓器結構的初步設計；基於該設計，利用簡諧場的有限元方法進行了場的計算，比較了幾種結構方案的幅值誤差、相角誤差、最大場強值及其幅值誤差的頻率特性，從而得到一種最優方案；製作了分壓器樣機，並在本實驗室進行了實驗；最後，對電子電路部分進行了初步設計，並提出了抗干擾的措施。
  9. In present dissertation, the model of ert was established, the method to deduce the system equation using finite element method ( fem ) was discussed, and the process of calculating the voltage, resistance and sensitivity matrix through numerical computation was also introduces. because during the process of positive problem solution, errors are unavoidable, so the evaluation of the results were carried out through data and diagram, also the influence to the results caused by the change of parameters was analyzed

    由於在正問題求解過程中，被測域的離散化、計算公式的離散化以及數值計算的近似處理等都將不可避免的引入誤差，因此論文中對計算結果進行了評價，分析了傳感器的參數（電極數，電極尺寸等）以及計算過程所用參數（如剖分精度）的改變對計算結果（電勢、電阻、敏感場）的影響。
  10. Then the constant of peukert equation is calculated from the linear interpolation. simultaneity the characteristic curves of the battery capacity, electromotive force and inner resistance are fitted with least - squares. the maximal of relative error between the calculated values from the models and the experimental data is 2. 59 % under 50a discharge current

    利用peukert方程的變形式，用線性插值法計算出鋰離子電池的peukert常數值；利用最小二乘法擬合了該動力電池的容量特性、電動勢和內阻特性曲線；在50a的放電電流下，數學模型的計算值與試驗結果的最大相對誤差為2 . 59 。
分享友人
分享到 Line

分享到臉書