附著力試驗 的英文怎麼說

中文拼音 [bùzhāolìshìyàn]
附著力試驗 英文
adhesion test
  • 附 : Ⅰ動詞1 （附帶） attach; add; enclose 2 （靠近） get close to; be near 3 （依從; 依附） agree to; ...
  • 著 : 著助詞1. （表示動作的持續） 2. （表示狀態的持續） 3. （用在動詞或表示程度的形容詞後面, 加強命令或囑咐的語氣） 4. （加在某些動詞後面, 使變成介詞）
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 驗 : 動詞1. （察看; 查考） examine; check; test 2. （產生預期的效果） prove effective; produce the expected result
  • 著力 : put forth effort; exert oneself
  • 試驗 : trial; experiment; test
  1. Butyl acrylate was selected as the tender monomer in prepared bpua, and when the viscosity of middle multipolymer is 800 - 1000mpa. s, the last prepolymer had good capability. in the applied research, some influencing factors such as diluent, photoinitiator and photoinitiators that match to different pigments on the coating film were studied

    根據研究的結果，進行大量的配方實驗，研製了適合於皮革使用的uv上光油，經性能測試顯示：光澤度110 、耐折性3萬次、耐溶劑性200次、附著力合格，達到皮革上光油的使用要求。
  2. Advanced technical ceramics. methods of test for ceramic coatings. determination of adhesion by a scratch test

    高技術陶瓷.陶瓷塗層試驗方法.第3部分:用劃痕試驗法對陶瓷塗層附著力的測定
  3. Several kinds of fillers, i. e., phenol - formaldehyde, alkyd, polyester, polyurethane and poly - vinyl - acetate, were tried to coat surface of wheat straw board ( wsb ) in this paper

    摘要對麥?人造板表面分別試驗了酚醛樹脂、醇酸樹脂、聚酯樹脂、聚氨酯、聚醋酸乙烯酯膩子，塗刮膩子后再噴塗丙烯酸漆，並測定漆膜附著力。
  4. Metallic coatings - galvanization by immersion in molten zinc hot - dip galvanizing - adhesion test methods

    金屬鍍層.熱浸鍍鋅.附著力試驗法
  5. Coil coat metals - test methods - part 6 : adhesion after indentation cupping test

    鍍層盤材金屬.試驗方法.第6部分:壓痕后的附著力
  6. Self - prepared paper varnish with excellent comprehensive properties, adhesion is well, glossiness is > 110 % and resistance to acetone is > 200 times. self - prepared uv printing ink adhesion is well, glossiness is > 80 %, tenderness is 1mm and resistance to acetone is > 200 times, and through aging testing, the coating film did n ' t become brittle

    研製的紅、黃、藍三種顏色的uv油墨，經性能測試表明：光澤度80 、附著力合格、耐溶劑性200次、油墨性能良好，柔韌性1mm ，長時間老化實驗后塗層沒有出現發脆的現象，改善了現存油墨的脆性問題，油墨性能良好。
  7. Adhesion testing methods for rubber, vulcanized or thermoplastic

    硫化的或熱塑性橡膠附著力的試驗方法
  8. Test method for adhesion of corrugated fibreboard

    瓦楞纖維板附著力的試驗方法
  9. Vitreous and porcelain enamels for aluminium and aluminium lloys. adhesion tests

    鋁和鋁合金用釉瓷和搪瓷.附著力試驗
  10. Adhesion test for metallic coatings by shot peening

    噴丸加工處理的金屬覆層的附著力試驗
  11. Test methods for adhesion of thin films on glass substrate

    玻璃基材上薄膜的附著力試驗方法
  12. Detailed contrastive simulation tests of four - phase and self - optimalizing abs control have been made and applying effects of self - optimalizing control are discussed, which establish stable principle foundation for self - optimalizing control applying to realistic abs controller. from the simulation results we can find that : automobiles which install self - optimalizing abs apparatus lock on the any road surface only when the vehicle body velocity and wheel velocity arrive at zero approximately, which is better for improving driving stability under braking. it shows anti - lock ability of self - optimalizing ; slip ratio approximates and surround the desired slip, which shows that this abs system uses fully road surface performance and retains large adhesion and braking performance is good ; braking force regulates with varies of road condition, which realizes road self - identification

    通過模擬試驗可以看出：在各種路面上，汽車在安裝了自尋優防抱制動裝置后，在車速、輪速接近為0時才抱死，這對提高汽車制動時的操縱穩定性特別有利，顯示了自尋優避免車輪抱死的能力：滑移率的值基本上一直接近並且圍繞著與路面附著系數相對應的滑移率上下變化，說明了該系統充分利用了路面性能，基本上保持了較大的附著力制動，制動性能較好；制動力隨著路面條件的變化而相應做出調整，實現了路面自動識別的功能。
  13. Standard test method for adhesion of dried thermal insulating or finishing cement

    干固的絕熱水泥或飾面水泥附著力的標準試驗方法
  14. Tonellini m. on the work of adhesion of film - substrate solid junctions [ j ]. thin solid films, 1991, 202 : 227 - 234

    氣相沉積薄膜-基體界面附著力的劃痕試驗法編制說明
  15. Coating adhesion test instrument

    漆膜附著力試驗儀
  16. The structure and the thickness of the coatings was inspected by the xjp - 2 metallography microscope, the structure morphology was tested by philips xl30 peg sem, and the adhesion between the foundation and the coating was examed by two methods : one is ws - 92 sound - producing coating adhesion nick testing, another is bending

    利用xjp - 2型金相顯微鏡觀察鍍層組織並測其厚度， philipsxl30feg型掃描電鏡觀測鍍層表面的組織形貌，鍍層與基體的結合力採用ws - 92型聲發塗層附著力劃痕試驗和彎折法兩種方法來定性地檢測。
  17. Test methods of plating adhesion by adhesive type for printed boards

    印製板鍍層附著力試驗方法膠帶法
  18. Standard practice for preparation of bar and rod specimens for adhesion tests

    附著力試驗用棒和桿試樣制備的標準操作規程
  19. Plastics materials. surface coating of metals. plastics coatings. adhesion test

    塑料材料.金屬表面塗層.塑料塗層.附著力試驗
  20. Test methods of solid film lubricants - part 3 : test method for adhesion of solid film lubricants

    干膜潤滑劑試驗方法第3部分:干膜潤滑劑附著力試驗方法
分享友人
分享到 Line

分享到臉書