零位探測器 的英文怎麼說

中文拼音 [língwèitàncèqì]
零位探測器 英文
null detector
  • 零 : Ⅰ數詞1 （零數） zero2 （數的空位） zero sign （0）; nought 3 （表示沒有數量;無） nil; nought 4 （...
  • 位 : Ⅰ名詞1 （所在或所佔的地方） place; location 2 （職位; 地位） position; post; status 3 （特指皇帝...
  • 探 : Ⅰ動詞1 （試圖發現） try to find out; explore; sound 2 （看望） call on; visit; see 3 （向前伸出）...
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 探測器 : finder; detector; seeker; sounder; probe
  • 探測 : survey; search; sound; probe; sounding; detection; acquisition; reconnaissance; localization; fin...
  1. The traditional level measuring methods can n ' t meet our demand because the subjective investigated is in such a poor systemic condition that the temperature is a little high and there ' s so many mill dust and steam there. in this article we perform systemic discuss and research against the dynamic level measuring method under special working condition on the basis of analyzing kinds of level measuring technique in and abroad. first we establish the pressure distribution mathematic model in storage bin and then deduce the mathematic relation between level height and the uniform stress on the bottom of the bin and designed a resistance compressive stress sensor used for the special condition and put forward a resoivement according to its zero excursion existing in practical use

    由於本研究系統被測對象環境溫度較高且潮濕，同時料倉中有大量粉塵及蒸汽，因此傳統的料位檢測方法不能滿足本測試要求。本文在分析國內外各種物位檢測技術的基礎上，針對特殊工況下動態物料高度的檢測進行了系統的探討與研究。首先建立了料倉中的壓力分佈數學模型，推導出料位高度與倉底均布壓力間的數學關系式，並據此設計了中溫電阻應變式壓力傳感器，同時對它在實際應用中存在的零點漂移等問題提出了改進措施，提高了傳感器性能，解決了上述特殊工況下動態物料檢測的技術難題。
  2. At last, the experiment result proved the effectiveness of the spectrum rebuilding technology. the experiment result show that the wavelength detection accuracy is improved by an order of magnitude using the spectrum rebuilding technology compared with that obtained from direct peak search. some other schemes to enhance the accuracy are illustrated

    最後列舉了其它幾種提高測量精度的方案，包括關鍵器件可調諧濾波器的位置變化提高信噪比，調整探測器pinfet的輸出電壓的零點以提高a / d採集卡的利用率，以及採用系統參考消除系統誤差造成的波長漂移。
  3. Two wedge interferometers are designed that the thickness of one is higher than the other. so when the incident coherent light through the interferometers can acquire two fringe patterns which having space shift, but the incident incoherent light only result in consistent intensity signal. through a differentiating amplifier, two signals subtract which can eliminate noise of background and result in higher contrast ratio fringe signals. this method largely improves the system and the ability of detection. the spacing of line fringes is a function of incident laser wavelength, by analyzing, we can extract the wavelength of incident laser. the optical unit analyzing and results also simulated with matlab

    當背景光入射時，直接穿過干涉儀，僅發生強度的衰減，在兩個探測平面上產生幅度基本一致的灰度信號，通過差分放大器，相消為零，從而抑制了背景干擾。當激光信號入射，穿過干涉儀時受到調制，在探測平面上產生干涉條紋。通過所設計的存在平均厚度差的雙楔形干涉儀，兩路干涉條紋圖案出現相對移位：在兩個探測平面對應的位置上，一路出現亮紋，另一路出現暗紋。
分享友人
分享到 Line

分享到臉書