零比較器 的英文怎麼說

中文拼音 [língbǐjiàoqì]
零比較器 英文
zero comparator
  • 零 : Ⅰ數詞1 （零數） zero2 （數的空位） zero sign （0）; nought 3 （表示沒有數量;無） nil; nought 4 （...
  • 比 : Ⅰ動詞1 （比較; 較量高下、 長短、距離、好壞等） compare; compete; contrast; match; emulate 2 （比...
  • 較 : Ⅰ動詞1 （比較） compare 2 [書面語] （計較） dispute Ⅱ副詞（比較） comparatively; relatively; fair...
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 比較 : 1 （對比） compare; compare with; contrast; parallel （with）; comparison; by comparison; in comp...
  1. In hardware design, a / d, mt8880, serial port communication module and other interface circuit are described. in software design, the related algorithms such as scale transform, digital filter, digital zero, dtmf communication and repeated output program are considered

    硬體設計主要介紹了a d轉換、 mt8880 、串列通信等模塊和介面的電路設計，軟體設計主要介紹了程序設計中比較關鍵的標度變換、數字濾波、數字調零和重復輸出等數據處理的演算法以及利用dtmf信號實現數據採集器和監測站傳輸數據的通信軟體設計。
  2. To get a tiny - current high - precision current transformer avoiding electromagnetic susceptible 、 performance instability 、 short life of electronic ones, studies high - precision passive current sensor with single - turn cored structure by reducing its secondary turns. based on the zero - flux current transformer principle, propose a passive zero - flux compensation method and deduced it. designs a current transformer with 500 turns based on this method

    本文研究了零磁通電流互感器原理，提出了一種無源零磁通電流互感器的方法，推導了它的工作原理，設計了基於該原理的500匝電流互感器，通過校驗發現它的比差和角差特性都比普通電流互感器有了很大的改善，並達到了比較高的精度。
  3. The clamping diodes conduct only once in a switching period, and the resonant inductance current is smaller in zero state, leading to a higher efficiency and reduced duty cycle loss. the operation principle of the improved converter and the comparison with the original converter are analyzed in this paper. the effect of the blocking capacitor in series with the transformer or resonant inductance is discussed, and a best scheme is determined

    本文將諧振電感和變壓器交換位置，使變壓器與滯后橋臂相連，這樣箝位二極體在一個開關周期中只導通一次，同時零狀態時諧振電感電流較小，有利於提高變換效率和減小占空比丟失，本文分析改進后變換器的工作原理，並與改進前的變換器進行對比，討論隔直電容在不同位置對變換器工作的影響，確定一種最佳工程方案。
  4. In the thesis, some of the most important functional modules of the smart power control ics are researched and designed, including voltage reference, voltage regulator, under voltage lockout, oscillator and zero - voltage comparator. their topologies, schematics and layouts are introduced and developed

    本畢業設計研究和提出了構成智能電源控制晶元的主要功能模塊，完成了其中若干模塊ip核的電路與版圖設計? ?包括基準電壓源，電壓調節器，欠壓鎖定比較器，振蕩器，電壓過零比較器等。
  5. Under the pattern of cyber - education, open laboratories are becoming inseparable parts which still are weak in the process of teaching. as for electric experiment category, there are many problems in common, for instance, less safe in equipment systems, less functional in instrument protection, thus forcing students to spend large quantity of time reviewing, recording, and analyzing data, while students do experiment only with less time, which have negative effect on purpose of experiment, at the same time, this does not reflect benefits that internet brings us

    然而當前大多數高校的實驗教學環節還比較薄弱，其中對電類實驗來說存在諸多共性問題，比如：實驗系統安全性差，儀表保護功能少，導致實驗器材損壞嚴重：儀表性能不穩定，零漂、溫漂現象嚴重，元器件線性度校正不夠，儀表測量精度差；學生做一次實驗要花大量時間記錄數據、整理數據、寫實驗報告，真正用在做實驗上的時間並不多，從而使實驗效率大大下降；同時也沒有充分利用校園網所帶來的便利和信息共享及互動的功能。
  6. The former two are implemented with logarithmic complexity algorithm

    指數比較器和前導零檢測器都是用對數復雜度演算法實現。
  7. The main content includes exponent comparator, leading zeros detector and leading zeros anticipatory logic, while leading zeros anticipatory logic is the core

    主要內容包括：指數比較器設計、前導零檢測器和前導零預測邏輯，而前導零預測邏輯是本文的核心。
  8. Move with the x axis micrometric movement the sharp shadow, till the digital comparator red light is on the zero right position

    微調移動x軸接近「十」字比較尺，直到數字比較器的指示燈在零點右邊變亮。
  9. According to zero sequence voltage distribution from system zero sequence impedance to shunt reactor zero sequence in zero sequence circuit, the zero sequence voltage at the terminal of shunt reactor and the zero sequence compensating voltage at neutral are compared in the scheme

    即根據零序網路中零序電壓在系統零序阻抗和電抗器零序阻抗上的分佈情況，通過直接比較電抗器首端零序電壓與補償到電抗器末端中性點的零序補償電壓的幅值大小，來判別電抗器匝間故障。
  10. Compared with phase - shift control, pwm plus phase - shift control can reduce the current stresses and rms currents of the converter. the loss of the converter can also decrease. lt is proved the converter can achieve zvs in larger load variation

    與常規相移控制方式相比， pwm加相移控制方式能減小變換器的電流應力，減小通態損耗，同時也能拓寬零電壓開關的范圍，使變換器在較寬的負載變化范圍內都能實現軟開關。
  11. In this paper, a creative precise and carry - home stiffness testing system is designed for measuring stiffness of large sheet metal. this system overcomes difficulties such as instability, being hard to test displacement. except for the mechanism, this system uses a torsion sensor with high accuracy, a suit of step motor s and a pc with the given software to get an ideal effect in practical test

    本文針對大型薄板類零部件剛度測量中的難點，比如力的加載不穩定、變形量測量困難等，設計出了一套精密的便攜式剛度測量系統，系統在機械裝置基礎上利用了高精度傳感器、步進電機和計算機，並結合自主開發的測控軟體，在實際測試中，達到了較高的測量精度。
  12. And to the electric capacity type voltage mutual inductor, because it compares with electromagnetic type voltage mutual inductor, transient state its bad to respond characteristic, as circuit when making the short circuit two times trouble, the voltage two times delays dropping to zero while needing to pass certain one

    而對于電容式電壓互感器，由於它與電磁式電壓互感器相比，其瞬態響應特性比較差，當線路故障而使二次短路時，二次電壓需經過一定的時延後才能下降到零。
  13. By studying the iges data exchange standard and analyzing iges files produced by the preprocessors of cad systems, comprehend basic line elements and basic face elements constituting parts and summarize the means to get data information of parts and assemblies. 2

    通過對iges數據交換標準本身的研究，分析比較由cad系統的前處理器生成的iges文件，了解組成零件的基本線元和基本面元的實體類型，總結出從iges文件中提取零件和裝配體數據信息的方法。
  14. The rapid and reversible change between fluid and solid enables erf potential applications in mechatronic devices, cars and general machines. the transmission ability of a self - made cylinder coupling with zeolite - based erf was investigated, the torque transmission of the coupling in wide ranges of driving speed and electric field was measured. the relationship between the transmission torque, the zero field viscosity of erf and shear yield stress of erf under different electric fields was obtained and compared with theoretical prediction

    本文用沸石和硅油配製的電流變液，在自製圓筒式聯軸器上研究了在一定的速度范圍和有無電場作用條件下測量了其扭矩傳遞能力，獲得了傳遞扭矩與零電場電流變液粘度以及電場中電流變液的剪切屈服應力之間的關系，並與理論值進行了比較。
  15. In the instance of the nc simulation for g - cnc6135 numerically controlled machine tool from engineering teaching center of sichuan university, the simulation software module takes effect well and bears good adaptability and expandability. 2 on the iis of windows operation system, we design the web service system for manufacturing enterprises in the miniature through the asp and ado technology, which is the transfer station and service desk of information for the client who edit the nc code and the client who carry our the simulating

    在對四川大學工程訓練中心實習工廠提供的零件加工數控程序進行模擬的實踐中取得了比較滿意的效果2在windows操作系統和iis平臺上，利用asp技術結合ado數據訪問技術建立起小型的企業網站服務器系統，作為數控程序編程用戶和數控程序仿論文摘要真用戶信息交互的樞紐和信息服務的平臺。
  16. In this paper, a size detecting system, which based on the machine vision technology and image process method has been developed. this system can be applied to the notched impact specimens ’ product line. the main research as follows : according to the request of the notched impact specimens ’ on - line detecting and the feature of machine vision system, on - line detecting system of the notched impact specimens ’ dimension and shape designed by using the technique of image acquisition, display, processing and analysis, which includes the structure design of the system, the configuration of the hardware, the comparison image of image processing, the design of the software and the final error analyzing

    本文以機器視覺技術為基礎，以圖像處理技術為方法，針對機械加工的特殊條件，開發了用於沖擊試樣零件生產線的尺寸檢測系統，本文主要研究了以下內容:針對沖擊試樣在線檢測的研製要求，結合機器視覺系統的功能及結構特點，利用圖像採集、顯示、處理和分析技術，完成了沖擊試樣尺寸在線視覺檢測系統的設計，包括系統的總體結構設計、硬體配置、圖像處理方法比較分析、軟體設計及誤差分析等。
分享友人
分享到 Line

分享到臉書