電刷電流 的英文怎麼說

中文拼音 [diànshuādiànliú]
電刷電流 英文
brush current
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : 刷構詞成分。
  • : Ⅰ動1 (液體移動; 流動) flow 2 (移動不定) drift; move; wander 3 (流傳; 傳播) spread 4 (向壞...
  • 電流 : current; galvanic current; electric current; electricity; current flow電流保護裝置 current protec...
  1. Depend on the comprehensive analysis and study of the structure, principle, and exterior characteristic of the motor, through the methods of system modeling and digital simulation analysis, two kind of control device that work for the low voltage ( lvdc ) and the high voltage ( hvdc ) in avigation are researched respectively. point to the control technique of close - loop speed stabilization at a limited adjustment speed range, we bring out the close - loop speed control method that using the rotor position sensor indirectly measure the speed of the motor

    在全面分析了稀土永磁無動機的結構特點、工作原理、運行方式以及外部特性的基礎上,通過系統建模和數字模擬分析,分別針對航空低壓直( lvdc )和高壓直( hvdc )兩種動機構用永磁無動機,在小范圍轉速連續調節下的閉環穩速控制技術進行了詳細理論研究,提出了利用轉子位置傳感器信號間接測量機轉速進行機轉速閉環穩速控制的策略。
  2. This paper is based on " the remodeled item of the 122mm automatic barbette servo system ". it introduced the controlled project of brushless direct current motor realized by dsp at first. on the base of analyzing and studying the driving wave of the brushless direct current motor thoroughly and fully, it carried on the servo system ' s simulink and presented the concrete software and hardware ' s devise of the whole system in the end

    本論文的撰寫是以「 122mm自行迫榴炮伺服控制系統的改型項目」為基礎,首先介紹了dsp實現無機的控制方案,在深入、系統的分析和研究了無機驅動波形的基礎上,然後進行了伺服控制系統的模擬,最後給出了伺服控制系統具體的軟硬體設計。
  3. Development of control technology of brushless direct current motor

    動機控制技術研究
  4. Novel close - loop speed control technique for brushless direct current motor

    新型無機速度閉環控制技術
  5. Adopted unique ventilation system and non - carbonate direct current motor stabilize the hot airflow

    採用獨特的導風系統及無碳機,恆定預熱風量。
  6. This paper presents the method of design and parameter optimizing in a phase - locked controller, which is used in high - speed brushless direct current motor ( bldcm ) speed control

    摘要提出一種用於高速無動機鎖相速度控制器設計和參數優化方法。
  7. The experiment results indicate that this method is more effective in the brushless direct current motor ' s low speed torque ripple attenuation, and its more effective in improving system dynamic performance

    運行結果表明,此方案能有效地抑制無動機低速時的轉矩脈動,更好地改善系統的動態性能。
  8. Research of non - linearity in brushless dc motor system

    動機系統非線性研究
  9. Dongguan yuhong micromotor co., ltd, affliated to yuhong industry co., ltd., is a professional manufacturer mainly specialize in all kinds of brushless dc micro - motors and various fans

    東莞市宇鴻微機有限公司隸屬于東莞市宇鴻實業有限公司,專業生產以無機為主的各類微特機,以及散熱風扇的企業。
  10. Research on the vibration and noise of the minitype brushless dc motor

    小型無動機振動與噪聲的研究
  11. Stepper motors are like a brushless dc or ac motor

    步進機就像沒有的直或交機。
  12. Theory of thulium no - brush dc motor will be research. 2

    了解稀土永磁無機的工作原理。
  13. The core products include telecom power systems, board mounted power supplies, custom power supplies, ups, precision air conditionings, outdoor shelter solutions, automatic transfer systems, network power protection products, vrla batteries, lv & precision distribution cabinets, centralized power and environment monitoring systems, dc power systems and ac motor drive inverters used in electric utility power systems

    艾默生網路能源產品涉及通信源、印板板裝源、客戶定製源、 ups 、機房專用精密空調、戶外一體化通信機櫃、自動切換開關、動力網路保護產品、蓄池、低壓配和精密配櫃、動力設備及環境監控系統、力操作源、交變頻調速器等領域。
  14. Torque ripple reduction in brushless dc motor drives using a buck converter

    變換器的無機轉矩脈動抑制方法
  15. A separated collecting ring with carbon brushes was designed and manufactured for the dynamic stress test of spoke plates of rotor of bulb tubular turbine generator

    摘要根據測試需要,設計自製了分體式碳環,對燈泡貫式水輪發機轉子輻板進行了動應力測試。
  16. For the bldcm which has a pseudo - sinusoidal back - emf waveform, this dissertation presents a svpwm control method using six discrete position signals for minimizing the torque ripple. the main aspects for the implementation of this method are analyzed, including the initial orientation of the voltage vector, reasonable choice of the impedance angle and the advance commutation angle, and estimation of the successive rotor positions

    針對反動勢類似正弦的準正弦波反動勢無動機,本文提出一種基於六個離散位置信號的自同步svpwm (壓空間矢量法)控制方法,用以削弱磁轉矩脈動,分析了實現這種方法的主要控制環節,包括起動時壓空間矢量的初始定位,阻抗角與超前角的合理選擇以及連續轉子位置的估計等。
  17. The simulation results prove that this control technique can effectively minimize the torque ripple for the bldcm drives whose back - emf waveform crest width is less than 120

    模擬結果表明這種控制策略能有效地抑制反動勢平頂寬度小於120角的無動機的換相轉矩脈動。
  18. Furthermore, this dissertation also gives a comprehensive analysis and comparison to the torque ripple factor, torque - current ratio and other aspects for pseudo - sinusoidal emf bldcm drived by 120 conduction mode, 180 conduction mode and self - synchronous svpwm mode respectively. the simulation and the experimental results indicate that self - synchronous svpwm method is more effective for minimizing the torque ripple without any expense of the torque - current ratio when the crest width of the back - emf waveform is less than 107 electrical angles

    對準正弦波反動勢無動機在120導通方式、 180導通方式和自同步svpwm三種控制方式下的轉矩脈動系數、轉矩比等方面進行了全面的分析與比較,模擬研究和實驗結果表明,當反動勢的平頂寬度小於107角時,採用自同步svpwm控制方法可以在不損失轉矩比的基礎上,更有效地抑制磁轉矩脈動。
  19. Cnc took over glass cutting, pattern making, electrical discharge machining, steel - mill roll grinding, coordinate measuring, electron beam welding, tube bending, drafting, printed circuit manufacturing, coil winding, functional testing, robots, and many other processes

    從玻璃切割、樣式設計、發負載、鋼廠滾動打磨、坐標測量、子束焊接、彎管製作、起草方案、印路製造、線圈纏繞、功能檢測到自動機械等許多過程都已由數字計算機控制系統控制完成。
  20. And the converter will work on the strategy of vector control with the definitive direction of the stators magnetic field. also, the thesis develops the algorithm to corroborate the magnetic field ' s direction by the state ' s current and voltage. to validate the theory analysis of bdfg

    根據理論分析和模擬的結果,本文提出級聯式無雙饋發機的控制策略是基於定子磁鏈定向的矢量控制方法,並推導了用定子側量來確定定子磁鏈方向的演算法,繪制了相應的閉環控制框圖。
分享友人