電弧現象 的英文怎麼說
中文拼音 [diànhúxiànxiàng]
電弧現象
英文
arc phenomenon-
Searching for a way to create an arc light for use on ac networks, tesla now found a new fundamental ideal on which to focus : high - frequency electrical phenomena
在特士拉想辦法讓電弧燈搭配ac電路使用時，發現了一個嶄新的基本想法並且專注其上，那便是高頻電流現象。Analyze and compare pid and vague, single neuron etc. control strategy, and combine with single neuron self adaptive gain, self adaptive right value and preventive integral saturation etc. control strategy. have improved single neuron control algorithm, may restrain efficiently to disturb, reduce broken arc and short circuit etc. phenomenon, make systematic control effect and robustness get to strengthen, also have certain application reference value for the design of the dc arc furnace
通過對pid 、模糊、單神經元等控制策略的分析比較，將單神經元增益與權值的自適應調節、抗積分飽和等控制策略相結合，改進了單神經元控制器演算法，可以有效抑制擾動，減少斷弧、短路等現象的發生，使系統的控制效果和魯棒性都得到增強，對電弧爐控制系統的設計也具有一定的應用參考價值。The electrochemical impedance spectroscopy of nickel electrodeposition indicates that nickel electrodeposition occurs in two steps, the medium frequency inductive loop is ascribed to the relaxation of the electrode coverage by an adsorbed intermediate such as niohads, the low frequency capacitive loop may be due to the inhibition of nickel electrodeposition by adsorbed hydrogen. the mechanism and equivalent circuit of nickel electrodeposition were proposed on the basis of the analysis of electrochemical impedance spectroscopy
不銹鋼電極上電積鎳的電化學阻抗行為表明氨絡合物體系鎳電沉積過程是二次放電過程，中頻感抗弧是由於中間吸附產物nioh _ （ ads ）的弛豫現象引起，低頻容抗弧可能是由於吸附氫原子對鎳結晶的阻滯作用引起，依據實驗結果提出了氨絡合物體系鎳電沉積的反應機理和等效電路模型。Possess the arc push current device. it ' s not easy to change
設有推力電流裝置，不易發生引弧不良和焊條粘附現象。Along with the development of power network transmissed in our country, the internal electric power net in industry and enterprise and the electric power sesytem on generating electricity and power supply, the overvoltage phenomena in the electric power sesytem becomes more and more serious
隨著我國電網系統的發展，電力系統中的過電壓現象越來越嚴重，尤其隨著電纜線路逐漸代替架空線路，電容電流不斷增加，弧光接地現象更是不可避免。The reasons and harm of high harmonics in the substation of electric arc furnace, and some measures of avoiding and decreasing the high harmonics are put forward after careful analysis
摘要通過對電弧爐變電所在運行過程中出現的現象進行分析研究，指出了高次諧波產生的原因及其危害，提出了防止和減少高次諧波的措施。The two - dimensional axisymmetric subsonic - transonic - supersonic flow in an experimental arcjet thruster is simulated numerically using flux vector splitting method. the profiles of density, velocity, temperature, pressure and mach number can be obtained by the computation. the computation grid and some computed results are given here. the test equipment such as power supply system, ignition system, propellant supply system, arcjet thruster, thrust measuring device and vacuum system are introduced briefly. some working phenomena of the arcjet are observed and discussed. three different kinds of instability appeared in the process of the experiments. except some important parameters are measured, it is found that the operating stability of argon is better than that of nitrogen
對一實驗電弧加熱式發動機二維軸對稱亞跨超音速流動進行了數值模擬，所採用的方法是矢通量分裂演算法.通過計算可以得出密度、速度、溫度、壓力和馬赫數的分佈.給出了計算所使用的網格和一些計算結果.簡要介紹了實驗所使用的設備，如電源系統、點火系統、推進劑供給系統、電弧加熱式發動機、推力測量裝置和真空系統.對所觀察到的一些工作現象進行了討論.有三種不同的不穩定性出現于實驗過程.除了所測量的一些重要參數，通過實驗發現氬比氮工作更穩定Innovative, easy to use and powerful 3d photo - realistic rendering, animation and virtual reality software. arc + render makes your image express your imagination
創新性，易用性和強大的三維照片真實感繪制，計算機動畫和虛擬現實軟體.電弧+提供讓你的圖像表達你的想象In this paper, the over voltage induced by re - ignition, rules of breakdown in vacuum contact clearance, factors which influence dielectric strength of clearance and characteristics of re - ignition when vacuum switchgear switch capacitor banks are analyzed. the conclusion is that the breakdown of clearance in vacuum interrupter is the direct cause which inducing re - ignition of vacuum circuit - breaker in capacitor banks ’ switch. particle breakdown is the essential reason to induce breakdown in clearance of vacuum interrupter, although mechanical characteristic of vacuum circuit - breaker is another factor
本文通過對真空開關投切電容器組重燃過電壓、真空觸頭間隙擊穿機理及影響真空間隙介質強度的因素、真空開關投切電容器組重燃現象特點進行分析研究發現，真空滅弧室斷口的真空間隙擊穿是導致真空斷路器投切電容器組重燃的直接原因，其次是真空斷路器機械性能的影響，而微粒擊穿是導致國產真空滅弧室真空間隙擊穿的根本原因。分享友人