電極電勢 的英文怎麼說

中文拼音 [diàndiànshì]
電極電勢 英文
electrode potential
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : i 名詞1 (頂點; 盡頭) the utmost point; extreme 2 (地球的南北兩端; 磁體的兩端; 電源或電器上電流...
  • : 名詞1 (勢力) power; force; influence 2 (一切事物力量表現出來的趨向) momentum; tendency 3 (自...
  • 電極 : electrode; pole
  1. With the use of finite method we have developed computer simulation software for vacuum microtriodes with wedge - shaped and cone - shaped cathode on the basis of stduying deeply the field emission theory of vacuum microelectronics. the software included field section, grid point numbering, and the calculation of electric currents, transconductance and cathode capacitance, moreover, it can simulate the properties of vacuum microeletronic with variant structures and sizes. the relationship was studied and simulated among electic properties and device structures, sizes and cathode materials etc. the optimized design of vacuum microtiode was proposed

    本文在深入研究真空微子器件場致發射理論的基礎上,根據圓錐形、楔形陰真空微子三體的不同特點,分別建立了物理和數學模型,在考慮空間荷密度影響的前提下,以有限元法為基礎採用迭代的方法計算出真空微子三體內的分佈情況,繪制出了等線、子軌跡線,並得到了器件學性能隨幾何參數的變化情況。
  2. Each half reaction responds to the interfacial potential at the corresponding electrode.

    每個半反應都與相應上的界面差相呼應。
  3. In general, there is a measurable difference in potential between the two electrodes whether the cell is passing a current or not.

    通常,無論池有無流流過,兩之間均具有可測量的差。
  4. Two kinds of solutions to the electric potential of electric couple polaron and conductor sphere system

    子和導體球系統的求解
  5. The analysis of potential along the channel of the unipolar organic static induction transistor

    型有機靜感應三體溝道縱向分析
  6. The corrosion behavior of nanocrystalline ( nc ) copper bulks with various grain sizes prepared from igc ( inert gas condemsation ) and vacuum annealing in comparison with conventional microcrystalline ( mc ) copper ( as - rolled and electrolytic ) in acid copper sulphate solution and neutral solution containing chlorides under free corrosion conditions and anodic polarizations has been studied using potentiodynamic polarization, potentiometric analysis, cyclic voltammetry and electrochemical impedance spectroscopy. x - ray diffraction was used to estimate the grain size of the annealed nc copper. field emission gun scanning electron microscopy and x - ray energy - dispersive spectroscopy was used to characterize the surface morphology and analyze the surface composition after the polarization and potentiometric test of both nc and mc copper

    本文研究了用igc (惰性氣體蒸發凝聚原位溫壓法)制備並真空退火到不同晶粒尺寸的納米晶銅和微米晶銅(冷軋紫銅、解銅)在酸性硫酸銅溶液和中性含氯溶液中,在自腐蝕狀態和陽化狀態下的腐蝕性能。使用了動化、位測定、循環伏安法( cv )和化學阻抗譜( eis )等方法。 x -射線衍射( xrd )的方法用來估算納米晶銅晶粒尺寸。
  7. The other was to research new li - al solid solution alloy material and use it as anode in lithium battery. by the trace alloy component, aluminum, doping in lithium metal, it was hoped to improve the sei film stability of lithium / electrolyte interface and consequentially enhance the performances of lithium anode. meanwhile, different form the previously studied lial alloy that had very high content of aluminum, such alloy should not decrease the mass specific energy and electrochemical potential of lithium electrode

    方法二:研究新型鋰鋁固溶體合金材料並將其應用於鋰二次池中,通過微量合金成份鋁的摻雜提高鋰/解質界面sei膜的穩定性,進而提高鋰負性能;而該合金不會像以往高鋁含量的鋰鋁合金那樣降低鋰的質量比能量和化學反應
  8. Standard test method for conducting cyclic potentiodynamic polarization measurements for localized corrosion susceptibility of iron -, nickel -, or cobalt - based alloys

    鐵鎳鈷基合金的局部腐蝕敏感性的循環動化強度的試驗方法
  9. Polymer three - dimension packed bed electrochemical reactor potential distribution

    復合型三維固定床化學反應器分佈
  10. To change the surface condition of electrode and the potential distribution of boundary layer through adsorption, thus affecting the electrode process ; b

    通過吸附改變表面狀態及界面層中的分佈,影響過程; b
  11. As a consequence, the mmf due to the armature current is along the aixs midway between the two adjacent poles, called the quadrature ( or q ) aixs

    因此,由流所產生的磁動沿著相臨的兩個磁,並稱為正交軸。
  12. However, df pre - processing is not required in a interferometer direction finder. it only makes use of the phase relations or differences of sensors disposed at different position. azimuth and elevation are caculated from the phase differences or displayed directly on a crt drived by the voltage or current from the phase differences

    干涉儀測向不必進行測向信號預處理而是直接或間接求取在空間上分開的傳感器上感應之間的相位關系,即干涉相位差,方位角或仰角是直接由干涉相位差計算得到,或將兩基線正交的天線陣的干涉相位差轉化為驅動壓(流)分別加到crt陰顯示器的垂直偏轉線圈和水平偏轉線圈,模擬顯示出來波方位,干涉儀測向為典型的相位測向方法。
  13. Henceforth, we calculate the saliency ratio of improved motor by the way of " electromotive oprce method ", and simulate the start processions of original motor and the improved motor with matlab language. from the result of simulation, we can find that the improved motor have better pefformance than the original motor

    此後本論文運用「法」計算出轉子結構改進后永磁同步動機的凸比,並利用matlab語言對改進前後機的起動過程進行計算機模擬,模擬結果表明改進后永磁同步動機能獲得更好的起動性能。
  14. The research of the new and high conductivity material of lithium ionic conductor is always an interesting issue in the material field due to its low potential, light weight and providing high cell voltage and energy density

    由於鋰具有較負的電極電勢和較輕的重量,可以為化學器件提供高的壓和能量密度,所以鋰離子導體高導率新材料的研究一直是材料研究領域倍受關注的課題之一。
  15. The main work can be summed up as follows : firstly, we studied the thermal - field properties of vcsels, and analyzed the influences of current spreading, material parameters and operating conditions on the temperature distributions. secondly, we began with the electrode voltage and calculated the equipotential s distributions, compared the distributions of voltages and current densities in different depths of vcsels, and then studied the influences of the oxide - confining region with different position or thickness, and the different sizes of the gain - guided aperture and emitting window on the distributions of the injected current density, carrier concentration and temperature in the active region. thirdly, we realized the coupling of electricity, optical and thermal - fields, worked out the threshold voltage, calculated the distributions of the injected current density, carrier concentration and temperature under different offset voltages, and analyzed the impacts of temperature profile and carrier density on the refractive index, fermi levels and optical - field

    具體工作可以概括如下:首先,研究了vcsel的熱場特性,分析了流擴展,材料參數和工作條件對于溫度分佈的影響;其次,從壓入手,計算出激光器中的等線分佈,並對不同深度處的壓和流分佈進行比較,研究了高阻區的不同位置和不同厚度、限制層和出射窗口半徑的大小對流密度、載流子濃度和溫度分佈的影響;再次,實現了、光、熱耦合,求出了閾值壓,計算了不同偏置壓下的流密度分佈、載流子濃度分佈和熱場分佈,分析了溫度和載流子濃度變化對折射率、費米能級和光場的影響;最後,給出了考慮n - dbr和雙氧化限制層時激光器中的等線分佈,分析了n - dbr和雙氧化限制層對vcsel流密度、載流子濃度、溫度和光場分佈的影響。
  16. Surface active agents - determination of inorganic sulfate content in anionic surface active agents - potentiometric lead selective electrode titration method

    表面活性劑.陰離子表面活性劑中無機硫酸鹽含量的測定.鉛電極電勢選擇滴定法
  17. Step standard test method for simultaneous thickness and electrode potential determination of individual layers in multilayer nickel deposit step test

    多層鎳鍍層中單層的同步厚度和電極電勢測定的標準試驗方法
  18. Standard electrode potentials

    標準電極電勢
  19. Polarization potential of electrode

    電極電勢
  20. Discussion on computing method of the standard potential of micro - solubility salt electrode

    對微溶鹽標準電極電勢解法的討論
分享友人