電橋電阻 的英文怎麼說
中文拼音 [diànqiáodiànzǔ]
電橋電阻
英文
bridge resistor-
This paper selects dc double - arm bridge, uses the four - port connection to remove the contact and connection resistances and reduce the electromagnetism interfere. grounding grid conductors fault levels are established during a lot of emulational computations, simulative experiments
使用直流雙臂電橋，採用四端鈕連接法，可大大降低現場中電磁干擾及引線電阻和接觸電阻的誤差影響。Among various fabrication techniques of thin film, the sol - gel process has gained much interest for the preparation of pzt thin film, due to ihe advantages of good homogeneity, easy control of composition, low in - ill i reaving temperature, easy formation of large area thin films pb ( zrxti : - k ) 0 :, ( pzt ) films were prepared on the ito coated glass plates and low resistor silicon wafer in sol - gel dip - coating process associated wi di heat treatment : at different temperatures and characterized by x - ray diffraction ( xrd ) and transmission electron microscopy ( tem ). lt is shown that the pzt ferroelectric thin films with ( 110 ) preferred orientation and well - crystallized perovskite structure can be obtained after annealing at 680 ? for 30 minutes on ito substrate and at 800 " c for lornin on silicon substrate
Pzt的制備方法有很多，其中溶膠?凝膠（ sol - gel ）方法可以和集成電路（ ic ）光刻工藝相互兼容，處理溫度低，有大面積塗敷性能，能精確地控制組分，無需復雜的真空設備，成本低廉，所以對于集成鐵電薄膜電容的應用這種方法有很廣闊的前景。本文利用sol - gel技術在摻錫的in _ 2o _ 3透明導電薄膜（ ito ）襯底和低阻硅襯底上成功地制備了pzt鐵電薄膜。運用了x射線衍射， sawyer - tower電路和lcr電橋分別對薄膜的晶化溫度，結構和電學性能進行了測試。Recording units for resistance thermometers are mostly based upon the wheatstone bridge circuit.
電阻溫度計的記錄設備基本上是根據惠斯通電橋的電路。Three methods used for improving resistive bridge amplifier are introduced in this paper
摘要在構成基本型電阻電橋傳感放大器的基礎上給出了三種改善其性能的方法。Self - balance display instruments for temperature measurement. guidance for the calculation of bridge resistance, scale and chart
自動平衡式測溫顯示儀表.橋路電阻標度尺和記錄紙的計算導則Resistance thermometer bridges may be excited from either a-c or d-c sources.
電阻溫度計電橋的供電可以是交流電源，也可以是直流電源。Measuring contract resistance with double electric bridge method
雙電橋測收縮電阻The main work and conclusion for this paper is as following : according to the flashover test results of several kinds of iced insulators under positive voltage and negative voltage, this paper obtained : for the single porcelain insulator, the single glass insulator and the composite insulator bridged completely by icicle, the metal cathode ' s strong ability of emission electron is the primary reason that results in the lower negative flashover voltage ; the position difference of the high resistance district in method anode side results in that porcelain insulator cluster and glass insulator cluster have an evident effect of polarity ; when less ice and no icicle at the brim of the sheds, due to numerous non - polar arcs on the composite surface, the effects of polarity of composite insulator was lost using the test method of the average flashover voltage in the freezing period, dc flashover performances were investigated of several insulators with some typical structures and different material
本文的主要工作和結論如下：在人工氣候室內，根據不同覆冰絕緣子正、負極性下的閃絡試驗結果，得出負極性電弧金屬陰極的強電子發射能力造成了單片瓷、玻璃絕緣子及被冰凌橋接的合成絕緣子有較低負極性冰閃電壓；正極性電弧金屬陽極側產生高電阻區所處位置的差異使得瓷和玻璃絕緣子串具有明顯的極性效應；覆冰較少時，合成絕緣子表面出現數量較多的非極性電弧使合成絕緣子無極性效應。利用覆冰期內平均閃絡電壓的試驗方法，對不同材質和結構的絕緣子在覆冰、低氣壓和污穢共存環境中的直流閃絡特性進行了研究。試驗結果表明，直流平均閃絡電壓隨著海拔的升高、覆冰量的增加以及污穢度的增加而降低，且其特徵指數與絕緣子結構、覆冰量、覆冰狀態、污穢度等有關。D. c. bridge for measuring high resistance
直流高阻電橋Dc high resistance bridge
直流高阻電橋Among it the sensing surface of sensor should be established whetstone bridge, when the pressure is increased, resistance value of each bridge arm takes place change
其中傳感器感壓面有惠斯頓電橋，當增加壓力時，電橋各橋臂電阻值發生變化。By compared with the simulation results and the experiment results, we come to the conclusions that : ( 1 ) circuit with assistant network can widen soft - switching extent in lagging arm, reduces duty - cycle loss on the secondary, diminishes switching dissipation of inverter spot - welding power source. ( 2 ) the range of resonant capacitor, the important factor to soft - switching process, not only affects zero - voltage turn - off of power switches, but also affects the range of zero - voltage turn - on of power switches. so resonant capacitors must be considered according to many aspects ; ( 3 ) it easily fulfils soft - switching condition in lagging arm as leakage inductance of power transformer increases, but bigger leakage inductance of power transformer increases opening dissipation of transformer and decreases efficiency of soft - switching inverter power source
通過模擬結果與軟開關點焊逆變器試驗結果的對比分析，得到了如下主要結論：採用輔助網路可以完全拓寬全橋軟開關逆變器的滯后橋臂軟開關范圍，減小了次級占空比丟失，降低了逆變電阻點焊電源的開關損耗；諧振電容是影響軟開關工作狀態的重要因素，其大小不僅影響開關管的零電壓關斷，同時也影響開關管的零電壓開通范圍，因此，諧振電容應該綜合考慮；功率變壓器漏感越大，越容易滿足滯后橋臂的軟開關條件，但是大的漏感也使變壓器的通態損耗增加，降低了軟開關逆變器的效率。It is convenient to adjust the circuit and easy to acquire sensitive signal by using this method, and there is not the impedance mismatching problem met in bridge - based self - sensing circuit
該方法使得自感知電路的調節和感知信號的獲取變得容易，克服了電橋法自感知電路阻抗不易匹配的不足。The results indicates the new hybrid bridge type sfcl using the inductance of the superconducting state and the impendence of the normal state of the superconductor could be more efficient in fault current limiting than the traditional bridge type sfcl
結果表明，該拓撲結構同時利用了超導體超導態的電感和失超后的電阻來限制故障電流，限流效果好，響應和復位速度快，是對橋式限流結構和混合型限流原理的有意義的探索。An experimental study of the measurement of resistae by applying unequilibrium electric bridge
應用非平衡電橋測量電阻實驗的研究According to the principles of unequilibrium electric bridge, this paper analyses the work features of the three bridge types and based on experiments, shows how to select the bridge types and parametes. to reduce the non - linear errors and avoid centain unusual circumstances in the measurement
從非平衡電橋測電阻原理出發，分析了3種橋式的工作特性，並通過實例說明如何選取電橋的橋式與參數，以減少測量的非線性誤差及避免一些異常情況。A new bridge type high temperature superconducting fault current limiter ( sfcl ) with a limiting impedance of superconductor serried in the limiting circuit is proposed, which could limit the peak value and the stable value of the fault current
摘要提出一種改進的橋式高溫超導限流器拓撲結構，將不同高溫超導體製成的限流電阻與限流電感同時申入橋式限流迴路。Directives of designing and calculating the bridge resistances and scales of moving coil temperature indicators
動圈式溫度指示儀.橋路電阻標度設計計算導則Dc bridges for measuring resistance ; amendment 2
電阻測量用直流電橋.第2次修訂D. c. bridges for measuring resistance
電阻測量用直流電橋分享友人