電流軸線分量 的英文怎麼說

中文拼音 [diànliúzhóuxiànfēnliáng]
電流軸線分量 英文
component of current
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 軸 : 軸Ⅰ名詞1. （圓柱形的零件） axle; shaft 2. （對稱部分的直線） axis 3. （圓柱形的纏繞器物） roller; spool Ⅱ量詞（用於纏在軸上的線以及裝裱帶軸子的字畫）
  • 線 : 名詞1 （用絲、棉、金屬等製成的細長的東西） thread; string; wire 2 [數學] （一個點任意移動所構成的...
  • 分 : 分Ⅰ名詞1. （成分） component 2. （職責和權利的限度） what is within one's duty or rights Ⅱ同 「份」Ⅲ動詞[書面語] （料想） judge
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 電流 : current; galvanic current; electric current; electricity; current flow電流保護裝置 current protec...
  • 軸線 : 1 [機械工程] axis; axle; [地質學] axial trace; axial cord; axis shaft line; shaft line 2 [紡織] s...
  1. Since complicated differential and integral operations were involved in the kernel of the integral equation, we simplified the equation and got the nakano equation. as instances, the planar archimedean spiral antenna, the planar equiangular spiral antenna, the monofilar helical antenna, the conical helical antenna with fixed ascending angle and the conical equiangular - spiral antenna were analyzed through the moment method. all of the results matched fairly well with the references and experiment results

    這種方法的積分方程的積分核里含有復雜的微積分運算，為了簡化計算，本文在推廣的海倫積分方程的基礎上，對方程進行了簡化，推導了nakano方程，並以平面阿基米德螺旋天線，平面等角螺旋天線，軸向模圓柱螺旋天線，具有固定升角的圓錐螺旋天線和圓錐等角螺旋天線為例，用矩量法求解了天線上的電流分佈，研究了螺旋天線輻射的寬頻帶特性，所得的結果均與參考文獻吻合很好。
  2. In order to make the sensitivity of 2 - demension accelerometer along the two main arbors almost identical, symmetric four - beam structure that embeds a double - sides interdigitated differential capacitive with puckered beam in two directions was used as sensitive component. in addition, the differential capacitive accelerometer fabricated by bulky silicon micromechanical technique has high sensitivity, wide measurement scope, less nonlinear error, and simple converting circuit. then, the structure parameters of the sensitive component were calculated and stimulated, which results in a set of the optimized structure design parameters, main fabrication procedure and several key fabrication technology

    為使二維振動傳感器在兩主軸方向的靈敏度大致相同，敏感元件採用高度對稱的四梁結構，其中每個軸向上均採用帶折疊梁的雙側叉指電容結構，採用體硅微機械工藝製作的高深寬比叉指電容式敏感元件，具有高靈敏度、寬量程、非線性誤差小、外圍電路簡單等優點;對設計的敏感元件結構參數進行了計算，並利用有限元法進行了模擬分析，根據模擬結果得出了優化參數;在確定敏感結構的基礎上，研究了敏感元件採用體硅微機械加工工藝製作的工藝流程和關鍵工藝技術;對敏感晶元內部的c - v介面電路進行了原理設計與分析，利用差動測量技術得到由振動引起的微小電容變化量，經c - v介面電路進行相位調制處理，然後通過解調輸出與加速度成正比的電壓信號。
  3. Based on many references form civil and abroad, the author mainly studies the measurment theory and method for flux, raising height, axial power and rotational velocity. avoiding many complicated and intermediate courses for power wastage analysis, introduces the electric measurement and using efficiency curve of motor in measureing axial power, and satisfies the automatization of the device. the paper also provides a new method, inductive winding, in measuring rotational velocity of electromotor, supplys limitations of other method in measuring rotational velocity of electromotor in water, and meet practical needs in developing diving electric pump for corporation

    作者在參閱大量國內外有關文獻，著重探討了水泵流量、揚程、軸功率、轉速的測試原理和測試方法，提出了採用電測法並結合電機效率特性曲線測量水泵軸功率，從而避免了損耗分析法中大量復雜的中間過程，滿足了試驗裝置的自動化測量要求；採用漏磁感應線圈法測量電機轉速，彌補了其它轉速測量方法對水下電機測試的局限性，適應了萊恩公司開發潛水電泵的實際需要。
  4. It was difficult to measure the load voltage directly between inner and outer conductor of cable induced by shield current under low flux x ray. this paper introduces a measurement, pouring a current, which was same as cable approximately photocurrent in x ray test, into the shield of cable with a triocoaxial system, and the load voltage was got. finally the measured result of typical cable and comparison with the calculation was given with a special load

    在簡要介紹屏蔽電纜的轉移阻抗和轉移導納耦合的基礎上，描述了利用三同軸系統對雙電纜和等效負載組成的電纜系統進行電流注入，模擬電纜屏蔽層發射電流，測量芯線等效負載感應信號的實驗，給出實驗結果及分析，並對理論結果與實驗進行了比較。
  5. A linear theory of rbwo with inner - slot coaxial structure is analyzed detailedly, and the equation of dispersive relation is deduced and computered numerically. 4. particle simulation is used in rbwo respective with coaxial and partial structure. in the simulation, the output parameters of rbwo such as phasespace, contour, vector, voltage, current, output power, interaction efficiency and microwave radiation

    4 .對同軸和偏心返波管分別進行了粒子模擬，通過改變電壓、電流、電子注位置、磁場等參數來觀察返波管加了內開槽前後相位空間、等位線、矢量、電壓、電流、輸出功率、工作頻率的變化。
  6. By equalizing the three - dimension current source to the two - dimension current source in spectral domain, the coaxial probe - fed microstrip antenna is analyzed with the full wave method and moment methods is used to numerically analyze the integral equation

    通過在譜域中把空間三維電流源等效成二維平面電流源，對同軸探針饋電的微帶天線進行全波分析，運用矩量法對積分方程進行數值分析。
  7. Secondly, the beam orbit offset effects caused by the initial beam offset and the linac components " offsets have been quantitatively studied first. as an example with the injector linac for beijing electron positron collider upgrading project ( bepcii ), the beam orbit offset caused by the above error effects have been simulated and analyzed

    其次定量研究束流的初始徑向誤差和加速器部件的安裝誤差等對束流軌道偏軸的影響，並以北京正負電子對撞機二期工程（ bepc ）的直線加速器為例，給出了上述各種誤差導致軌道偏軸的模擬計算結果及其分析。
分享友人
分享到 Line

分享到臉書