電源供給供電 的英文怎麼說

中文拼音 [diànyuángōnggěigōngdiàn]
電源供給供電 英文
power supply
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : 名詞1. (水流起頭的地方) source (of a river); fountainhead 2. (來源) source; cause 3. (姓氏) a surname
  • : 供Ⅰ名詞1 (供品) offerings 2 (口供; 供詞) confession; deposition Ⅱ動詞1 (供奉) lay (offerin...
  • : 給Ⅰ動詞1 (送對方某物; 使對方得到) give; grant 2 (用在動詞后 表示交與 付出) pass; pay 3 (叫; ...
  • 電源 : source; current source; electric source; power pack; power supply; power source; source of power ...
  1. A well-regulated power supply provides the high voltage for the photomultiplier.

    一個高度穩定的倍增管所需要的高壓。
  2. The demodulator receives its reference voltage from the signal-generator voltage supply.

    解調器的參考壓由信號發生器
  3. We can tap into china ' s vast and stable supply of resources, such as human capital, land, water, and power supply

    中芯國際在中國不僅可以貼近中國飛速成長的子產品市場,更能得益於中國充沛且穩定的資,如人力、土地、工業用水和應等。
  4. In order to describe the actual working processes of dielectric barrier discharge ( dbd ) circuit, an analysis model of differential - difference equations was presented, based on the working modes of full bridge serial load resonant dbd circuit, which was adopted with phase shifting control

    摘要為描述介質阻擋放型臭氧發生器路的實際工作過程,在分析一種移相全橋脈寬調制下串聯負載諧振的臭氧發生器路的基礎上,提出了採用微分差分方程來描述路的工作過程,並出了路可能的工作軌跡。
  5. In the second chapter, equivalent circuit of the eddy current sensor is firstly analyzed. based on that, the carrier signal generating circuit that is realized by the lc periodic circuit is introduced, thus, the carrier signal of standard frequency is obtained through the trimming capacity. subsequently, the disc type rotational armature generator and the rotational coupling transformer are separately leaded in to realize the power supplies of the carrier signal generating circuit and output of the measuring signal

    在傳感器設計一章中,首先對渦流傳感器進行等效路分析,在此基礎上分析了由感、容諧振路構成的載波信號發生路,並通過微調容獲得了標準頻率的載波信號;接下來提出了採用盤式旋轉樞發機解決載波信號發生問題的方案,同時通過旋轉耦合變壓器的引入,使得測量信號輸出問題很好地解決;本章最後出的一組實驗曲線充分說明了這一方案的可實現性。
  6. Power supply, uninterruptible

    不斷
  7. The power supply will be auto recovered when short circuit faults remove

    器在短路解除時,能正常工作恢復。
  8. Power suppliew, switching

    交換式
  9. Peripheral power supplies

    外圍
  10. Power - supply efficiency

    效率
  11. Power - supply operation

    操作
  12. Power - supply circuit

  13. Power - supply basics

    基礎
  14. Line power supply

  15. In these 7 years, the company operates based on human oriented, top science and technology, serving customers and return society. our aim is to establish up - to - date management system, develop environment protection hi - tech and products and contribute to human environment protection. we always insist on jingming core value - love and responsibility, love hometown and love the earth, be responsible to environment protection, be responsible to society and the future

    七年以來,公司遵循「向環保負責向社會負責向未來負責」的原則進行項目的開發和建設利用工業垃圾工業廢水生活垃圾農業廢棄物,通過我們的特殊技術和設備進行治理,分解和燃燒,向園區內的企業和居民提全方位的能,可以實現水污水處理和標準化廠房五項功能為一體,達到「循環經濟節約能以廢治廢變廢為寶」的最終目的。
  16. The system uses micro - work designs ; the total supplied current is not beyond 300 a, which makes it possible that one 5ah li - cell can be used about 2 years

    整個系統採用微功耗設計,的總流不超過300 a ,使得一節5ah的鋰池可以持續使用2年。
  17. Available to the flashlight, computers and household appliances work power

    筒、腦等家用器的工作
  18. G : available to the flashlight, computers and household appliances work power

    筒、腦等家用器的工作
  19. In the description of circuit design, the emphasis is paid the following hardware modules : ad / da inverter, dsp module, external program / data memory, cpld control logic, serial communication module, power module, and so on. problems and the corresponding solutions found in the design and debug stage are discussed, too. finally, the low - level software driver design is presented in detail, including system booting, initialization of dsp registers, cpld logic and timing control, drivers for asynchronous communication fifo, and drivers for ad converter

    路模塊分析中,重點介紹了語音的輸入放大和輸出緩沖部分、 ad da轉換、 dsp語音壓縮解壓、外部程序數據存儲器、 cpld邏輯控制、串列收發組件、以及dsp的jtag介面等等,並且出了在硬體路設計和調試過程中的問題與解決辦法。
  20. At the end of the thesis, simulation results of hxmt are given to validate the system designing. furthermore, attitude adjusting method is used to solve the power - supply lacking question when p angle is big

    此外,還提出了通過側擺解決在角較大時能系統不足的問題,並出了相應的設計及模擬結果。
分享友人