電熱負荷 的英文怎麼說

中文拼音 [diànrèfùhé]
電熱負荷 英文
electrothermal load
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 負 : Ⅰ名詞1 （負擔） burden; load 2 （虧損） loss 3 （失敗） defeat Ⅱ動詞1 [書面語] （背） carry on th...
  • 荷 : 荷名詞（蓮） lotus
  • 負荷 : [電學] load; charge; weight
  1. The test shall demonstrate to the satisfaction of the owner that the equipment meets all specified performance criteria, is properly installed and anchored, and operates smoothly throughout the specified speed range without exceeding the full load amperage rating of the motor or excessive motor heating

    測試應該讓用戶滿意，證明這些設備符合所有規定的性能標準，經過正確的安裝和錨固，在額定轉速范圍內運行平穩，沒有超過電機的額定滿負荷運轉電流安培數，或發生電機過熱。
  2. 2d - cad, 3d - cad cae, injection molding machines, 3dmeasurement machines, ultrasonic welding machines, high - frequency electromagnetic welders, hot stamping machines, silkscreen printing devices, caulking machines, automatic screw machines, det raw material - exclusive dryers, load testers

    2d - cad ， 3d - cad cae ，射出形成機， 3維測量機，超聲波焊著機，高頻電磁電焊機，熱沖壓機，絲印刷裝置，鉚合機，自動打釘機， det原料專用乾燥裝置，負荷試驗機。
  3. Finally, we can not use electric power but the engine of bus or subsidiary engine to drive air compressors of bus air conditions. because the change range of turnaround speed of engine is very wide, that brings difficulties in controlling the rate of flow of cold - producing medium. in the control of bus air - conditions, preventing evaporator from freezing to make the air - conditions work with high efficiency and controlling the temperature of railway carriage are the basic tasks in air - condition control

    與一般的建築空調相比，汽車空調的工作環境惡劣，條件差，控制難度要增加很多，主要體現在以下幾個方面：一是車外熱負荷變化大，難以確定控制參數；二是要求空調負荷大，而且要控制空調使其降溫迅速：三，不便於用電力作為動力源，必須用汽車發動機或輔助發動機來帶動壓縮機，當採用汽車發動機作為動力源時，由於汽車的車速變化大，發動機轉速的變化可從600r min到4000r min ，壓縮機轉速與發動機轉速成正比，其轉速變化高達7倍，給空調系統製冷劑流量控制帶來困難。
  4. According to the operation of subcritical reheat controlled circulation drum boiler, this paper analyses the factors which affect the responding speed to unit load, through modifying the coordinating control system, fully using the boiler ability of heat accumulation and other methods, the author puts forward some measures to raise responding speed to unit load

    分析了影響中間儲倉式汽包爐機組快速響應電網負荷變化的因素，通過對協調控制系統的改進，以及充分利用鍋爐蓄熱能力等方法，提出了提高機組快速響應負荷變化的幾條途徑。
  5. The electric heat components and heated components in resistor furnace were regarded as research object, the simplified model was provided on the basis of simplification of studied objects, the thermotechnical theoretical calculation and analysis for it were done by utilizing radiation heat transfer theory, some main factors influencing the temperature of electric heat component were obtained on condition that the hot load for the heated component be constant, thermotechnical engineering scheme by which the service life for resistor component could be prolonged, was raised

    摘要以電阻爐中的電熱元件和被加熱元件為研究對象，經過簡化提出簡化模型，運用輻射換熱理論對其進行了熱工方面的理論計算和分析，在被加熱元件熱負荷一定的情況下，得出了影響電熱元件溫度的幾大要點，提出了延長電熱元件使用壽命的熱工技術方案。
  6. Actually, known the distribution of electric price and demand of heat load versus time, an optimizing supply curve can be drawn, that is, the concrete economically running policy can be made

    實際上，在已知逐時電價曲線和用戶熱負荷曲線的情況下，應存在一條最優的供熱曲線（或電鍋爐啟停曲線） ，這條曲線可利用最優化理論和適當的優化方法來找到。
  7. During the heat accumulator supplying to users, the electric boiler usually try to make heat by starting at low price of electric and stopping at high. in general, the system of electric boiler with heat accumulator runs according to experience to utilize the time - of - use electricity price or controlled by the signals of water level or temperature

    當前運行的蓄熱式電鍋爐供熱系統中電鍋爐的啟停控制一般有兩種方式：一種是根據分時電價和用戶熱負荷由人工啟停，另一種是根據蓄熱器的水位或水溫信號由自動控制裝置啟停。
  8. This paper analyses current situation of chp and situation of development, use evaluating energy utilization - - based on electricity comparing with state calculated method - - based on heat, calculates the operating data of baotou second thermal power plant heat supply system ， extends the study of heat supply performance to heat net and heat consumer, synthetically analyses heat load characteristic 、 pipe net property and heat supply distance witch effect heat supply cost. the paper studies the thermal power performance of thermal power plant total energy system, discuss heat supply cost which effect the development of chp

    本文對熱電聯產的現狀及發展情況進行分析，採用能源利用系統性能評價指標體系及其評價指標? ?電量法與國家目前採用的法定計量方法? ?熱量法進行比較，通過對內蒙古包頭第二熱電廠供熱熱源系統及供熱熱網系統的熱電聯產運行數據進行分析計算，將供熱過程的熱力性能研究延伸至熱網和熱用戶，分析用戶終端的能源利用情況，針對內蒙古地區主力機組和地區條件，綜合分析了熱負荷特性、管網性能及供熱距離對供熱成本的影響，研究了熱電廠總能系統的熱力性能，對困擾熱電聯產的供熱成本進行了探討。
  9. According to the requirements of propeller aerocraft model test in wind tunnel, specifications of the driven motor is presented by aerodynamic analysis, and a short - term operated high power density three - phase induction motor is developed with reasonably designing the motor, such as electromagnetism load, heat checkout and high - efficiency heat exchanger

    摘要針對螺旋槳飛機模型帶動力風洞實驗要求，通過氣動性能分析提出驅動電機的技術指標，在滿足結構約束的條件下，通過合理設計電機的電磁負荷、校核發熱、採用高效冷卻裝置等，研製出短時工作制高功率密度三相異步電機。
  10. As the dangerous position needed to be verified has been identified with the known heat flux profile and the characteristics of flow rate distribution, the metal tube temperature of the position can be obtained

    此方法克服了目前常用的電廠鍋爐壁溫計算方法中校核點工質流量與熱負荷並不一定互相對應的缺點。
  11. When using electric heaters, ensure adequate indoor ventilation, and keep the heater away from the entrance, the corridor and combustibles. do not overload the electricity supply and avoid overheating, which may lead to fire or burn injuries

    若選用電暖爐，一定要確保室內空氣流通，電暖爐要遠離門口通道或易燃物品並要避免電力負荷過重及小心過熱，以免發生火警或灼傷等意外。
  12. The regenerative electrothermal boiler heating system can increase the ratio of charge, it have nice developmental outlook

    能充分提高電網負荷率的蓄熱式電熱鍋爐供暖系統具有很好的發展前景。
  13. Choose the cable type according to power supply condition and power net load, decide if use parallel connection or series connection type cables, single phase or three phase type cables

    根據供電條件、電網負荷及電伴熱帶使用長度等因素來選擇電伴熱帶的型式、電壓等級，以便確定是用並聯式還是串聯式？
  14. Abstract : for offsbore oil fields with large power and heating loads, butlack of asaociated gas, the solution of power and heating co - generation will improve theovemll energy efficiency and cut down operating costs, thus improving the mteof return and lowering the barrel oil xost

    文摘:對于電負荷和熱負荷都比較大而伴生氣量嚴重不足的海上油田，實現熱電聯供將會提高能源綜合利用率，節省操作費用，從而提高油田收益率，降低桶油成本。
  15. From magnetic fields in pf coils of east expressed as elliptic integrals, the heat load of pf coils during plasma discharge is determined

    摘要通過求解橢圓積分，計算了east極向場系統的磁場分佈，從而計算出極向場線圈在等離子體放電過程中的熱負荷。
  16. Abstract : it is capable for stabitizing operating data, raising generating capacity, and saving energy that a low pressure and condensing turbine - set was installed on the exhaust pipe of turbine - set of back - pressure or extraction and back - pressure, and was run in parallel with a little heat load

    文摘:在背壓或抽汽背壓式汽輪機排汽處增裝低壓凝汽式機組，與少量熱負荷並列運行，可穩定運行參數、提高發電量、節能降耗。
  17. This paper tries to establish a cwl ( climate - weekday - load ) model to predict the heat demand load of users. based on this and associated with the policy of time - of - use electricity price at present time and its future tendency, a much more economical decision can be made for this system using the optimization method

    作為嘗試，通過「 cwl （氣候-星期-負荷） 」模型預測用戶的熱負荷需求，並以此為基礎，結合當前及著眼未來的分時電價發展趨勢，利用優化方法對該系統的經濟運行做出決策。
  18. In order to shift the peak heating and cooling loads to off - peak hours, chinese government has carried out the " peak and off - peak price " policy and research about lhtes is gradually becoming a new focus again

    已經出臺的旨在利用「削峰填谷」緩解電網負荷峰谷差過大的峰谷電價分時計價制已使相變貯能成為研究和應用熱點。
  19. Through analyzing the present operation condition and heat supply respect of the beihai heat power plant which is the largest heat and electricity cogeneration and concentrated heat supply corporation in dalian, a scheme is settled to install a climax load adjustment boiler in the plant

    針對日益增加的熱負荷需求，對大連市最大的熱電聯產、集中供熱單位?北海熱電廠目前狀況和發展要求進行了分析，並制定了新增調峰鍋爐房的方案。
  20. The paper designed a project of plant online load optimal distribution system, which could change the mode of load control between electric power distribution center and power plant. with the use of plant online load optimal distribution system, the power distribution center will not control each power unit directly ， but delieve instruction of load to plant online load optimal distribution system which shall assure each unit to operate more economically

    本文針對國內熱力發電廠負荷優化分配中存在的問題，提出了廠級在線負荷優化分配系統的設計方案。該系統的成功應用將改變現在電網總調對電廠負荷控制方式，總調不再直接控制機組，而是針對整個發電廠發出負荷指令，經在線負荷優化分配系統處理后，根據分析計算結果實現各機組的負荷最優分配。
分享友人
分享到 Line

分享到臉書