電絕緣環 的英文怎麼說

中文拼音 [diànjuéyuánhuán]
電絕緣環 英文
electrical insulation ring
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 絕 : Ⅰ動詞（斷絕） cut off; sever Ⅱ形容詞1 （完全沒有了; 窮盡; 凈盡） exhausted; used up; finished 2 ...
  • 緣 : Ⅰ名詞1 （緣故） reason 2 （緣分） predestined relationship 3 （邊） edge; fringe; brink Ⅱ動詞（攀...
  • 環 : Ⅰ名詞1 （環子） ring; hoop 2 （環節） link 3 （姓氏） a surname Ⅱ動詞（圍繞） surround; encircle;...
  • 絕緣 : 1 [電學] （隔斷電流） insulation; isolation; insulate; isolate 2 （跟外界不發生接觸） be cut off ...
  1. First, a simple discussion for the mechanism about electrostatic atomization of the liquids has been given ; then the paper theoretically analyzed waving course, liquid drop producing course, and the liquid drop diffusing course in electrostatics atomization process., gave an analysis about the methods about carrying charges to the liquid drop, and analyzed that liquid with high electrical conductivity can be carried charges and atomized by electric field, while the isolated liquid with low electrical conductivity can be charged fully with the soakage electrode and inducing charge methods. at last the paper designed and configured the experimental equipment, conducted the atomization experiment to the three liquid medium - kerosene, emulsifier and alcohol under the same environment, handled the experimental results, then summarized the relationship between liquid electrostatic atomization effect and liquid surface tension, electronic conductivity and viscosity, along with the influence of voltage to electrostatic atomization and so on, found out the liquid atomization rule in high voltage electrostatic field

    首先，對液體介質的靜電霧化機理作了初步的探討，理論上分析了液體霧化過程中射流區、波紋區、霧滴區和霧滴擴散區;然後對液體荷電方法進行了研究分析，對于高電導率的液體，場致荷電和接觸荷電可以使其霧化，而對于電導率較低的絕緣液體，需用浸潤電極荷電和感應荷電方法使其充分帶電;最後，根據前面的研究分析，設計和組裝試驗裝置，在同一環境下對煤油、乳化劑、酒精三種不同液體介質進行高壓靜電霧化試驗，並對試驗結果進行分析處理，總結出液體靜電霧化與液體表面張力、電導率和粘度的關系及電壓對液體靜電霧化的影響等，得出高壓靜電場中液體霧化的一般規律。
  2. Neoprene grommet and complete epoxy encapsulation provide for a true non - wicking cable entry. an isolating cable chamber is not needed

    氯丁橡膠絕緣墊圈和全部環氧樹脂密封，提供真正的無芯電纜連接。不需要另外配置絕緣電纜盒。
  3. In applications where high impedances and very low currents are involved a guard ring may be used to minimize the effects of low insulation resistance

    保護環用在那些高阻抗或電流非常微弱的電路中，用於減輕因絕緣電阻不夠高而產生的（漏電）問題。
  4. The product is a chief material for high temperature insulant, used mainly for the producing of polyimid resin, thin film, and insulating paint. it is also a high temperature curing agent and plasticizer. some kinds of curing agents of powder coating are made from it

    主要用於制聚酰亞胺樹脂，聚酰亞胺在廣泛的溫度范圍內具有優良的電氣絕緣性能，亦可做耐高溫環氧樹脂固化劑聚氯乙烯增塑劑及皮革柔軟劑，還可用做某些粉末原料。
  5. The control system of furnace " s temperature has been widely used in every walk of life, as an important link of repair and manufacture of the electrical equipment such as electromotor transformer etc., soaking lacquer drying craft has some especial requests on drying crafto this article starts with the analysis of drying chamber " s configuration, analyzed its configuration limitation and control function limitation according to the factory " s situation and advances the conception of heated air drying circulation, in addition, this article adopts an intellectualize a / d module, a development sampling tuning - voltage circuit, and presents the method to measure online the insulation resistance of products in order to improve constantly products quality

    而浸漆乾燥工藝作為電機、變壓器等電氣設備的修理、製造中的重要環節之一，對乾燥過程的質量要求有一定的特殊性。該文從乾燥爐的結構分析入手，聯繫到工廠的實際情況分析了結構功能缺陷和控制功能缺陷，提出了熱風循環乾燥的概念，同時，選擇了較為先進的a d板卡、熱電阻信號調理板等專業化智能卡，運用數字pid控制技術，構成了一個較有特色的計算機控制系統。此外，該文還從保證乾燥品質量的角度，採用智能化交流模塊和自製采樣調壓電路的方法，提出了在線檢測產修品的絕緣電阻的方法和手段，以確保企業產品質量不斷提高。
  6. 2. the reactor is soaked with epoxy and its coil is sealed by fiberglass cloth. in reactor coil, mylar and fiberglass is adopted as wire isolation material

    2 .電抗器由環氧樹脂浸過的無緯玻璃絲帶對線圈進行包封，電抗器線圈採用絕緣性能優良的聚脂薄膜及玻璃絲作為導線的匝絕緣。
  7. This paper introduces the property requirements on insulating varnish and some technical indicators of import varnishes used in electronic transformer, discusses the effects of baking temperature, baking time, dry capability, impregnation process of varnish on the noise, rustiness box craze, insulating tape bond failure which occurred in electronic transformer

    摘要介紹了電子變壓器用絕緣浸漬漆的性能要求，介紹了一些進口絕緣浸漬漆的性能指標，分析討論了漆的烘烤溫度、時間、乾燥性、浸漬工藝對電子變壓器的噪聲、生銹、外殼爆裂、絕緣膠帶脫開的影響，討論了絕緣漆在應用中的環保問題。
  8. Tga. insulating and sheathing materials of electric and optical cables - common test methods - part 4 - 1 : methods specific to polyethylene and polypropylene compounds - resistance to environmental stress cracking - measurement of the melt flow index - carbon black and or mineral filler content measurement in polyethylene by direct combustion - measurement of carbon black content by termogravimetric analysis - assessment of carbon black dispersion in polyethylene using a microscope

    電纜和光纜的絕緣和護套材料.通用試驗方法.第4 - 1部分:聚乙烯和聚丙烯化合物專用方法.抗環境應力致裂.熔化流動指數測量.通過直接燃燒測量聚乙烯中炭黑和或礦物填料含量.通過熱重分析法
  9. Insulating and sheathing materials of electric and optical cables - common test methods - part 4 - 1 : methods specific to polyethylene and polypropylene compounds - resistance to environmental stress cracking - measurement of the melt flow index - carbon black and or mineral filler content measurement in polyethylene by direct combustion - measurement of carbon black content by thermogravimetric analysis - assessment of carbon black dispersion in polyethylene using a microscope

    電纜絕緣護套材料的通用試驗方法.第4部分:聚乙烯和聚丙烯專用方法.第1節:耐環境應力破裂性.在空氣中熱老化后的卷繞試驗.熔體流動指數測量.聚乙烯中炭黑和
  10. Pe. insulating and sheathing materials of electric and optical cables - common test methods - methods specific to polypropylene and polypropylene compounds - resistance to environmental stress cracking - measurement of the melt flow index - carbon black and or mineral filter content measurement in pe by direct combustion - measurement of carbon black content by tga - assessment of carbon black dispersion in polyethylene using a microscope

    電纜和光纜的絕緣和護套材料.通用試驗方法.聚丙烯和聚丙烯化合物專用方法.抗環境應力致裂.熔化流動指數測量.直接燃燒法測量聚乙烯
  11. Abstract : in this paper, characteristics of polluted insulator ' s operation state were analysised, studied the differences between each characteristics, the factors influencing lc significantly were found, including circumstance factors, and characteristics of leakage current ( lc ) were studied basing on artificial contamination test, obtained the relationship between leakage current and the influenced factors

    摘要:文章分析了表徵污穢絕緣子運行狀態的特徵量，比較了各特徵量的特點及其適用場所，總結了影響泄漏電流的特徵量，包括環境因素，並且在人工污穢試驗的基礎上，分析了泄漏電流在閃絡過程中的特徵，得出了泄漏電流與其基本特徵量之間的關系。
  12. Test method for evaluating resistance to tracking and erosion of electrical insulating materials used under severe ambient conditions

    在嚴酷的大氣環境下使用的電絕緣材料耐漏電起痕蝕損的評價的試驗方法
  13. The epoxy resin modified by polysiloxane have the advantage of both polysiloane and epoxy resin, it have good heat - resistance, moisture - resistance, dielectric properties. to improve the heat - resistance and the strengthening of the composite, nano - sio2 has been add into the reaction system to modify the epoxy resin with polysiloxane

    這種復合基體能有效得利用有機硅樹脂優異的耐熱性、耐候性、電絕緣性、憎水性、阻然性及耐寒性能，同時又具有環氧樹脂良好的粘結性、耐溶劑性及配伍性等優點。
  14. In order to improve the circuit ' s input impedance, which is affected by insulating resistance of electrode leading wire, terminals and printed circuit board, electrode is connected to the meter through insulating wire of high impedance which is directly welded in the printed circuit board with insulating ring. the deviation of electrode is corrected by software and the algorithm is given

    使用高阻絕緣線連接電極，並將高阻絕緣線直接焊在加有絕緣環的印刷線路板上，從而消除電極引線、接線端子和印刷線路板漏電對放大電路輸入阻抗的影響；軟體校正電極偏差，並給出校準演算法。
  15. Solventless polymerisable resinous compounds used for electrical insulation - specification for individual materials - epoxy resin - based coating powders

    電絕緣不溶可聚合樹脂化合物.第3部分:各型材料規范.第11節:環氧樹脂基塗層粉末
  16. Specification for solventless polymerisable resinous compouds used for electrical insulation. part 3 : specifications for individual materials. sheet 11 : epoxy resin - based coating powders

    電絕緣用無溶劑可聚合樹脂化合物規范.第3部分:專用材料規范.活頁11 :環氧樹脂基塗料粉末
  17. Electrical insulating materials - determination of the effects of ionizing radiation - part 4 : classification system for service in radiation environments

    電絕緣材料.電離輻射效應的測定.第4部分:在輻射環境中工作的分類體系
  18. Varnishes used for electrical insulation - part 3 : specifications for individual materials - sheet 1 : ambient curing finishing varnishes

    電絕緣用清漆.第3部分:專用材料規范.活頁1 :上清漆過程中的周圍環境
  19. Electrical insulating materials - determination of the effects of ionizing radiation - classification system for service in radiation environments

    電絕緣材料.電離輻射的效應測定.輻射環境中設備的分類系統
  20. Methods for evaluating resistance to tracking and erosion of electrical insulating materials used under severe ambient conditions

    電絕緣材料在嚴酷環境條件下耐劃痕與侵蝕性評定方法
分享友人
分享到 Line

分享到臉書