電荷表面 的英文怎麼說

中文拼音 [diànhébiǎomiàn]
電荷表面 英文
surface charge
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 荷 : 荷名詞（蓮） lotus
  • 表 : Ⅰ名詞1 （外面;外表） outside; surface; external 2 （中表親戚） the relationship between the child...
  • 面 : Ⅰ名詞1 （頭的前部; 臉） face 2 （物體的表面） surface; top 3 （外露的一層或正面） outside; the ri...
  • 表面 : surface; superficies; boundary; face; rind; sheet; skin; outside; appearance
  1. We infered that this new absorption band was associated with the effect of charge - transfer transition between adsorbates and colloidal silver particles, not the effect of the surface plasma resonance due to the silver particles aggregation which was usually attributed to in previous research work

    我們將其歸因於與納米銀顆粒表面間的電荷轉移效應（ ct ） ，而非通常所認為的因銀膠凝聚而產生的表面等離子體共振吸收效應。
  2. Secondly the major mechanisms of degeneration of pcss are caused by both the filamentary nature of the current in high - gain pcss damage to the chip of the switch and the charge domain reached the anticathode causes the erosion of metal interface

    開關退化的主要原因是:開關體內的絲狀電流對開關晶元的損傷;以及電荷疇到達陽極時來不及放電而產生的電荷擁擠現象對開關電極接觸表面的損壞。
  3. The boundary of the charge region for a proton is not sharp like the surface of a billiard ball.

    質子電荷飛域的邊界並不象彈子球的表面那樣分明。
  4. First, a simple discussion for the mechanism about electrostatic atomization of the liquids has been given ; then the paper theoretically analyzed waving course, liquid drop producing course, and the liquid drop diffusing course in electrostatics atomization process., gave an analysis about the methods about carrying charges to the liquid drop, and analyzed that liquid with high electrical conductivity can be carried charges and atomized by electric field, while the isolated liquid with low electrical conductivity can be charged fully with the soakage electrode and inducing charge methods. at last the paper designed and configured the experimental equipment, conducted the atomization experiment to the three liquid medium - kerosene, emulsifier and alcohol under the same environment, handled the experimental results, then summarized the relationship between liquid electrostatic atomization effect and liquid surface tension, electronic conductivity and viscosity, along with the influence of voltage to electrostatic atomization and so on, found out the liquid atomization rule in high voltage electrostatic field

    首先，對液體介質的靜電霧化機理作了初步的探討，理論上分析了液體霧化過程中射流區、波紋區、霧滴區和霧滴擴散區;然後對液體荷電方法進行了研究分析，對于高電導率的液體，場致荷電和接觸荷電可以使其霧化，而對于電導率較低的絕緣液體，需用浸潤電極荷電和感應荷電方法使其充分帶電;最後，根據前面的研究分析，設計和組裝試驗裝置，在同一環境下對煤油、乳化劑、酒精三種不同液體介質進行高壓靜電霧化試驗，並對試驗結果進行分析處理，總結出液體靜電霧化與液體表面張力、電導率和粘度的關系及電壓對液體靜電霧化的影響等，得出高壓靜電場中液體霧化的一般規律。
  5. 4 the cleanout and the passivation of si surface was carried out by a two - step process to overcome the surface oxide layer and balance the charge between the substrate and epitaxy. by this way, the crystal quality and emission characteristic of zno thin films can be improved, which provide a way to resolve the native oxide layer of si substrate

    4 、通過用等離子體對硅襯底表面進行清洗和鈍化兩步處理，解決硅襯底表面的氧化層和界面電荷平衡問題，制備出了高質量的氧化鋅薄膜材料，找到了一條獲得了高質量的氧化鋅薄膜的新途徑。
  6. That is the premise of the bg / ha electrophoresis codeposition. the laws of the electrophoresis deposition of the bg and ha partic les were found by the study on each of their deposition under the different conditions. the electrophoresis codeposition of the bg and ha particles had been studied and the bg / ha graded coating, which is compact in the bottom layer and porous near the surface layer, had been prepared on the surface of the dental implant after the low temperature heat treatment ( about 740 ) and fast firing ( 50 - 80 / min, heat preservation time was 5 - 8min. )

    以bg微粉和ha微粉作為塗層原料，通過研究bg和ha微粉在非水介質中的分散情況和帶電特性，選擇冰醋酸為介質，使分散在其中的bg顆粒和ha顆粒表面均帶上正電荷，為電泳共沉積提供前提條件；通過對不同條件下bg 、 ha各自電泳沉積的研究，探索出了兩者電泳沉積的規律；通過對bg和ha在冰醋酸中電泳共沉積以及后續低溫（ 740左右）快燒（ 50 ? 80 min ，保溫5 ? 8min ）熱處理的研究，在鈦合金牙根種植體基體上成功制備出了底層緻密而表層多孔的bg ha梯度塗層。
  7. For electrodeposition by dc methods, the metals deposite uninterrupted and the particles were also embeded uninterrupted into the coatings ; for electrodeposition by pc method, the particles with biggish volume were desorbed from the coatings and returned to the electrolyte again owing to the presence of pulse interval ; for electrodeposition by prc method, the particles carried positive charges are much more easy to desorb from the coatings owing to the effecf of reverse pulse current combined with pulse interval, in addition, the reverse pulse current also could dissovle the metals, further accelerates the desorption of particles, thus the particles size embeded in the coatings by prc method is the least

    直流電沉積時，基質金屬的沉積連續進行，粒子在電極表面不間斷嵌入鍍層;單脈沖電沉積由於脈沖間歇的存在使得具有較大體積的粒子會脫附，重新回到溶液中;採用周期換向脈沖時，反向脈沖電流使表面荷正電的較大的粒子更易從電極表面脫附，同時，反向脈沖電流對基質金屬的溶解作用，也會促進粒子的脫附，因此鍍層中復合粒子尺寸最小。隨著鍍層中粒子復合量的增加，三種鍍層的晶粒都明顯細化，說明al _ 2o _ 3的存在阻止了晶粒的長大，提高了電沉積過程中晶核的形成速率。
  8. The results showed that the fluorescent intensity of dph decreased and the fluorescent intensity of mc540 increased under sound stimulation, which indicated that the vesicles got looser, the charge density of membrane surface and the plasmalemma hydrophobicity decreased but the membrane fluidity increased

    結果表明，聲波刺激使標記質膜的dph熒光偏振值降低、 mc540熒光強度增加。表明一定強度和頻率的聲波刺激使質膜變的疏鬆，膜表面電荷密度降低，疏水性降低，流動性增加。
  9. Electrostatic attraction will play a major role in the absorption of viruses to positively charged surfaces.

    靜電吸引在病毒吸附到帶正電荷的表面中起主要的作用。
  10. The oxide and reduce potential and the dopant concentration. the experiments of degradation methyl blue a1so showed that the photocatalytic activity could be greatly improved with vzos - loaded tio2, maybe that loading v2o5 would accelerate the electron captured and charge transferring, change the samp1e surface hydrophilic and absorption

    納米tio _ 2 - v _ 2o _ 5復合光催化劑對次甲基藍的降解實驗表明，復合v _ 2o _ 5后tio _ 2可以加速電子捕獲和電荷遷移速率，改變了樣品表面吸附親合力，使降解效率相比純tio _ 2有很大提高。
  11. The surface of the soil particle will have a negative charge.

    土粒表面會有負電荷。
  12. These surface charges partially nullify the effect of the charges on the metal plates.

    這些表面電荷部分地抵消金屬極板上電荷的作用。
  13. This dissipation process limits the maximum surface change density on a planar surface to 30μc/.

    這種耗散作用限制著物體平面的最大表面電荷密度為30c。
  14. It shows that the injection quantity and the difference of temperature distribute as a parabola which is at the same load, and the minimum of the parabola corresponds to the optimum quantity of injection ( g ). under the condition that the quantity of injected mass, the air speed and the heat quantity is respectively g, v and q, the research demonstrates that the pentium iv chip ' s temperature variation can be controlled under 40c and work normally when the wind speed overpass 1. 5m / s and the power dissipation of the chip is 60w. otherwise this paper calculates the flooding limit of thermosiphon with several different methods

    對其充灌量、散熱量、電子元件（ cpu模擬晶元）表面與環境溫度之差及通風、流速的影響進行了系統的測試，發現充液量與溫差的關系在負荷不變時呈拋物線分佈，其極小值點對應的充液量是最佳充液量g 。在充液量為g時，對風速v 、散熱量q進行的研究表明，當風速超過1 . 5m / s后，奔騰晶元在60w發熱條件下晶元溫度小於40 ，能滿足長期正常工作。
  15. Amnio acids could promote cac2o4 to crystallize on the ca2 + - rich ( 101 ) axis of com when negative charges were taken on their surfaces. trp, tyr and asp could promote orientation growth of ( 101 ) face of com more and more easily

    而當其表面帶負電荷時，則能促進com的（ i0l ）面生長，且caczo ;沿該面取向生長的程度隨色氨酸一酪氨酸~天冬氨酸而增強。
  16. During the high - voltage device design, the thick epitaxial layer ldmos which is compatible with current technology was researched. this device used piecewise vld and multiple region structure f reduce field layer. the using of the f reduce field layer effectively reduce the surface electric field of the device, shorten the length of its drift region, enlarge the choice of range of the ion implant dose of the p layer, and effectively restrain the disadvantageously affection on the breakdown voltage of the interface charge qss

    在高壓器件研究中對與現有工藝相兼容厚外延ldmos進行研究，該結構採用分段變摻雜多區p ~ -降場層，有效降低器件的表面電場，縮短器件的漂移區長度，增大p ~ -降場層注入劑量的選擇范圍，並有效地抑制界面電荷qss對器件耐壓的不利影響。
  17. In this paper, the theory of negatively charged surface states is used to investigate dynamic breakdown characteristics and the increase of gate - drain breakdown voltage as well as the reduction of saturated drain - source current after sulfur passivation. the measure which can improve the stability of sulfur passivation is proposed

    本論文通過對gaasmesfet擊穿機理和硫鈍化機理的研究，用負電荷表面態理論，解釋了gaasmesfet動態擊穿特性及硫鈍化后柵漏擊穿電壓增大、源漏飽和電流減小的機理，提出了改善硫鈍化穩定性的措施。
  18. Surface electromyography signal power spectrum during static load using two - dimensional mapping analysis

    靜態負荷表面肌電信號功率譜的二維地形圖分析
  19. Uses the high quality special molding manufacture, but becomes by the kneading board and the leg combination ; has the contour artisticly, firm is durable, does not need to maintain and so on the merit ; the kneading board and the inside lining stiffener spreads across, the bearing power optimizes, leg each strengthens processing, the average distributed load ; the surface uses galvanizes or the static electricity spurts models processing, is advantageous for cleanly, is not easy to pollute ; is suitable in various professions, the many kinds of situations, the use scope is extremely broad

    鋼制托盤：採用優質特種型材製造，由面板和支腿組合而成；具有外形美觀、堅固耐用、無須維護等優點；面板與內襯的加強筋縱橫交錯，承重能力更加優化，支腿各面均強化處理，平均分佈載荷；表面採用鍍鋅或靜電噴塑處理，便於清潔、不易污染；適用於各行業，多種場合，使用范圍極廣。
  20. Smd sectional specification : fixed low power surface mount resistors ; german version en 140400 : 2003

    分規范:低負荷表面安裝的固定電阻
分享友人
分享到 Line

分享到臉書