電荷轉移過程 的英文怎麼說

中文拼音 [diànhézhuǎnyíguòchéng]
電荷轉移過程 英文
charge transfer process
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 荷 : 荷名詞（蓮） lotus
  • 轉 : 轉構詞成分。
  • 移 : Ⅰ動詞1. （移動） move; remove; shift 2. （改變; 變動） change; alter Ⅱ名詞（姓氏） a surname
  • 過 : 過Ⅰ動詞[口語] （超越） go beyond the limit; undue; excessiveⅡ名詞（姓氏） a surname
  • 程 : 名詞1 （規章; 法式） rule; regulation 2 （進度; 程序） order; procedure 3 （路途; 一段路） journe...
  • 轉移 : 1 （改換位置） shift; transfer; divert 2 （改變） change; transform 3 [醫學] （擴散） metastasis;...
  • 過程 : process; procedure; transversion; plication; course
  1. Based on sndm technique, a method of local capacitance - voltage characteristic characterization of ferroelectric thin films was proposed. the effect of traps at oxide - semiconductor interface on metal - oxide - semiconductor structure capacitance - voltage curve was discussed, and the influence of coercive field to the capacitance - voltage characteristics of ferroelectric thin films was also discussed. the dynamic switching of ferroelectric domain in ca doping ( pb, la ) tio3 thin film was studied by sndm from the view of electricity

    利用sndm ，從純電學的角度觀察了plct薄膜中的電疇動態反轉過程，由電疇橫向擴張的移動速度的降低，發現了晶界在電疇反轉過程中對疇壁移動的阻擋作用;根據sndm和pfm的在垂直方向上的不同信息敏感深度，得到plct薄膜中電疇反轉過程中電疇是楔形疇;用pfm觀察同一電疇在去掉外加反轉電場后電疇的極化弛豫現象，結果表明空間電荷是發生極化弛豫的主要原因。
  2. The potential energy surface scan tells us that the lithium into or out of the graphene layers is the charge - discharge process of li - ion secondary batteries which concurs with the continuous charge transfer between lithium and the graphite layers which synchronizes with the shift of the graphite layer stacking sequences between the abab type and the relatively stable aaaa type

    計算結果顯示，鋰離子嵌入碳層的過程中同時伴隨著鋰和石墨間發生電荷連續轉移，同時石墨碳層堆積方式由aaaa型變為abab型，二者協同進行，最終嵌鋰石墨相對于鋰在石墨表面體系較穩定。
  3. The practical situations of system operations are considered in this paper. based on the enumeration of the cut sets for the load point interruption, load transition character, maintenance of devices, active failure mode and overload of transmission line are all discussed

    該方法考慮了系統運行的實際情況，列舉引起負荷點停電事件割集，還考慮了負荷點供電的轉移特性，網路元件的計劃檢修和主動性故障使評估過程更加合理和有效。
  4. Study on charge transferring in the adsorption process of co on cu surface

    表面吸附過程中電荷轉移的理論研究
  5. The charger - transferred processes of the charge - transferred states are displayed in order to understand their maximal two - photon absorption cross sections

    中心部分的特性有關。同時，我們還給出了分子電荷轉移態的電荷遷移過程。
  6. The disease in jaw surface will be drop the bite force ; the bite force in the patient who disease in temporal jaw joint descent obviously than normal person ; serious mistake in join deformity, the acute damage in the area arthritis can also drop the bite force evidently ; compare to normal children, wenneberg fund that the bite force lower and the duration of the biggest bite force shorter in the children who fall ill of the chronic arthritis ; the bite force also be used in appraise of the recovery condition in surgical operation 、 disorder in jaw arthritis and the serious bone offset in bite lopsided etc. some materials, it will be produce polarization phenomenon inside when suffered some force in certain direction, at the same time, it produce opposite electric charge in two of the surface ; and resume to the station of on - electrification when removed the outside force ; change the direction of the outside force, the polarity of the electric charge also be changed, this kind of phenomenon is called as “ piezoelectric effect ”

    本文設計了石英晶體壓電傳感器，以它作為傳感元件把咬合力信號轉變成電信號;利用ts5860型準靜態電荷放大器把傳感器的電荷信號轉變成電壓信號;選用usb7822數據採集卡，編寫該數據採集卡的驅動程序，採集該電壓信號並送到計算機里;編寫labview程序對該信號進行處理，得出咬合力值和咬合力曲線，並把測量結果以電子表格的形式保存，以便做進一步的分析和研究。通過對該測量儀的靜態標定、動態標定、溫度漂移標定以及實際測量試驗，證實了本測量儀具有較高的靈敏度、受動態力和溫度變化的影響比較小、能實時地顯示咬合力曲線和較準確地顯示咬合力值，滿足了咬合力測量的要求。
  7. The practical situations of system operations are considered in this paper. based on the enumeration of the cut sets for the load point interruption, load transition character, maintenance of devices, active failure mode and overload of transmission line are all discussed. the evaluation is more realistic and effective

    該方法充分考慮了系統運行的實際情況，在列舉引起負荷點供電停止事件割集的基礎上還考慮了負荷點供電的轉移特性，網路元件的計劃檢修和活動性故障，以及系統運行的過負荷約束等諸多情況，使評估過程更加合理和有效。
  8. The sequence to solve a overcurrent line of a feeder is : load transference to another feeder, reduction the reactive power and finally increase the section of the cable

    規劃一個饋線線路（設備）的一條過流主幹路的順序是：了解負荷轉移至另一個饋線線路（設備）過程中，將無功功率降低最終就要增加電纜。
分享友人
分享到 Line

分享到臉書