靈敏度測試 的英文怎麼說

中文拼音 [língmǐndùcèshì]
靈敏度測試 英文
sensitivity test
  • 靈 : Ⅰ形容詞1 （靈活; 靈巧） quick; clever; bright 2 （靈驗） effective Ⅱ名詞1 （精神; 靈魂） spirit; ...
  • 敏 : Ⅰ形容詞（靈敏;敏捷） quick; agile; smart; nimble Ⅱ名詞（姓氏） a surname
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 靈敏度 : [電子學] sensitivity; response rate; sensibility; sensitiveness; response; susceptibility; suscep...
  • 靈敏 : sensitive; keen; quick; agile; acute
  • 測試 : test; testing; checkout; measurement
  1. We found that tio2 thin films are a amorphism when they are not annealed ; they are anatase when annealed at 300 c ; rutile occured be anneled at 700 ; ti02 thin films are transformed into rutile completely when be anneled at 1100. oxygen - sensing properties of tio2 thin films were analysised, and we found the variation law of sensitivity with the partial pressure of o2 and temperatures. sensitivity increases with po2 / ( po2 + pn2 ) at a constant temperature. the higher working temperature is, the slower sensitivity increasing with po2 / ( po2 + pn2 ) is

    對tio _ 2薄膜氧敏器件特性進行了分析，發現靈敏度隨工作溫度和氧分壓變化的規律， 400以上時，在一定工作溫度下，隨氧分壓的增加，靈敏度逐漸升高；工作溫度越高，隨p _ （ o _ 2 ） （ p _ （ o _ 2 ） + p _ （ n _ 2 ） ）的增加，靈敏度增加越緩慢，在400下靈敏度隨氧分壓增加最快；在我們所測試的工作溫度點中， 400時具有最高的靈敏度，相對於他人的工作此溫度是比較低的。
  2. For this reason, considerable testing is done on such devices as centrifuges to determine linearity of sensitivity to acceleration.

    為此，大量的測試要在離心機裝置上進行，以確定對加速度靈敏度的線性度。
  3. During the calibration, a regress - analyse method is used to get the weight of the different channel based on equational coefficient, the weight represents the sensitivity of each channel

    為了提高測量的可靠性和精確性，對9通道數據同時採集，在測試標定時採用回歸分析方法，根據靈敏度得到不同通道的權值。
  4. With the aid of baffle movement, a technique named masking pretreatment and the method of vacuum deposition have been used to fabricate the ag - o - cs photoemissive thin films with internal field - assisted structure for the first time. the internal field - assisted photoemission characteristics of ag - o - cs thin films show that the photoelectric sensitivity is increased when the internal electric field is applied to the thin films, which indicates that the electric field has been effectively provided to the thin films by the above - mentioned internal field - assisted structure. such an enhanced photoemission is attributed to the variations in energy - band structure of ag - o - cs thin films, and which are considered to induce the lower - energy electrons to participate in the photoemission

    通過掩膜預處理和擋板轉移技術的配合，利用真空沉積方法首次制備了內場助結構ag - o - cs光電發射薄膜。 ag - o - cs薄膜內場助光電發射特性測試結果表明，該方法能夠有效地實現ag - o - cs薄膜體內電場的加載與表面電極的引出，薄膜光電靈敏度隨內場偏壓的增大而上升。 ag - o - cs薄膜在內場作用下的光電發射增強現象與薄膜體內能帶結構變化低能電子參與光電發射等物理機制有關。
  5. The electromagnetic interference tolerance is discussed in this paper, the radio spectrum assignment and the sensitivity of interference measurement equipment are described

    摘要討論了日像儀的干擾容限，列出了干擾源分佈，估算出干擾測試儀靈敏度。
  6. After reference solution has been formulated and sensitivity has been adjusted and tested according to above mentioned method ( 3 ), take appropriate amount of test sample solution and reference solution, blend samples separately ; unless otherwise specified, recording time of the former should be 2 times of retention time of chromatographic peak of main component, measure peak area of each impurity on the chromatograph chart of test sample solution, and compare with peak area of main components of reference solution, then calculate content of each impurity accordingly

    同上述（ 3 ）法配製對照溶液並調節檢測靈敏度后，取供試品溶液和對照溶液適且，分別迸樣，前者的記錄時間，除另有規定外，應為主成分色譜峰保留時間的2倍，測量供試品溶液色譜圖上各雜質的峰面積並與對照溶液主成分的峰面積比較，計算雜質含量。
  7. However, one of the most serious impediments to wider use and improve precision of psi is its sensitivity to external vibration with the consequence that psi has rarely been used in a manufacturing in - situ and some special situations, such as that the optical path is very long or the detected unit is very large

    通過嚴格控制環境條件（溫度、氣流、振動等） ，其理論光程差（位相）的最小解析度可以達到nm的數量級。然而，由於干涉計量測試靈敏度高、精度高，對外界振動非常敏感，使它的應用范圍受到限制。
  8. 4. based on the sensitivity analysis by a step - perturbation test for several most important parameters, the effective interfacial area is found the most sensitive parameter, which affects the separation efficiency in structured packing column significantly

    4 .基於階躍攝動測試，對非平衡模型主要參數進行了靈敏度分析，結果表明模型中的有效相接觸面積的靈敏度最大。
  9. New tracers and their analysis methods, new developments on the interpretation of tracer response and new concepts & methods contributed on tracer methodology. since 1980s, interwell radiotracer test has gained rapid development. the main reasons are radiotracers has the advancetages of high sensitivity, wide selectivity and no chemical contamination on the reservoir

    自上世紀八十年代以來，放射性井間示蹤測試在國際上得到了很大的發展，主要是因為放射性示蹤劑具有種類多、檢測靈敏度高、並且對油藏不產生化學污染等優點。
  10. Methods for calibration of vibration and shock pick - ups. testing of transient temperature sensitivity

    振動與沖擊傳感器的校準方法瞬變溫度靈敏度測試法
  11. The minimum requirement for sensitivity shall be such that a succession of not less than 20 breakdowns of the spark gap shall cause the fault indicator to register neither more nor less than one cunt per breakdown when the spark gap is open and is of the length shown above, with the current limiting impedance in series with the gap

    在最底靈敏度測試的時候，應先接入上述要求的人工擊穿裝置，啟動人工擊穿裝置，使金屬板與金屬針間的火花間隙被連續擊穿20次，要求火花試驗機的擊穿計數器應記錄20次，對每次擊穿都應準確無誤地計數，不應多計也不應少計。
  12. The minimum requirement for sensitivity shall be such that a succession of not less than 20 breakdowns of the spark gap shall cause the fault indicator to register neither more nor less than one count per breakdown when the spark gap is open and of the length shown above, with the current limiting impedance in series with the gap

    在最底靈敏度測試的時候，應先接入上述要求的人工擊穿裝置， ，啟動人工擊穿裝置，使金屬板與金屬針間的火花間隙被連續擊穿20次，要求火花試驗機的擊穿計數器應記錄20次，對每次擊穿都應準確無誤地計數，不應多計也不應少計。
  13. Semiconductor devices - mechanical and climatic test methods - part 27 : electrostatic discharge sensitivity testing ; machine model

    半導體器件.機械和氣候試驗方法.第27部分:靜電放電靈敏度測試.機器模型
  14. Methods for the calibration of vibration and shock pick - ups. testing of acoustic sensitivity

    振動與沖擊傳感器的校準方法聲靈敏度測試
  15. Methods for the calibration of vibration and shock pick - ups. testing of base strain sensitivity

    振動與沖擊傳感器的校準方法基座應變靈敏度測試
  16. Methods for the calibration of vibration and shock pick - ups. testing of transverse shock sensitivity

    振動與沖擊傳感器的校準方法橫向沖擊靈敏度測試
  17. Methods for the calibration of vibration and shock pick - ups testing of transverse vibration sensitivity

    振動與沖擊傳感器的校準方法橫向振動靈敏度測試
  18. Single parameter provides little message and sometimes it is difficult to make an exact evaluate. in this paper, by testing the sensitivity of the system model, three parameters are selected as sensitive parameters, and based on simulation result of the system model, three dimension failure surface is used for alarm criterion and arithmetic of the alarm is carried out

    單一參數提供的信息較少，有時難以作出準確的評價，本文通過對系統模型的靈敏度測試，選取三個參數作為靈敏參數，根據系統模型的模擬結果，以三維失效面作為報警判據，並實現了報警演算法。
  19. The sensitivities testing of system model includes changing parameters and changing initial value. by testing the model of system dynamics of the fault, the change of the system behavior indicates that which parameters are sensitive to the system model, accordingly, these parameters can be used for sensitive parameters of the fault alarm

    系統模型的靈敏度測試包括更改參數和改變初始值的測試，對故障的系統動力學模型進行靈敏度測試，通過行為的變化可說明系統模型對哪些參數的變化是敏感的，從而將這些參數作為事故報警的靈敏參數。
  20. Standard test methods for measurement of electrical performance and spectral response of nonconcentrator multijunction photovoltaic cells and modules

    無聚集器多結光電池和組件的電性能和光譜靈敏度測量的標準試驗方法
分享友人
分享到 Line

分享到臉書