靜應力 的英文怎麼說

中文拼音 [jìngyīnglì]
靜應力 英文
static stress; statical stress; steady stress
  • 靜 : Ⅰ形容詞1. （安定不動; 平靜） still; calm; motionless 2. （沒有聲響; 清靜） silent; quiet Ⅱ名詞（姓氏） a surname
  • 應 : 應動詞1 （回答） answer; respond to; echo 2 （滿足要求） comply with; grant 3 （順應; 適應） suit...
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  1. The powder was pressed through molding and cold isostatic pressure, which increased the density and decreased the uneven distribution of stress inside the briquet to make the ceramic briquet equally compact

    粉料採取模壓和冷等靜壓相結合的方法壓制，增大了坯體內部的密度並減少了應力的分佈不均，得到均勻緻密的陶瓷坯體。
  2. Considering to the continuous rigid - frame bridge construction characteristic, putting forward the idea of reverse to optimize prestressed steel. according to different construction phases, the paper gets the formual of the cantalever phase, join two section of a bridge phase and the vertical prestressed steel, and works out corresponding program

    考慮大跨徑預應力混凝土連續（剛構）橋施工的特點，提出了基於倒裝方法的預應力靜定束、合龍束以及豎向束的優化設計理論，並編制了相應的計算程序。
  3. On the base of the analysis of the static fbd under diametric compression, numerical analysis and compare are performed on the dynamic stress field of the brazilian disk and fbd used in the testing tensile strength under shpb

    在對靜態平臺壓縮巴西圓盤（ fbd ）進行的數值分析的基礎上，本文分析了shpb動態劈裂拉伸實驗中巴西圓盤和平臺巴西圓盤的動態應力場，並對結果進行了比較。
  4. We possess accurate processing equipments, such as hydrogen making equipment, reducing furnace, isocratic press machine, 500t capacity hydraulic machine, intermediate frequency induction furnace, high or low temperature fritting durance and forging equipment, which forms whole production line

    公司擁有制氫裝置、系列制粉還原爐、等靜壓力機、 500噸油壓機、中頻感應爐、高低溫燒結爐、鍛造設備及精密加工設備。
  5. Objective to investigate the effects of fluid shear stress on il - 8 gene in human umbilical vein endothelial cells ( huvecs ) and the roles of time course of low shear stress and intensity of fluid shear stress using lightcycler ? system ; to investigate the gene expression profiles in huvecs exposed on low shear stress ( 4. 20 dyne / cm2, 2 h ) and incubated by 17 p - estradiol ( 10 - 7 m ) + low shear stress ( 4. 20 dyne / cm2, 2 h ) using the cdna microarray approach. methods endothelial cells were isolated from human umbilical cord veins by collagenase treatment as described by jaffe and modified

    目的探討人臍靜脈內皮細胞（ humanumbilicalveinendothelialcells ， huvecs ）在流體切應力作用下il - 8基因的誘導表達以及切應力的作用時間和作用強度對il - 8基因表達影響的變化規律；利用表達譜基因晶元技術研究內皮細胞在低切應力（ 4 . 20dyne cm ~ 2 ， 2h ）作用下其切應力相關基因的表達情況以及生理濃度（ 10 ~ （ - 7 ）的17 -雌二醇孵育內皮細胞48h ，再經同樣條件的切應力處理后對內皮細胞切應力相關基因表達的可能影響。
  6. Based on total stress index of property of statics and dynamics of dam body and dam base materials which obtained from test, utilizing duncan - chang hyperbola model and equipollence linearity model to analysis static state and dynamic stress state affected by earthquake of hada mountain dam body and dam base

    根據試驗得到的壩體和壩基材料的靜動力學性質的總應力指標，計算中採用duncan ? chang雙曲線模型和等效線性模型，分析了哈達山壩體和壩基的靜應力狀態以及它們在地震作用下的動應力狀態。
  7. Utilizing pseudo - static method theory, calculated the safety factor for the dam slope, give, a primary conclusion. utilizing static finite element method based on duncan - chang hyperhola modelfound the static stress riele, make the foundation for hynamical finite element analysis. utilizing dynamical finite element method based on equipollence linearity model, found the dynamical stress field and the acceleration field, make the foundation for calculated the safety factor of the dam slop with finite element method

    運用擬靜力法的基本原理，對滿拉堆石壩的壩坡穩定進行了分析研究，得出了初步結論；採用duncan - chang雙曲線模型，用計算土石壩應力及變形的靜力有限元程序，對滿拉堆石壩進行了靜力有限元分析，得到了壩體的靜應力場分佈，為動力有限元計算打下基礎。
  8. In this paper, 3d nonlinear finite element model is used to analyze the stability of side slope of baise hydraulic power plant ' s tail channel, and the result to be given for consulting

    本文主要應用三維非線性有限元對百色水電站尾水渠高邊坡進行靜、動力穩定性分析，並對結果進行分析，給出供工程設計的參考意見。
  9. The photoelastic experiment study of gear ' s static stress

    齒輪靜態應力的光彈性實驗研究
  10. The dynamic tensile stresses of earthquake may balance or exceed to the precompression stresses due to static watef, this may arouse opening of joints along the normal direction. if the altemate actions of earthquake join, the joints may behave gradual opening and closing

    由於地震作用時的動拉應力將抵消並超過靜載作用下的壓應力，導致橫縫面沿法向張開，加上地震的交變作用，橫縫可能會呈現反復的「漸開漸合」現象。
  11. Static and dynamic behavior of three - span continuous prestressed concrete rigid framed arch bridges without spandrel members

    三跨連續無腹桿預應力混凝土剛架拱橋的靜動力特性
  12. Secondly, the static stress and strain characteristic of polymer - geogrid reinforced earth is summarized, the pulling stress distributing of the reinforced material in the earth walls, the interface characteristeric between the reinforced material and earth and the friction stress distributing between the reinforced material and earth are analysed

    然後，總結了塑料土工格柵加筋土靜應力應變特性的一般理論，分析了塑料土工格柵筋材在擋墻中的拉應力分佈和塑料土工格柵與土的界面特性以及筋土間摩擦應力的分佈。
  13. And the results of the static stress were applied on the analysis of seismic reaction

    隨后把計算得到的靜應力狀西安理工大學工程碩士學位論文態用於地震反應分析的初始應力場中。
  14. The result indicates that the maximum stress on the runner is mainly in proportion to the turbine output

    結果表明在大部分工況下該轉輪葉片最大靜應力基本上與水輪機功率成線性關系。
  15. 2 the maximum stress and the maximum stress location and the distribution of the stress are attained through the static analysis of building up finite element module

    2 、對建立的有限元模型進行靜強度分析，得到各個工況該泵車的最大靜應力值和最大靜應力位置及各構件的靜應力分佈。
  16. In this paper, spindle fem computation model taking solid as basic unit is established. based on this model, firstly, static stress is analyzed and the stress distribution of spindle under various static woking condition is attained ; secondly, transient analysis is carried out

    本文建立了以實體單元為基本單元的大軸有限元計算模型，在此模型基礎上首先進行靜應力分析，得到各靜工況下的應力分佈；隨后進行瞬態的沖擊載荷分析。
  17. Data processing software is designed for tbs - 2000 strain measuring system in the classical virtual instruments engineering workbench ; it is applied to process the data which are acquired in the way of dynamic stress analysis, statistic stress analysis and proper frequency analysis

    利用虛擬儀器的典型開發平臺labview針對tbs ? 2000應變測試系統開發了數據處理軟體；利用該數據處理軟體對測試所得的數據進行了動、靜應力分析和固有頻率分析。
  18. In this paper, on the basis of the numerical analysis with the concept of equivalent soil mass with reinforcement and shake table model test, the calculation of high loess embankment with geogrid - reinforcement in highway is carried out under static loading, and the dynamic response of high reinforced sand - gravel embankment with grogrid - reinforcement in highway is tested under earthquake. the behaviors of loess embankment are indicated as the following : ? he stress and deformation varies with reinforcement design conditions and foundation types

    本文通過將土工合成材料與土體視為加筋等效土體的數值計算方法和振動臺模型試驗，以加筋黃土高路堤和豎直擋板加筋砂礫土高路堤為研究對象，計算分析了不同堤基上不同加筋設計條件下黃土高路堤的靜應力及變形變化規律，試驗研究了不同加筋條件下砂礫土高路堤的動力反應特性。
  19. Taking the earth - rock dams with straight clay core constructed on thick moraine cover foundation and directly built on bed - rocks with the same sizes and the same materials for example, two - dimensional dynamic fem programme is used to contrast and analyze the static stress distribution and dynamic response difference of two types of high earth - rock dams in the intensive earthquake zones

    摘要以相同尺度和相同材料的建造在深厚覆蓋層上直心墻土石壩和直接建設在基巖上的直心墻土石壩為例，採用二維動力有限元程序對比和分析了強震區兩種高土石壩的靜應力分佈和動力反應的差異。
  20. Statistic stress dangerous positions of bump on different working situations are got by generally analyzing all of the data. the working frequencies on different working situations are gained during the course of dynamic stress analysis, at the same time they are compared with the results of the bump hydraulic system measuring experiment, they are quietly consistent with each other. the main aim at analysis of the bump inherent frequency is to get its first frequency, which is used to find out the reason why the bump vibrates so serious

    在進行靜應力分析中，計算出該型泵車所測工況所有測點的靜應力，通過對所有數據綜合分析之後，得出該型泵車在工作時不同工況的靜應力危險部位；在進行動應力分析過程中，分別求出不同工況的工作頻率，並與該泵車液壓系統測試實驗分析結果進行比較，二者結果比較吻合；對泵車進行固有頻率分析的主要目的是求得該型泵車的一階固有頻率，以尋求該泵車振動較大的原因。
分享友人
分享到 Line

分享到臉書