非電度纖維 的英文怎麼說

中文拼音 [fēidiànxiānwéi]
非電度纖維 英文
electroless plated fiber
  • : Ⅰ名詞1 (錯誤) mistake; wrong; errors 2 (指非洲) short for africa 3 (姓氏) a surname Ⅱ動詞1 ...
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : 度動詞[書面語] (推測; 估計) surmise; estimate
  • : 纖形容詞(細小) fine; minute
  • : Ⅰ動詞1 (連接) tie up; hold together; link 2 (保持; 保全) maintain; safeguard; preserve; keep ...
  • 纖維 : fibre; staple; filamentary
  1. We select ni / cr alloy resistor as element together with ceramic embedding hearth ; select small flat - and - disc heat - even hubby ceramic sample holder, select ni / cr & ni / si thermoelectric couple ( type k ) as thermoscope with threads 0. 5 mm in diameter which is installed in the middle of the holders symmetrically ; select aluminum silicate fire - retardant fiber as materials for heat preservation ; design some hardware, for example temperature controller & transporter, signal amplifier etc ; design controlling curve to heat stove ; and introduce the method of least squares nonlinear regression and subsection function to deal with data. in order to obtain the reasonable operation conditions and operation curve, we have also done many theory analysis and experiment discussions

    通過理論和試驗探討,選用鎳鉻合金阻絲作為加熱元件,配以陶瓷質埋入式爐膛;選用陶瓷質小尺寸扁平?圓盤均熱塊體型樣品支持器;選用0 . 5mm絲徑鎳鉻?鎳硅熱偶( k )作為測溫元件;熱偶對稱安置在樣品支持器容器的中部;選用硅酸鋁耐火作保溫材料;合理選用和設計了溫控制器、溫變送器、信號放大路等硬體;採用升溫曲線來控制爐膛供熱過程;採用最小二乘法線性回歸與分段函數相結合的曲線模擬方法,進行圖形處理。
  2. On the base of studying imaging theory of lens, the imaging theory of laser confocal scanning microscopy was analyzed in detail in this paper, and the advancement of that the optical fiber was applied to the system was described ; on the base of completed the demonstration for whole project, the experiment scheme was designed ; the relationship between the main parameters of key devices and the resolution was deduced, and the requirements of coupling efficiency and vignetting effects to optical system was analyzed ; the design of optical system and the planar scanning controlling circuit was completed ; a new method was put forward to resolved the inherent non - liner scanning problem of the galvanometer scanner by using software liner controlling in circuit design, and the perfect planar scanning was realized ; at last the low noise, high multiple and non - distortion amplify circuit of photoelectric detector was completed

    本文在透鏡成像理論的基礎上,系統、深入地分析了共焦掃描顯微成像的機理,論述了應用單模光的激光共焦掃描顯微成像系統的優點;進行了總體方案的論證,並設計確定了單模光激光共焦掃描顯微成像系統的總體方案;從理論上推導分析了解析要求與試驗系統中相關器件主要參數之間的關系,分析了系統耦合效率和漸暈現象對光學系統的設計要求;完成了方案中光學系統和二掃描控制路的設計,並在路設計中採用了用軟體解決檢流計式光學掃描器(振鏡)線性問題的新方法,能夠實現較為理想的二模擬掃描;完成了高增益、低噪聲和低失真的探測接收系統的設計和調試。
  3. It has great influence of product ' s performance of fiber - reinforced plastic, such as thickness, intension, gas closeness and cutting intensity etc. the higher resin viscosity is, the poorer its ability of moving and the worse proportioned of resin on the surface of raw and processed materials

    測量在石油、化工、紡織、國防、機械和力等行業應用常廣泛。它對增強塑料製品的性能的影響很大,主要表現在制品的厚、強、氣密性和剪切強等。
  4. The pp / pa66 / gpp / eg combined in - situ and nano electrically conductive composites with ? c of 4 wt %, which was lower than that ( ? c = 6wt % ) of composites without pa66 and simil

    降低;同時藉助pa66對pp基體的增強和增韌作用,使組合復合導材料的力學強和沖擊韌性高於組合復合導材料。
分享友人