顆粒層增厚 的英文怎麼說
中文拼音 [kēlìcéngzēnghòu]
顆粒層增厚
英文
hypergranulosis-
The results show that, composite could be fabricated on the complicated surface by means of sodium silicate sand mold combination with vacuum infiltration process. when the substrate was 10 mm, composite layers reached 3 mm to 5 mm in thickness with high strength interface and less casting defect. microstructures of grey cast iron and low chromium cast iron matrix composites with various volume fraction has been analyzed
結果表明:用水玻璃砂型(芯)加負壓鑄滲的工藝能夠實現復雜表面(曲面)顆粒增強復合材料的制備,澆注方式簡單可靠,基材厚度在10mm時,復合層厚度能達到3 5mm ,且復合層鑄造缺陷少,復合效果好,界面緻密而且結合強度高。As annealing temperature is 400, the phase of fexsy is greigite ( fe3s4 ) the fexsy particles cover the porous film of tio2. the average size of fexsy particles range from 5000nm to 20nm as the concentration of the starting solution decreasing. after five times of coating - annealing process, fexsy particles form aggregate in size of 10 m
鐵硫化合物顆粒覆蓋在多孔tio _ 2基底上,顆粒尺寸隨著初始溶液濃度減小從幾個微米減小到十幾個納米,隨著塗膜厚度、退火時間增加,鐵硫化合物的形貌按顆粒狀島狀層狀變化。It ' s indicated that the zeta potential and total interaction energy of the colloidal particles are both at a maximum when the nitric acid concentration is 0. 22mol / l for the alumina sols with a mol ratio of 1 : 50 between asb and h2o,
結果表明,膠體顆粒的雙電層厚度隨硝酸的濃度的增加不斷減小,對異丁醇鋁與水的摩爾比為1 : 50系溶膠,硝酸濃度為0 . 22mol l時膠體顆粒的zeta電位和作用位能最大。But when other factors are fixed, the thermal conductivity of composite will decrease with the increase of the propotion
隨著界面層的厚度和顆粒尺寸之比的增加,復合材料的熱導率減小。分享友人