飽和蒸汽表 的英文怎麼說

中文拼音 [bǎohézhēngqìbiǎo]
飽和蒸汽表 英文
saturation steam table
  • 飽 : Ⅰ形容詞1 （吃足） have eaten one s fill; be full 2 （充實; 飽滿） full; plump Ⅱ副詞（充足; 充分）...
  • 和 : 和動詞（在粉狀物中加液體攪拌或揉弄使有黏性） mix （powder） with water, etc. : 和點兒灰泥 prepare some plaster
  • 蒸 : Ⅰ動詞1. （蒸發） evaporate2. （利用水蒸氣的熱力使食物熟或熱） steam Ⅱ名詞[中醫] （將藥物隔水蒸熟） steaming
  • 汽 : 名詞1. （由液體或某些固體變成的氣體） vapour2. （水蒸氣） steam
  • 表 : Ⅰ名詞1 （外面;外表） outside; surface; external 2 （中表親戚） the relationship between the child...
  • 飽和 : （在一定溫度壓力下, 溶液可含溶質的量達到最大限度, 不能再溶解, 泛指事物達到最高限度） saturation; saturated
  • 蒸汽 : vapour; reek; breath; steam蒸汽採暖 steam heating; 蒸汽錘 [機械工程] steam hammer; 蒸汽打樁鍾 ste...
  1. The results show that in 185 saturated steam, pyrite tailing doesn ' t hydrate alone, but is converted into calcium silicate hydrate when mixed with lime

    結果表明： 185飽和蒸汽壓下，硫鐵尾礦不具有水熱水化的能力，硫鐵尾礦與石灰可以形成具有膠凝性能的水化產物。
  2. Abstract : based on the analysis of the mathematics models of saturation steam density and superheat steam density the paper states that the deviation of the detection on temperature highly affects the accuracy of intelligent flow totalizer. especially for saturation steam ， the accuracy of the temperature detection circuit shall be designed higher than the accuracy of the instrument. thus a temperature detection circuit based on ratio method with high accuracy is introduced

    文摘:在分析飽和蒸汽和過熱蒸汽密度的數學模型的基礎上指出，溫度檢測的偏差對智能流量積算儀的精度影響極大，尤其是飽和蒸汽，測溫電路的精度應設計為遠高於儀表的精度，同時引入一種基於比率法的高精度測溫電路。
  3. On the saturate concentration, the moisture density in the micro - holes was 100 times larger than the vapor density in the standard state, but only 8 % of liquid water. the water inside the plastic material was in a special liquid state. the delamination and the delamination recovery were observed by c - sam

    當水汽濃度達到飽和時，在塑封材料中可以被水分子進入的有效體積內，實驗條件下的水汽密度為標準狀態下水蒸氣密度的100倍，為液態水密度的8 ，表明在塑封材料中的水分子以一種特殊的液態水形態存在。
  4. Through analyzing the effect of temperature and nitrogen on crude oil viscosity the influences of different nitrogen injection volume and injection modes on steam displacement are contrasted, the mechanism of nitrogen - assisted steam stimulation is clarified, which includes : heat carrying capacity is raised, the saturation of remaining oil is reduced after nitrogen - assisted injection is made ; crude oil flow is enhanced because of nitrogen compression and dispersion and the change of oil flow shape ; water back - production rate is improved by expanding the steam sweep volume and compensating in - situ energy ; steam distillation effect is enhanced

    通過分析溫度、氮氣對原油粘度的影響，對比不同注氮量、不同注入方式等對蒸汽驅油效果的影響，弄清了氮氣輔助蒸汽增產的機理主要表現在：氮氣輔助后增加攜熱能力，降低殘余油飽和度，氮氣的壓縮膨脹作用分散和改變了原油流動形態，增強了原油流動性；擴大蒸汽的波及體積，補充地層能量，提高回採水率，強化蒸汽蒸餾效應。
  5. In order to size a stop - check the technical information needed is saturated steam gage pressure in pounds per square inch and actual required steam volume flow in pounds per hour

    為了確定正確的截止止回閥的通徑，需要下列有關的技術參數，飽和蒸汽表壓（磅/平方英寸） ，和實際所需的正氣流量（磅/小時） 。
  6. Saturation vapour pressure of internal combustion engine under actual operation conditions is expressed as the multinomial by using least square method, which facilitates the calculation of rectifying coefficient of engine output and fuel consumption as well as the fabrication of computer programme for such calculations

    摘要介紹了用最小二乘法擬合方法，將內燃機現場環境狀況下飽和蒸汽壓表示為多項式形式，為計算功率和燃油消耗率校正系數，並為此而編制計算機程序提供方便。
  7. The paper is on how to set up lab platform of vapour spewing to uppercooling water surface to coagulate directly and to observe and analyse which vapour coagulate on the water surface, the results enable people to know the security system of nuclear power. the range of the pressure parameters of prz is from 0. 2mpa to 0. 6mpa, and the range of the initial temperature parameters of cmt is from 23. 5 to 78. 5, all of the testing points are 30 and there are fifty thousand testing data. many results of vapour spewing to uppercooling water surface vertically to coagulate can get. for example : coagulating can make the water of cmt surge forcefully when vapour spews to uppercooling water surface, too many vapour - bubbles come into being and strike the water of cmt owing to rupture continually, all these will strengthen the surge because of the vapour pressure of cmt

    實驗中prz飽和蒸汽壓力變化范圍為: 0 . 2mpa - 0 . 6mpa ， cmt中水初始溫度變化范圍: 23 . 5 - 78 . 5 ，實驗中測試工況30個左右，實驗測試數據50萬余個，得出了很多與非能動安全系統相關的蒸汽垂直噴向過冷水表面凝結時的結論：蒸汽垂直噴入過冷水表面凝結時會造成cmt中液面的強烈波動和振蕩，產生大量蒸汽汽泡，汽泡不斷破裂對cmt中液體帶來很大沖擊，勢必引起cmt中液體的振蕩，造成cmt汽空間汽壓不均勻，加強cmt液體的振蕩和波動。
  8. There will be a hot water layer in the water of cmt when vapour spews to uppercooling water surface vertically and coagulates directly. the higher of the vapour pressure of prz and the initial water temperature of cmt are, the deeper the hot water layer is. and obtaining the experience formula of the hot water layer is as follows : the condensation coefficient is high when vapour coagulate at first, then it will lessen with the process of coagulation, the higher of the vapour pressure of prz and the initial water temperature of cmt are, the higher of condensation coefficient is

    蒸汽垂直噴入過冷水表面凝結時， cmt中水有明顯熱分層現象， prz中飽和蒸汽壓力越高， cmt中水初始溫度越高，熱分層厚度越大，熱分層厚度的經驗關聯式為：凝結剛開始時，凝結換熱系數非常大， ，隨著凝結的進行，凝結換熱系數越來越小， prz中飽和蒸汽壓力越高， cmt中水初始溫度越高，凝結換熱系數越大。
  9. Pressures, water level, surface and axial temperatures and total clotted liquid were obtained and analyzed. by experimental phenomenon, the condensation process was divided into two phases : steam supply limit and condensation limit. the interfacial heat transfer coefficient in steam supply limit phase was calculated

    通過實驗，觀察飽和蒸汽在cmt內的冷凝現象，獲取cmt內壓力、水位變化、表面、軸向溫度分佈和累積冷凝量等重要實驗數據，對實驗所得的數據進行分析。
分享友人
分享到 Line

分享到臉書