驅替模擬 的英文怎麼說

中文拼音 [qūtìmónǐ]
驅替模擬 英文
displacement simulation
  • 驅 : 動詞1. （趕） drive （a horse, car, etc. ） 2. （快跑） run quickly 3. （趕走） expel; disperse
  • 替 : Ⅰ動詞1 （代替） replace; substitute for; supply [take] the place of 2 [書面語] （衰敗） decline Ⅱ...
  • 模 : 模名詞1. （模子） mould; pattern; matrix 2. （姓氏） a surname
  • 擬 : 動詞1. （設計; 起草） draw up; draft 2. （打算; 想要） intend; plan 3. （模仿） imitate
  • 模擬 : imitate; simulate; analog; analogy; imitation; simulation模擬艙 boilerplate; 模擬電路 [電學] circ...
  1. The physical simulation test for depletion drive in carbonate reservoir in lunnan buried hill is conducted according to the real reservoir conditions of modeling

    摘要全面模擬油藏實際條件，對輪南古潛山碳酸鹽巖油藏進行了衰竭驅替物理模擬實驗。
  2. According to the analyses of the research results about the feasibility of 4 - d seismic and the successful 4 - d seismic cases of foreign companies, the author put forward the suggestions for 4 - d seismic pilot area selection ; briefly analyzed the influential function of producing way on the seismic response ; utilized theory calculation, coring data analyses, and reservoir numerical simulation to define the fluid substitution effects on the p - wave velocity. through long time water driven to the reservoir, some of the properties and the log curves have changed, the author tried to find the variation rule of the reservoir and its effects on seismic velocity. the " blind point " in 4 - d seismic feasibility study both in china and overseas was found, that is the lack of consideration of the influence of physical property variation by long time water driven on the seismic response

    在深入分析國外四維地震可行性研究成果和成功實例的基礎上，提出了有利於水驅四維地震成功的工區優選條件；簡要剖析了各種開采方式及其對地震特性的影響；利用理論計算、巖心分析、油藏數值模擬三種方法確定了流體替代對縱波速度的影響；通過對長期水驅造成的物性參數、測井曲線以及油藏溫度和壓力變化規律的總結，分析了這些變化對地震速度的影響，指出了目前國內外水驅四維地震可行性研究中存在的盲區?沒有充分考慮長期注水造成的物性、溫度和壓力變化對地震響應的影響，完善了水驅四維地震可行性研究的內容；在考慮了這些變化因素后，高29斷塊水驅四維地震可行性研究結果表明：四維地震監測注水前沿可能要比監測油藏變化容易的多；以四維地震巖石物理可行性研究結果為基礎，提出了五個有助於突出四維地震造成的微小差異的途徑，為今後水驅四維地震研究指明了方向。
  3. The domestic artificial map cracking ( cavity ) core is first presented, which is accordant with prerequisites similar to the real permeability and the percolation spatial configuration of the reservoir, and successfully applied to the long - core test under the conditions of high pressure, high temperature, high salinity and high viscosity available

    在國內首次人工製造出了同時符合油藏儲滲層滲流空間形態要求和滲透率要求的網狀裂縫（洞）巖心，並在四高，即壓力高、溫度高、礦化度高、粘度高的模擬油藏實際條件下成功應用人工製造網狀縫巖心完成了輪古地區長巖心驅替實驗。
  4. On the basis of 3d modeling and virtual prototyping technology and energy saving transformation method for parameterized simulation moving beam typed oil suction pump, and using the eccentric gear reducer to replace the ordinary gear reducer to let the driving radius of eccentric gear be kept a variation of similar tendency with the load of crank in order to improve load property of the motor, thus raised the working efficiency of the entire oil suction pump and achieved the effect of energy saving

    摘要基於三維建模和虛擬樣機技術，參數化模擬游梁式抽油機節能改造方法，用偏心齒輪減速器代替普通齒輪減速器，使偏心齒輪驅動半徑和曲柄負載保持同趨勢變化，以改善電機負載特性，提高整個抽油機的工作效率，達到了節能的效果。
  5. The effects of demulsifiers on interfacial tensions and membrane strength were studied for the model and effluence systems from the three - compound - combination flooding field. the interfacial tensions owned by the two - compound - combination system decreased but those owned by the three - compound - combination system increased with increasing the demulsifier concentrations. membrane strength decreased with the increase of demulsifier. the demulsification mechanism of demulsifier is suggested that demulsifier partially replaces the stabilizers and greatly decreases the intensity of interfacial film

    針對模擬采出液和三元復合驅礦場采出液，研究了破乳劑對復合體系界面張力和膜強度的影響.破乳劑濃度增加，二元復合體系界面張力降低，而三元復合體系界面張力升高.破乳劑分子部分頂替乳化劑分子並顯著降低了界面膜強度
  6. Application of simulation annealing algorithm in calculation of relative permeability from unsteady - state displacement experimental data

    模擬退火演算法在基於非穩態驅替實驗的相對滲透率計算中的應用
  7. It performs a large amount of physical simulation experiment using the multi - function displacement equipment which is imported from american temco company and summarizes the effecting rule of the injected alternating slug size on the displacement efficiency during the alternating injection of gas and liquid. it uses orthogonal method to study the set and type of pre - slug and post - slug and their effect on the displacement efficiency of foam flooding and optimizes the main and sub - slug size so as to decrease the cost while keeping a high displacement efficiency

    通過從美國temco公司引進的多功能驅替設備，所做的大量的物理模擬試驗，總結出了氣液交替注入時，注入交替段塞的大小對驅油效率的影響規律，利用正交設計法研究了前後段塞的設置與否及種類對泡沫復合驅驅油效率的影響程度，還對主次段塞的大小進行優化，在保證較高的驅油效率的前提下降低成本。
分享友人
分享到 Line

分享到臉書