驗濕器 的英文怎麼說

中文拼音 [yànshīqì]
驗濕器 英文
hygroscope
  • 驗 : 動詞1. （察看; 查考） examine; check; test 2. （產生預期的效果） prove effective; produce the expected result
  • 濕 : Ⅰ形容詞（沾了水的或顯出含水分多的） wet; damp; humid Ⅱ名詞（姓氏） a surname
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  1. An experimental study on humidifying performances in countercurrent humidifier

    逆流式空氣濕化器加濕性能的實驗研究
  2. Second, the starting and stopping behaviors under disturbed condition are analyzed and calculated by using the dynamic concentrative parameter model, which gives some advice to better prescribe refrigeration system and set theoretic foundation for carrying out automatic control of refrigeration system. third, the normal running process is analyzed and calculated by means of rational matching theory, which gives some advice on how to better understand the parameter change under steady state and the affection of inlet - parameter on evaporator. fourth, the simulation software with dynamic characteristic is designed, which can be applied to calculate thernio - parameter of cryogen, air humidity and frost thickness under different initial and boundary conditions, and to carry out dynamic simulation under conditions of dryness, wetness and frostiness, at the same time, to achieve detection and simulation at any stage from starting to stopping

    本文的主要內容如下： 1 ）對翅片管蒸發器結構特點進行分析，選取適當的微元控制體，就干、濕和霜工況下對每個微元分別進行傳熱傳質分析，基於經驗關系式確定霜的有關參數，對于霜工況下的霜生長建立模型，經適當假設，運用質量守恆、能量守恆和動量守恆方程建立適合動態模擬的蒸發器數學模型，為系統模擬奠定基礎； 2 ）對蒸發在大擾動下的開、停機過程，運用動態集中參數模型進行分析和計算，為更好地描述製冷系統運行的全過程奠定基礎，同時也為製冷系統實現自動控制提供一定的理論基礎； 3 ）對蒸發器正常運行過程，運用動態分佈參數和參數間定量耦合的觀點來分析和計算，為更好地了解穩態工況下各點參數的變化情況及各入口參數對蒸發器動態特性的影響即蒸發器性能對各參數變化的敏感性； 4 ）編寫翅片管蒸發器動態特性模擬計算程序，可以計算不同邊界條件和初始條件下的製冷劑熱力參數、空氣溫濕度和霜厚度分佈場，實現對翅片管蒸發器在干、濕和霜工況下的動態模擬。
  3. There are over 80 sets test apparatus in tech - innovation centre, including : anechoic chamber, vibration tester, vibration measurement analysis, impact instrument, constant temperature and humidity facilities. salt spary test case, circle insulation withstand voltage tester, insulation resistance tester, withstand voltage tester, electric lead tester, electrical leakage tester, earth resistance tester, chassis dynamometer, chassis dynamometer control system, high stability dc resistance tester, electrical capacity tester, temperature rise test system

    中心擁有各類分析測試儀器和試驗裝置80餘臺套，包括：消音室振動臺噪聲振動測試分析系統沖擊儀恆溫恆濕實驗儀鹽霧試驗箱匝間耐壓分析儀絕緣電阻分析儀對地耐壓分析儀泄露電流測試儀對地電阻測試儀測功機測功機控制系統高精度直流電阻測試儀電參數測試儀帶電溫升測試儀復合式三坐標測量儀萬分投影儀及電功測試分析系統等。
  4. Electric humidifier for household use ; characteristics of performance, tests

    家用電加濕器.使用性能.檢驗
  5. Test method for friction element of wet clutch

    濕式離合器摩擦元件試驗方法
  6. Standard test method for determination of oxygen gas transmission rate, permeability and permeance at controlled relative humidity through barrier materials using a coulometric detector

    用庫侖檢測器測定氧氣傳輸率滲透率和穿透屏蔽材料的受控相對濕度的滲透的標準試驗方法
  7. Semiconductor devices - mechanical and climatic test methods - internal moisture content measurement and the analysis of other residual gases

    半導體器件.機械和氣候試驗方法.其他殘余氣體的內部濕氣含量的測量和分析
  8. Puts forward an improved method based on the theory in which the enthalpy difference is considered as the driving force in heat transfer under wet cooling conditions and thinks that the method can halve the testing work, require less for the experiment devices and reach higher accuracy

    認為該方法遵循了焓差是濕工況下換熱推動力的規律，試驗工作量減少一半以上，對試驗裝置的要求降低，由試驗數據整理出的公式用於表冷器熱力計算完全可以滿足空調常用范圍內的要求。
  9. Testing of ion exchangers - determination of bulk weight density, equilibrium moisture content and solids

    離子交換器的試驗.散重密度，平衡濕度和固體顆粒的測
  10. By adopting the method of saturated aqueous salt solutions, the paper designs the equipment to produce the humidity source and scale pi sensors. based on the design and long period measurement of demarcated equipment, we get the lots of curve and data that shows the linear relation between capacity and moisture and good linearity and resolving power

    採用飽和鹽溶液法得到相應級別的濕度標準，對傳感器進行標定試驗並採用相應的數據處理方法，建立了感濕特徵量與氣相濕度之間的數學關系，最終給出其數學模型和各種指標。
  11. Methods of testing for rating desiccant dehumidifiers utilizing heat for the regeneration process

    用於再生工藝的利用熱的乾燥劑減濕器評定的試驗方法
  12. Dehumidifiers with electrically driven compressors. rating tests, marking, operational requirements and technical data sheet

    帶電動壓縮機的減濕器.額定性能試驗標記和操作要求及技術數據單
  13. Dehumidifiers with electrically driven compressors - rating tests, marking, operational requirements and technical data sheet

    帶電動壓縮機的減濕器.額定性能試驗標記和操作要求及技術數據表
  14. Thermodynamic performance experimental study and cooling number calculation of counter - flow spray humidifier in hat cycle

    循環逆流式濕化器的熱力性能實驗研究及冷卻數計算
  15. Test methods for water vapor transmission of rigid containers

    硬包裝容器透濕度試驗方法
  16. Method of permeability test for moisture proof packing case

    防潮包裝容器的抗濕滲透性試驗方法
  17. Using lithium bromide aqueous solution as liquid desiccant, adopting the total heat transfer rate and enthalpy efficiency to describe the combined heat and mass transfer performance and the moisture removal rate and regenerative efficiency to describe the mass transfer performance of the regenerator, explores the effect of air and desiccant inlet parameters on the regenerator performance by experiment, and compares the result obtained with those of other counter - flow configurations previously published

    以溴化鋰溶液為除濕劑，採用總換熱量、全熱效率描述再生器的熱質交換總體效果，採用再生量、再生效率描述傳質效果，實驗測試了溶液和空氣的進口參數對再生器性能的影響，並與逆流再生器的實驗結果進行了比較。
  18. Electric connectors - humidity test procedure

    電連接器.濕度試驗程序
  19. 3. based on theoretical analysis and experimental results, the high relative humidity was diffcult to maintain in the closed tissue culture system when all of the fluorescent lamps were turn on, because of deficiency of the humidifier ' s capacity and air ventilation by top air nozzle outlets and return air in the bottom. 4

    根據對加濕過程的理論計算與試驗分析，指出本系統中降溫與加濕共存階段加濕效果不明顯，同時由於加濕器的加濕容量不足，頂部送風和下部兩側回風的通風方式造成了室內的相對濕度無法在熒光燈全開時達到控制要求。
  20. Fibre optic interconnecting devices and passive components - basic test and measurement procedures - tests - damp heat steady state

    纖維光學互連器件和無源元件.基本試驗和測量程序.試驗.濕熱
分享友人
分享到 Line

分享到臉書