高壓阻尼線 的英文怎麼說

中文拼音 [gāoxiàn]
高壓阻尼線 英文
anti-interference igniton cable(high resistance cable)
  • : Ⅰ形容詞1 (從下向上距離大; 離地面遠) tall; high 2 (在一般標準或平均程度之上; 等級在上的) above...
  • : 壓構詞成分。
  • : 動詞(阻擋; 阻礙) block; hinder; impede; obstruct
  • : 名詞(尼姑) buddhist nun
  • : 名詞1 (用絲、棉、金屬等製成的細長的東西) thread; string; wire 2 [數學] (一個點任意移動所構成的...
  • 高壓 : 1 (殘酷迫害; 極度壓制) high handed 2 [氣象學] (高氣壓) high pressure3 (高電壓) high tension...
  1. Based on extensive investigation of construction technique history of chinese ancient buildings, the structure method, structure developing history and seismic behavior of chinese ancient timber structure buildings are analyzed in several respects of the structural system and form. through a series of experiments on constituent parts of chinese ancient timber building structure, including the tests on the corbels and brackets called dougong subjected to low cyclic reversed loadings, the tests on the wooden frame using the tenon - mortise joints as connections of column and beam subjected to low cyclic reversed loadings, the tests on vibration isolation effect of friction and slippage between column footing and their socle base, and a series of shaking table tests on a chinese ancient timber structure palace building mode under artificial earthquake at serving conditions, destroyed conditions and reinforced conditions, many valuable results of structures such as moment - curvature hysteretic loops of dougong structure and tenon - mortise joints under low cyckc reversed loadings, the static function, the seismic performance, energy dissipation, vibration reduction, energy - loss mechanism, nechanicalmode and failure mode were studied. aplenty of valuable parameters of the structure system were obtained, such as the natural period of structure, vibration modes, damping ratio, factor of vibration isolation, oscillate amplitude of ineitial accebration, velocity and displacement, magnitude of slippage, and the mechanism of structure failure and collapse etc. based on these research, the complete analysis of ancient timber structure under earthquake were carried out in which including mechanism analysis method, calculating mode, strength analysis of members and joints, strengthening methods for serving damaged ancient timber structure buildings were also taken into account

    依照宋代《營造法式》建造了抬梁式殿堂木結構構件及結構模型,對中國古代木結構中的典型構造如:柱腳在礎石頂面平擱簡支、柱架榫卯連接、柱不越間之廣、側腳、生起、斗拱等的構造機理及結構功能進行了量化分析和實驗研究: (一)通過木柱石礎靜摩擦試驗,測定了柱腳與石礎古鏡面間的摩擦系數及摩擦力隨上部結構荷載變化的規律; (二)通過單柱承載力試驗,測定了古建築中木柱的受力變形特徵、破壞模式、及模型材料的變形模量、極限承載力、極限變形等參量; (三)通過柱架低周反復荷載試驗,測定了柱架的抗側移剛度、柱架恢復力特性及滯回曲、榫卯張角剛度及其變化規律、柱架及榫卯的極限承載力和極限變形、及榫卯減振參數; (四)通過斗?低周反復荷載試驗和受試驗,測定了古建築木構件與木構件間摩擦系數,斗?抗側移剛度,斗?恢復力特性及滯回曲,斗?抗極限承載力及受力變形規律; (五)通過抬梁式殿堂間架模型振動臺試驗,測定了殿堂木構架結構自振周期,地震反應振形、特性及比;按結構分層特點對柱腳、柱頭和斗?層上的屋蓋的地震反應採用多點同步測量,對柱根滑移、榫卯變形、斗?的變形、復位、耗能減振參數等進行了定量分析。
  2. High voltage damper wire quality goods times superman

    高壓阻尼線精品時代超人
  3. Unified power flow controller ( upfc ) is one of the most powerful and most promising controllers of facts. if we use upfc to control the transmission parameters, terminal voltage, line impedance and phase angle in normal situation and use it to compensate zero sequence and negative sequence currents when one of transmission lines is cut off, we can implement two phases operating in high voltage transmission lines, which can improve stability and reliability for the transmission system

    統一潮流控制器( upfc )是功能最強、最具發展潛力的靈活交流輸電系統( facts )控制器之一,如果在常規條件下,用upfc實現輸電路的電調節、移相、潮流控制、振蕩等功能,在發生單相永久性接地或單相斷路故障時,由傳統的三相跳閘改為單相跳閘,用upfc的並補來濾除兩端系統的零序和負序電流,用upfc的串補來提輸電的傳輸功率,以實現兩相長期運行,那麼輸電系統的穩定性、可靠性將大大提
  4. We did some analysis about the relativity between the vibration and the noise of the wheel. after the testing of the first line of guangzhou underground, we found that the existing wheel damper has nothing to do with the noise of wheel less than four thousands hz. compared of different contributions of the tread vibration and the web vibration on sound level of railway noise

    在實驗過程中,改進了對車輪的激振方式,利用單擺激振提了激振力的精度;實驗分析了車輪器的結構、安裝方式及其動力學參數對車輪器降噪效果的影響;也分析了車輪振動與噪聲的相關性;現場測試廣州地鐵一號的噪聲特性,確定了車輪器所要控制的頻率范圍;對比分析不同激振情況下,踏面徑向振動與輻板軸向振動對噪聲聲級的貢獻比例。
  5. The paper studied controlling rotor vibration with the super - elasticity of sma and sfd, set up the new equation of sys tern vibration according to the stress - strain curve of sma in super - elasticity state, used the nonlinear theory and the dynamic stability theory to study the vibration of rotor controlled by sma, discussed the stability condition of the system, obtained the relationship of system parameters when bifurcation was appeared, supposed a method that improves the stability of rotor system and restrains vibration amplitude though changing parameters, and finally validated the effect of restraining vibration of the improved system through emulation

    摘要研究利用形狀記憶合金的超彈性和擠油膜器控制轉子振動,利用形狀記憶合金在超彈性狀態下的應力應變曲,建立了新的系統振動方程,運用非性理論和運動穩定性理論研究轉子在形狀記憶合金控制下的振動狀態,討論了系統的穩定性條件,獲得系統發生分岔時系統參數之間的關系;並提出了通過改變參數來提系統穩定性和抑制振幅的方法,最後通過模擬驗證了改進后的系統振動抑制效果。
  6. High voltage line of resistance domestic type

    國產型高壓阻尼線
  7. High voltage line of resistance export type

    出口型高壓阻尼線
  8. High voltage damper wire quality goods

    高壓阻尼線精品捷達
  9. High voltage damper wire jitta king

    高壓阻尼線捷達王
  10. High voltage damper wire jitta

    高壓阻尼線捷達
  11. High voltage damper wire

    高壓阻尼線488小解放
  12. Changzhou shenjia automobile electric factory, is specialized ignition cable, ignition coil etc. 80 % of the product are exported in usa, japan, england, southeast asia and the middle - east

    常州市申佳汽車電器廠是專業生產汽車高壓阻尼線、汽車點火圈等產品, 80 %以上出口至美國、日本、英國、東南亞、中東等國家。年生產量達30萬套以上。
  13. As a designated unit producing fitting products for china faw group corporation, our factory mainly produces high voltage damping ignition wire, distributor head and discap, which are applied to the common ignition system electric control fuel injection type of jetta series, santana series, audi series, gm - buick, and hongqi saloon cars etc and sold far to europe and won the good comments from our users

    我廠現為中國第一汽車集團配套產品的定點單位,主要生產為轎車輕型車配套的點火分火頭和分電器蓋。適用於我國的捷達系列桑車系列奧迪系列通用別克小紅旗等轎車普通型電噴型的點火系統。產品遠銷歐洲,深得用戶的一致好評。
  14. Utilizing backstepping procedure, general expression of control strategy for hvdc converters is acquired. the control strategy can restrain the nonlinear uncertainty through injection of nonlinear damping terms in virtual controllers. the proposed decentralized adaptive control scheme guarantees that all the signals in the closed - loop system are bounded in the presence of high order interconnections and bounded disturbances

    設計中引入自適應非項來抑制系統非性不確定參數和未知有界干擾的影響,同時採用反演設計方法來克服控制器設計的復雜性,最後獲得直流輸電系統換流站的分散魯棒自適應控制策略的一般表達式,並提供了整個系統的穩定性證明。
  15. Based on the reference [ 22 ], the dynamical modeling converters for hvdc system have been transformed to a nonlinear system represented by input - output model with unmodeled dynamics and bounded disturbances, and a robust adaptive output - feedback nonlinear controller is designed. the controller counteracts the uncertain dynamic nonlinearities and bounded disturbances by nonlinear damping terms, and unmodeled dynamics by a dynamic signal

    本文在文獻[ 22 ]的基礎上,對直流輸電系統換流站動態模型進行變換處理,將其化為一類具有含未建模動態和有界擾動的輸入-輸出非性系統,並設計了一種魯棒自適應輸出反饋控制器,利用非項來抑制系統的動態不確定性和有界擾動,引入一動態信號來抑制系統的未建模動態。
  16. A novel strategy combined the fuzzy logic of linear multivariable feedback control to design a controller of statcom to meet the multi - objective demands of power systems is also proposed in this dissertation, and the controller is designed with this strategy, because of variational element, nonlinearity and multi - objective controlling demands of statcom, this paper designs the controller respectively aimed at continuous linear control for voltage maintaining, oscillation damping, improving the transient stability

    根據電力系統變參數、非性以及對控制要求多目標的特點,本文針對維持系統節點電系統振蕩、提系統暫態穩定性能等不同控制目標分別設計了控制器,然後將模糊邏輯和多狀態性反饋相結合,提出了一種能滿足電力系統多目標要求的控制方法,並用該控制方法為statcom設計了控制器。
  17. The model analysis of the deployed beams were studied in both theory way and simulation way. the differences of the beams in different pressures were studied. investigations showed that the method of modeling for short and long rolled beams is doable ; the process of fold maybe lead so large displacement and stress that membrane is damaged at local areas, ration and material wrinkle generates,

    研究結果表明:本文提出的分別針對短、長捲曲折疊充氣管的建模方法是有效的;在充氣管展開過程中,充氣速度越大,展開的速度越快,但由於損耗,二者並非性關系;充氣速度過大不利於結構展開過程的穩定性;充氣支撐管的氣越大其固有頻率越,但影響效果很小。
分享友人