高溫腐蝕 的英文怎麼說

中文拼音 [gāowēnfǔshí]
高溫腐蝕 英文
corrosion at high temperature
  • 高 : Ⅰ形容詞1 （從下向上距離大; 離地面遠） tall; high 2 （在一般標準或平均程度之上; 等級在上的） above...
  • 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
  • 腐 : Ⅰ名詞（豆腐） bean curdⅡ動詞（腐爛; 變壞） decay Ⅲ形容詞（腐爛） rotten; corroded; putrid
  • 蝕 : Ⅰ動詞1. （損失; 虧耗） lose 2. （腐蝕） erode; corrode Ⅱ名詞（天體現象） eclipse
  • 高溫 : high temperature; elevated temperature; hyperthermia; megatemperature; inferno
  • 腐蝕 : 1 （通過化學作用使物體逐漸消損破壞） corrode; corrosion; corroding; deep etch; diabrosis; rot; ea...
  1. Measuring object : high temperature corrosion or viscous fluid

    測量對象:高溫腐蝕性或粘性液體
  2. The mechanism of corrosion and erosion resistance of nicr alloy and cermet coatings were explored and their performance were compared with 20g, 20g covered by dope and the coatings of fecral, nicrti used widely at present

    並將由這些新的塗層材料和目前廣泛使用的fecral ， nicrti以及與未加以保護的20g基體和刷塗料保護的20g在抗高溫氧化、高溫腐蝕、耐沖蝕磨損和熱震性等方面加以比較。
  3. The water wall tubes were leaked by the high temperature corrosions, which put the boiler units shut down and made the safety and economy operation of the power plants effected severely, which also made the safety generation and dispatch of the all power network effected severely

    鍋爐水冷壁高溫腐蝕造成水冷壁管爆漏，迫使鍋爐停機，嚴重影響了電廠運行的安全性和經濟性，對整個電網的安全生產和調度也造成了嚴重的後果。
  4. Cause analysis of high temperature corrosion of the boiler in hubei hanchuan power plant

    湖北漢川電廠鍋爐高溫腐蝕原因探析
  5. General rules for high - temperature corrosion test of metallic materials

    金屬材料高溫腐蝕試驗的一般規則
  6. Method for high - temperature corrosion test of metallic materials by salt coating

    金屬材料鹽覆層的高溫腐蝕試驗方法
  7. Thermal spraying - coatings for protection against corrosion and oxidation at elevated temperatures

    熱噴塗.高溫腐蝕和氧化防護塗層
  8. Methods for high - temperature corrosion test of metallic materials by dipping and embedding in molten salts

    熔鹽中浸入和嵌入的金屬材料的高溫腐蝕試驗方法
  9. Thermal spraying - coatings for protection against corrosion and oxidation at elevated temperatures iso 17834 : 2003 ; german version en iso 17834 : 2003

    熱噴鍍.防高溫腐蝕和氧化的塗層
  10. Formulas of an inorganic high - temperature ceramic coating was studied quantificationally with a method of uniform design

    摘要採用配方均勻設計方法，對無機耐高溫腐蝕陶瓷塗料的配方進行了定量研究。
  11. The reason of the high temperature corrosion of water wall of no. 1 boiler of weifang power plant is the coal problem and separated of primary and secondary air

    濰坊電廠造成# 1爐高溫腐蝕的原因主要是煤質問題、煤粉顆粒粗及一、二次風分離。
  12. Thereby, more and more attentions and researching were given on the problem of the high temperature corrosion of the water wall tubes of the boiler recently

    因此，近年來，人們對鍋爐水冷壁高溫腐蝕問題給予了很多關注，不斷的深入研究和解決高溫腐蝕問題。
  13. However, researching of the high temperature corrosion is limited in engineering now, only judged by the corrosion products of the water wall tubes, more in - depth researching is lack about the corrosion mechanism and the course of reaction

    但是，目前人們對高溫腐蝕的研究局限於工程實踐的研究，只能根據水冷壁管的腐蝕產物來作出判斷，而對其腐蝕機理以及反應過程缺乏進一步深入的研究。
  14. In the industry of thermal power plants, boiler tubes, especially water wall tubes in enginery of over 300mw, water wall tubes are easily corroded in high temperature and wore by dust when the coal with high content sulphur is used, which made water wall tubes become thin and burst

    在火力發電行業中，燃煤鍋爐管特別是300mw及以上機組的水冷壁管在燃用高硫含量煤時，易受到嚴重的高溫腐蝕和飛灰的磨損，使管壁減薄導致爆管事故。
  15. No. 4 boiler in niangziguan plant is main research object, in view of slagging and high - temperature corrosion of boiler, after this problem is analyzed and studied, we put forward the horizontal concweak ellipse cone combustion technology with primary air and secondary air added side secondary air

    本文以娘子關電廠4 ~ #爐為研究對象，針對鍋爐結渣和高溫腐蝕問題，通過分析研究，提出一、二次風同心反切加側二次風水平濃淡煤粉橢圓錐燃燒技術。
  16. Passing the cold air - dynamic test, thermal efficiency test and practical running, we can conclude the technology is viable in setting the high temperature corrosion of the water wall tubes of boiler and increase thermal efficiency ect

    從冷態空氣動力場試驗、熱態效率試驗和實際運行方面出發，驗證此項技術在解決鍋爐水冷壁高溫腐蝕以及提高鍋爐熱效率等方面的可行性。
  17. The analysis of x - rd of the corrosion products is adopted ; the curves of add weightiness of corrosion is translated into the thermal dynamic curves, so we can judge the corrosion mechanism by the thermal analysis. the method is fresh and innovation, which made the means of researching and the content enriched

    並對腐蝕產物進行x - rd衍射分析，對腐蝕增重曲線進行轉化，利用熱分析動力學的分析方法對反應機理作出判斷，從理論上研究鍋爐水冷壁高溫腐蝕機理。
  18. High temperature corrosion problems are reviewed for chemical, petrochemical, petroleum refining, fossil energy, gas turbine and waste incineration industries

    摘要本文針對有關化學、石化、石油精煉、燃煤、渦輪引擎葉片及焚化爐等工業應用環境上，遭遇之高溫腐蝕問題作一回顧。
  19. At present the phenomenon that high temperature corrosion of water wall and gas temperature deviation of shandong power plant is ubiquity. it brings the great harm to safety and economical operation of boiler

    目前，山東省大機組普遍存在著爐膛出口煙溫偏差和水冷壁煙側高溫腐蝕現象，給鍋爐的安全、經濟運行帶來很大危害。
  20. Ththe function of titanium pot is nicee entire pot is made of hot - resistant and anti - corroed material. weight appropriately, anti - rust, durable and convenient are the characters

    鈦金鍋具有優異的性能：鍋體內外均為抗高溫腐蝕的金屬材料，重量適中，永不生銹，堅固耐用，使用方便。
分享友人
分享到 Line

分享到臉書