高溫變質處理 的英文怎麼說

中文拼音 [gāowēnbiànzhíchǔlǐ]
高溫變質處理 英文
high temperature modification
  • 高 : Ⅰ形容詞1 （從下向上距離大; 離地面遠） tall; high 2 （在一般標準或平均程度之上; 等級在上的） above...
  • 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
  • 質 : Ⅰ名詞1 （性質; 本質） nature; character; essence 2 （質量） quality 3 （物質） matter; substance;...
  • 處 : 處名詞1 （地方） place 2 （方面; 某一點） part; point 3 （機關或機關里一個部門） department; offi...
  • 理 : Ⅰ名詞1 （物質組織的條紋） texture; grain （in wood skin etc ） 2 （道理;事理） reason; logic; tru...
  • 高溫 : high temperature; elevated temperature; hyperthermia; megatemperature; inferno
  1. The effect of compound casting technology and compound modification on the properties of high speed steel roll collar was studied. the results showed that compound high speed steel roll collar with high and even hardness and good bond between outer and inner layers could be gained when the modified colbalt free high speed steel in outer layer and nodular iron inner layer in connection with appropriate rotational speed of centrifugal machine, pertinent pouring interval between two kinds of the melt and moderate pouring temperature as well as surface induction heat treatment were chosen. it is indicated in industrial use that the service life of compound roll collar is higher by 5 times than that of high chromium cast iron collar

    研究了離心復合鑄造工藝和復合變質處理對高速鋼輥環性能的影響，結果表明，選用變質高碳無鈷高速鋼作外層，用球鐵作內層，選擇合適的離心機轉速、兩種金屬熔液澆注間隔時間和澆注溫度，結合採用表面感應熱處理工藝，可獲得硬度高、均勻性好、內外層結合良好的高速鋼復合輥環，用於工業生產其使用壽命比高鉻鑄鐵輥環提高5倍以上。
  2. Besides, scan rate and cycle period also affect the result ; co - deposition of dualistic oxide is a focus of research, as an element in the same group, ir is selected. deposition rate of composition is decreased by the adding of ir composition, and when the proportion of ir exceeded 50 %, composition procession can be ceased. but cooperation of ir and ru oxide can highly increase the specific capacitance of active material ; annealing treatment under a certain temperature can help to change the hydrate ru composition into mixture state ru oxide, accordingly increase the stabilization of active material

    研究表明:電解液的配製過程中，氯化釕濃度、溶液ph值、陳化時間、溶液溫度對電鍍效果均有影響，其中溶液ph值是最主要的影響因素;在儀器的使用條件探索中，理論結合實驗確定了本電鍍液體系循環伏安電勢窗的理想范圍，並發現循環伏安掃描速度和掃描周期對電鍍結果也有較大影響;混合氧化物的共沉澱是目前研究熱點，在此選用與釕同一族的銥作為共沉澱元素，銥的加入會阻礙氧化物的沉積速度，銥的比例超過50 %會使沉積作用停止，但是二元氧化物的協同作用使沉積的活性物質比容量大大提高;一定溫度下退火后處理作用會使水合釕化物轉變成混合價態的氧化釕，從而提高活性物質的穩定性。
  3. The properties of lacamno3 films were enhanced dramatically with a post annealing treatment in high temperature and high oxygen pressure. the films show the highest so far tmi, which reaches the 300k, the transition of resistivity is kept in a narrow temperature range and the temperature coefficient of resistance ( tcr ) is about 5 - 8 %

    以高溫、高氧壓的條件對薄膜進行後退火處理，薄膜性質得到極大改善，轉變溫度點提高到了300k ，電阻?溫度系數也達到了5 - 8 ，不僅提高了轉變溫度點，而且使轉變保持在一個較窄的溫度區間內。
  4. Xps showed that there were much chemical absorbing water on the ti _ ( 2 ) film surface which mainly existed in form of - oh, and the contents of - oh was increasing with the annealing temperature. hydrophilic property became better with the annealing temperature ; the essential relation between the changing of contact angle and light - induced - electrons and light - induced - cavities was studied in details. the photocatalysis of samples without heat treatment was very bad, but that of samples after heat treatment was much better

    Xps的分析表明：試樣的表面含有大量的化學吸附水，主要以羥基的形式存在，隨著熱處理溫度的升高，吸附羥基的含量在增加；親水性能測試表明：隨著氧氣分壓的變化，其親水性能變化不大，隨著熱處理溫度的增加，試樣的親水性能在變好，並從理論上解釋了親水性能光照前後變化和光生電子?空穴對之間的本質關系。
  5. Results showed : ( 1 ) cbt cell death in low tempratures is accompanied by characteristic changes, such as, reduced cell size, distorted nucleus, chromatin condensation and margination and cell ( cytoplasmic ) vacuolization ; cell mortality and ca2 * concentration increase along with time passed in low temperature. mitochondrial membrane potential and 02 increased at first, and then decreased. activities of sod decreased at first, followed by significant increasing and finally depressed

    結果表明： （ 1 ） cbt在低溫協迫下，細胞圓縮，細胞核變形，染色質濃縮且邊位，細胞質空泡狀；細胞死亡率隨處理時間的增加而增加；細胞內鈣離子濃度隨處理時間延長而遞增；線粒體膜電位差在低溫處理早期急速上升，隨后一直下降；細胞內超氧陰離子（ o _ 2 ~ - ）在低溫處理前期出現高峰，接著呈下降趨勢；細胞內sod活性在低溫處理前期減弱，接著上升，然後持續下降。
  6. As the demand of low weight and high strength for high damping alloys, the composition of aluminum alloys was determined as al - 20 % zn - 6 % si - 0. 4 % mg ( i. e. azsm ) by the orthogonal experiments. furthermore, effects of alloyed elements, the modifying agents and heat - treatment on microstructures, damping capacities and mechanical properties of the azsm alloy were studied. finally, the damping mechanism of the azsm alloy was proposed

    根據對高阻尼合金輕質高強的要求，採用正交試驗法確定了具有良好阻尼性能的鋁合金的成分為al - 20 zn - 6 si - 0 . 4 mg （下稱azsm合金） ；探討了合金化、變質和不同熱處理工藝對azsm合金組織、阻尼性能和力學性能的影響；最後提出了azsm合金的室溫阻尼機制。
  7. The mutant pel - d92l was expressed in pichia pastoris gs115, sds - page detection showed that the expression product pel - d92l - gs is different from pel - gs, and its " yield decreased dramatically, the themostability of pel - d92l - gs is also different from the pel - gs, but their optimum temperatures are same. 3. directed evolution of pel through random mutagenesis mutagenesis pcr carried out in error - prone conditions was used on the vector psk - pel, using the oligos " beginning " and " end ", homologous to the 5 ' and to the 3 " ends of the gene of pel respectively

    三、 pel基因的隨機誘變用易錯pcr方法對pel基因進行隨機誘變， pcr產物與ppic3 . 5k連接，轉化大腸桿菌，獲得的混合質粒電轉化畢赤酵母gs115 ， omm平板篩選適于低溫或對熱穩定的重組子，篩選獲得一株最活反應溫度、熱穩定性、發酵酶活均有提高的突變體pel - ep5 - gs ，其最活反應溫度為45 ，比野生型高出5 ； 40處理30min殘留活性為56 ，大大高於野生型的6 ；初始ph7 . 3528條件下培養72h ，發酵上清酶活為325u / ml 。
分享友人
分享到 Line

分享到臉書