高限溫度 的英文怎麼說

中文拼音 [gāoxiànwēndù]
高限溫度 英文
ceiling temperature
  • 高 : Ⅰ形容詞1 （從下向上距離大; 離地面遠） tall; high 2 （在一般標準或平均程度之上; 等級在上的） above...
  • 限 : Ⅰ名詞（指定的范圍; 限度） limit; bounds Ⅱ動詞（指定范圍, 不許超過） set a limit; limit; restrict
  • 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 高限 : high common low relay
  • 溫度 : [物理學] temperature
  1. Based on the simulation model theory of temperature and stress fields presented in this article, a large simulating program for high rccd has been developed, which can numerically simulate all kinds of temperature control measures, including water pipe cooling, heat insulating in winter, reducing place temperature of concrete, spraying water brume, and long interval over - watering surfaces overflowing in flood season.

    基於本文提出的溫度場和徐變應力場模擬模型理論，編制了高碾壓混凝土壩的三維有限元模擬計算程序，在程序中考慮了各種溫控措施的數值模擬，包括：水管冷卻、冬季保溫、降低混凝土的澆築溫度、夏季混凝土表面噴水霧、施工汛期壩頂面過水等。
  2. The endurance limit is reduced for temperatures above room temperature.

    溫度高於室溫，持久極限則降低。
  3. In the deep mantle the highest possible concentration of radioactive materials is limited by the condition demanding temperatures below the melting point.

    在地幔深部，放射物質最高的可能濃度受溶點以下的溫度條件所限制。
  4. On the basis of experimental research, this thesis applies 2 - dimensional non - linear finite element method to the analysis of transient temperature field on the section by means of relatively high precision triangular element of six joints. when the temperature field is analyzed, finite element reseaus are divided in space field and finite difference reseaus are divided in time field, and then the program is compiled. the computing results are in good agreement with the test data

    在試驗研究的基礎上，本文採用精度較高的三角形六結點單元對構件截面二維非線性瞬態溫度場進行了有限元分析，即在空間域內採用有限元網格劃分，在時間域內採用有限差分網格劃分，據此編制了計算程序，計算結果與試驗數據符合較好，程序穩定性好，精度滿足要求。
  5. This thesis used aerodynamics equation and mechanics of materials knowledge analyzed the high pressure caused by overloading in terms of theory. by compared the increment of pressure in a not full container with the full one and combined with the igc - code, this thesis put forward a method of calculating safe loading capacity under different temperature

    本文應用了氣體力學方程和材料力學理論知識，對充裝過量導致過高的液貨艙壓力進行了理論分析，對比保留有氣枕時的液貨艙的壓力增量和充裝過量時造成滿液的壓力增量，並結合igc規則對充裝極限的規定，提出了不同溫度下的安全貨液充裝量的計算方法。
  6. But the temperature difference at the vertical direction in combustion chamber in lead column, that is said by operator, is over 60 ?. ( 2 ) according to the experiences in the practice, the second layer air and the second layer gas had a little effect of support burning, and the third air has little effect for combustion, and the power to drawing exhaust gas can only be adjusted in limited range. the problems, it is said above, restricted more advance of some kinds of technology and economy target in spelter refining in new jersey furnace

    由於鋅精餾爐產量提高，一些問題開始暴露出來： （ 1 ）燃燒室?舶要求溫度差不超過10 ，而從現場反映的情況來看，燃燒室上、中、下部溫度差已超過60 ； （ 2 ）在生產實踐中，發現燃燒室第二層空氣、第二層煤氣作用甚小，第三層空氣失去助燃作用，廢氣出口的抽力可調范圍有限；以上這些問題在客觀上制約了精餾塔在鋅精煉中各項技術經濟指標的進一步提高。
  7. The construction execution of prestressing work has many advantages such as : dry - work, rapidity, no organic adhesion agent, small space to be taken, the high efficiency of strengthening, so this way can be applied in the structures which request to improve bearing capacity largely and take small space after strengthening as well as other structures which will work in long time and in high temperature

    預應力加固過程是干作業，施工速度快，不使用有機粘結劑，加固后佔用空間小，加固效率高，適用於要求大幅度提高承載力及加固后佔用空間小的混凝土結構，也適用於要求施工速度快，加固后使用年限長，工作環境溫度高的結構。
  8. In this paper, a high performance sma system applied to steel bridge deck is put forth in allusion to the pavement project of the wuhan junshan yangtze river highway bridge. it comprises steel slab, zn coating layer, closing layer, adhesive, pre - mixed asphalt stone and dual layer sma from bottom to top. it is based on the fea results of the forces and deformation of the pavement layer by means of the algor feas, according to this bridge ' s traffic and the ambient temperature varying range of the pavement layer

    本文針對武漢軍山長江公路大橋鋼箱梁橋面鋪裝工程，從鋪裝層環境溫度變化范圍、交通量等使用條件出發，在用algorfeas有限元分析軟體分析鋪裝層受力變形基礎上，提出了（即鋼板+金屬鋅塗層+封閉層+粘接劑+預拌瀝青碎石+雙層sma ）的高性能鋼橋面sma鋪裝體系，並對這種sma的組成材料，包括改性瀝青、集料、礦粉、纖維進行了比較研究，設計了這種sma的配合比，對sma混合料的性能進行了對比試驗，對這種sma方案進行了疲勞性能研究，驗證了所選擇sma方案的可行性。
  9. This paper describes how to calculate the temperature of high - temp gas at the outlet of combustor by means of limited gas composition and analyses how errors in measuring gas composition, low calorific value of fuel, fuel composition and fuel temperature, etc. affect gas temperature

    摘要敘述了一種根據有限的燃氣成分推算燃燒室出口高溫燃氣溫度的計算方法，並分析了燃氣成分測量誤差、燃料低熱值、燃料成分及燃料溫度等對燃氣溫度的影響。
  10. Aim for the topic - study of prestressed lightweight concrete platform, from selecting style of the platform, to matching concrete material and admixture, to designing and building the model, to carrying out experiments of temperature field and stress performance, and analysis of finite element, some research work have been done as follows : 1

    本文針對「輕質高強預應力混凝土平臺的研究」這一課題，從罐體結構型式的確定，混凝土基本材料及外加劑的選配，模型的設計製作，到模型結構在各種外荷載及溫度荷載作用下的受力性能試驗研究及罐體結構的有限元分析，展開了如下幾個方面的研究： 1
  11. However, one of the most serious impediments to wider use and improve precision of psi is its sensitivity to external vibration with the consequence that psi has rarely been used in a manufacturing in - situ and some special situations, such as that the optical path is very long or the detected unit is very large

    通過嚴格控制環境條件（溫度、氣流、振動等） ，其理論光程差（位相）的最小解析度可以達到nm的數量級。然而，由於干涉計量測試靈敏度高、精度高，對外界振動非常敏感，使它的應用范圍受到限制。
  12. But it also includes two fatal disadvantages : first, at is difficult to be sintered and its density is low, which causes its lower strength ; second, in the temperature range of 1023 - 15 73 k, at can decompose into al2o3 and tio2 easily, which can cause the stress concentrated and raise the heat expansion rate

    但是該材料本身存在的兩大致命的缺點，在很大程度上限制了它的廣泛應用： （ 1 ） 、鈦酸鋁難以燒結，燒結體的緻密度低，因而強度不高； （ 2 ） 、在750 1300的溫度范圍內易分解成氧化鋁和二氧化鈦，造成材料內部應力集中，並使材料的熱膨脹率升高。
  13. The elastic constants of bcc li, na and fcc al crystals have been evaluated as functions of pressure and temperature by using a new model together with ab initio electronic structure and total - energy calculations. in the model it is considered that the elastic constants of crystals at a given temperature and pressure can be calculated using a conventional density functional method but modified by a new set lattice constants due to the isobaric volumetric thermal expansion when temperature rise from absolute zero to the given one

    本文對高壓及有限溫度立方金屬彈性常數的計算方法進行了研究，建立了一種考慮溫度效應的物理模型，基於這個模型和從頭算方法，對典型的立方晶系金屬li 、 na 、 al在高壓及有限溫度（熔點以下溫度）彈性常數進行了計算，取得了與已有實驗結果較好相符的計算結果。
  14. Comparison of the calculated elastic moduli with the experiment ones for fcc al and bcc li and na it shows they are in perfect agreement with each other

    當晶體從絕對零度升高到某一有限溫度下時，晶體發生體積膨脹，計算出發生體積膨脹后的新體積。
  15. It begins to refrigerate when the temperature in the milk jar is higher than the temperature upper limit, and stops refrigerating when the temperature is below temperature lower limit

    ：當奶罐內溫度高於「溫度上限」時，開始製冷，一直到溫度降到低於「溫度下限」時停止製冷。
  16. The residue contact pressure will be decreased after temperature cycle, the higher the working temperature, the lower the residue contact pressure, which has been proved by experiment

    研究表明，當復合管處于熱加載狀態時，復合管存在著極限工作溫度；經過極限溫度循環后，殘余接觸壓力將減小，且極限溫度越高，殘余接觸壓力值越小；通過實驗得到了驗證。
  17. And then, we specially study the effect of spin interaction ' s anisotropy on the critical temperature tc. from what we have observed we suggest that the critical temperatur tc grows as the anisotropy intensifies, while the system magnetization becomes weaker. the system becomes id if the anisotropy ratio r goes to infinity, and its equilibrium state keeps zero magnetization at any finite temperature, which confirm that there is no observable transition for id system

    其後，著重研究了自旋相互作用的各向異性程度r對其臨界溫度t _ c的影響，總結出：隨著系統各向異性程度的增強，系統的臨界溫度向高溫轉移，而系統的磁化強度在不斷的減弱；當r趨近於無窮大時，系統演變為一維系統，系統在任何有限溫度下達到的平衡態始終保持磁化強度為零，這也證實了一維系統不發生相變
  18. Typical temperature is 800 - 1000 in cvd diamond process, while the high temperature limits its application in optical window and coating such as gaas, zns etc. low temperature can not only make diamond crystal nucleus finer, reduce surface roughness of diamond films and lessen light dispersion, but also eliminate thermal stress

    化學氣相沉積金剛石膜過程中，襯底的典型溫度為800 1000 ，這么高的溫度限制了其作為gaas 、 zns等低熔點光學材料窗口和塗層的應用。低溫沉積金剛石膜不僅可以使晶粒細化，降低表面粗糙度，減小光的散射作用，而且可以消除熱應力。
  19. The calculation results also show that the elastic constants of li, na, al elevates with the increasing pressure value and decline with the increasing temperature value, which illuminate the soften effect of these metals with rising temperature

    計算結果表明：本方法計算典型金屬彈性常數隨壓力升高而增大，在有限溫度條件下，隨溫度升高而降低，表現出軟化效應；高壓下溫度對彈性常數的影響相對較小。
  20. Aluminum and tin plated copper cups are available for calibrations not exceeding 221 f ( 105 c ) and temperature overrides not exceeding 250 f ( 121 c )

    鍍鋁和鍍錫銅杯適用於不高於華氏221度（攝氏105度）的標定溫度內，極限溫度不能超過華氏221度（攝氏105度）
分享友人
分享到 Line

分享到臉書