點滴分析 的英文怎麼說

中文拼音 [diǎndīfēnxī]
點滴分析 英文
drop analysis
  • 點 : Ⅰ名詞1 （液體的小滴） drop （of liquid） 2 （細小的痕跡） spot; dot; speck 3 （漢字的筆畫「、」）...
  • 滴 : Ⅰ動詞（液體一點一點地向下落） drip Ⅱ名詞（一點一點地向下落的液體） drop; droplet Ⅲ量詞（用於滴下的液體的數量） drop
  • 分 : 分Ⅰ名詞1. （成分） component 2. （職責和權利的限度） what is within one's duty or rights Ⅱ同 「份」Ⅲ動詞[書面語] （料想） judge
  • 析 : Ⅰ動詞1. （分開; 散開） divide; separate 2. （分析） analyse; dissect; resolve Ⅱ名詞（姓氏） a surname
  • 點滴 : 1. （零星微小） a bit; crumb 2. （滴劑） drop 3. （藥劑靜脈滴注） drip; intravenous drip
  1. Through the analysis of contest experimental test questions from 1995 to 2003, it is found that metage, synthesis, standardization and determination are the characteristics of these years " experimental test questions. chemistry experiment is based on the elementary knowledge, especially checking the usage of suction pipet and buret. the core of questions lies on the basic operation of metage, dissolution, suction, refluxing, filter, wash and titration

    通過對1996 - 2003年化學競賽決賽實驗題進行分析得出： 「稱量?合成?標定?測定」是近幾年實驗試題的特點；化學實驗重在基礎，特別是考察移液管和滴定管的使用；基本操作如稱量、溶解、移液、回餾、抽濾、洗滌、滴定等是實驗考查的重點。
  2. Through the special studies on impacts to atomizing and humidifying effect from such factors as the firing pin type, centrifugal structure, higher spraying pressure, less aperture, initial water temperature and original state of the air, some conclusions are obtained, such as : the centrifugal nozzle with firing pin type, high pressure and little aperture has bigger air eddy and atomizing angle. the spaying liquid has high velocity. the droplet is small, and the heat and mass transfer velocity is high

    通過對撞針型結構、離心式結構、較高的噴水壓力、較小的噴嘴孔徑、噴水初溫及待加濕空氣初狀態對霧化加濕效果的作用原理的重點分析，得到：撞針型高壓小孔徑離心式噴嘴具有較大的空氣渦與霧化角，噴出的液體流速高、液滴小、水與空氣傳熱傳質速率高，撞針型結構提高了霧化加濕效率，高壓小孔徑的特點為霧化加濕提供了較大的能量，而噴水初溫的升高會減小水的粘性力和表面張力，從而優化加濕效果。
  3. Afterwards, the remnant lactic acid in lactide was measured by non - aqueous titration with sodium methoxide and the remnant water was surveyed by karl - fisher method. the melting point was investigated by thiele tube and the characteristics of lactide were analyzed by ir, uv spectrum, tg and dsc respectively

    然後，用甲醇鈉非水滴定法測定丙交酯中殘存乳酸，卡爾-費休法測定丙交酯中殘存水的含量，用提勒管測定精製丙交酯熔點，用紅外吸收光譜、紫外光譜、差熱分析對合成的丙交酯以及回收的丙交酯進行表徵。
  4. Analysis of experimental data indicates that there exist several following problems during the whole operation : first, the emission is serious and the density of hc and co smoke is very high at on and off period. second, there is oil dripping from the dripping vitta as a result of the fault of ignition system and combustion structure. the last, there might be accidents of disabled ignition resulted from the improper operation at the beginning

    通過對樣機的試驗分析和研究表明，汽車空氣燃油加熱器在整個工作過程中，其排放存在以下三個問題：一、開機和關機兩個階段的排放問題嚴重，廢氣中hc和co的濃度值及煙度測量值都很高；二、因點火系統和燃燒結構的缺陷而導致開機后一段時間內有油滴從滴油管滴落；三、在點火過程中，會出現因操作不當而點火失效的現象。
  5. Transitional feature of the arc and metal droplet in the welding process with steam shielded arc is investigated by means of analysing the waveforms of welding voltage and current under different welding regimes and it is found that there are two types of arc process behavor ? " arc starting - arc blowing out - short - circuiting " and " arc - starting - short - circuiting ". under the condition of constant diameter of welding wire and its feeding speed, the arc process behavor can be changed by adjusting the inductance of welding circuit as well as the voltage of power supply. if arc process behaves as alternative process of " arc starting - arc blowing out - short - circuiting " with minimum time duration of arc blowing out and maximum frequency of short - circuit transition, the welding process will be stable with less spatter and smooth weld bead

    通過分析不同焊接規范下的焊接電壓和電流的波形.研究了水蒸氣保護下電弧及熔滴過渡的特點，發現其電弧過程行為有「燃弧?熄弧?短路」和「燃弧?短路」兩種形式.在焊絲直徑和送絲速度一定的情況下，通過調節焊接迴路中的電感量和電源電壓，可以改變電弧的過程行為形式.若電弧過程呈「燃弧?熄弧?短路」交替進行，並且熄弧時間最短時，短路過渡頻率最高，在這種情況下，飛濺小，焊道成型好，焊接過程穩定
  6. Using the dsd models and forward scattering amplitude computed by the least squares fitting method, the specific attenuations at l - 400ghz have been computed and analyzed, the parameters of " power law " relation between specific attenuation and rainfall rate are obtained. the specific attenuations in qingdao, guangzhou and xinxiang are compared with itu - r specific rain attenuation models

    利用平均雨滴尺寸分佈和點匹配法計算的雨滴的前向散射數據計算和分析了青島、廣州和新鄉地區1 ? 400ghz特徵雨衰減特性，得到了特徵雨衰減與降雨率的指數關系參數，並與itu - r （ internationaltelecommunicationunion - radiocommunication ）特徵雨衰減模式進行了系統的比較研究。
  7. Scattering of the cloud or raindrop for radar wave was always the principal causes of meteorological interference. the author, according to specific property of the spherical or unspherical points, analysed some decline phenomena in propagation for radar - wave, especially the typhoon rainstorm

    雲雨滴對雷達波的散射是產生氣象干擾的主要原因.根據球形、非球形質點的散射特性，分析了雷達波在傳播過程中受其影響所產生的各種衰落現象，特別是臺風暴雨
  8. The basic principle of spectrum method in color measuring and its specialty are analyzed, and it is used in judging the ending of acid - alkali titration. the whole structure and the light source driver circuit are designed in detail ; the single chip control system ' s hardware interface and software design are given

    分析了光譜法顏色測量的基本原理及特點，並將它應用於酸堿滴定的終點判斷，具體設計了顏色測量系統的整體結構與光源驅動電路。
  9. Afterwards, the former presidium looked back last year ' s work, pointed out the shortage and talked of the happiness and affect in work

    然後，張曉敏等上一屆主席團成員回顧總結了過去一年的情況，分析了工作中的些許不足，更多地，談到了在俱樂部收獲的點點滴滴的快樂與感動。
  10. This paper reviewed the modeling and experiments of the transient phenomena involved in the various subsystems of the thermal spraying process at home and abroad, such as : effect of process on droplets behaviors, microstructure, residual stress analysis and spray materials, and based on experimental resuts to discuss the droplets thermal - transfer discipline and effects on coatings properties

    摘要從熱噴塗工藝參數對塗層形成的影響、微觀組織及殘余應力分析和噴塗材料等幾方面對國內外熱噴塗塗層形成機理的研究進展進行綜述，重點綜述了工藝參數影響液滴行為的研究，並結合試驗探討了液滴的熱傳輸規律及對塗層最終性能的影響。
  11. The labyrinth - type emitter can be directly applied to irrigation experiment, the flow rate of 8 emitter prototypes are mensurated under 12 pressure values on the test - bad. moreover, experimental data are analyzed with multivariable linear regression in matlab, formulas of pressure versus flow and regression plots for 8 different emitters are induced from the regression analyses

    製作出的一體化滴頭原型直接連接到水力性能試驗臺上進行流量試驗，測定了12個壓力點下8種滴頭原型的出水量；應用matlab軟體中的多元線性回歸演算法對所得試驗數據進行了回歸分析，得出了8種滴頭的壓力流量公式和回歸曲線圖。
  12. Methods of analysis of fats and fatty oils - physical methods - determination of flow and drop points

    脂肪和脂肪油的分析方法.物理方法.流動和滴點的測定
分享友人
分享到 Line

分享到臉書