點的位置 的英文怎麼說

中文拼音 [diǎndewèizhì]
點的位置 英文
point position
  • : Ⅰ名詞1 (液體的小滴) drop (of liquid) 2 (細小的痕跡) spot; dot; speck 3 (漢字的筆畫「、」)...
  • : 4次方是 The fourth power of 2 is direction
  • : Ⅰ名詞1 (所在或所佔的地方) place; location 2 (職位; 地位) position; post; status 3 (特指皇帝...
  • : 動詞1. (擱; 放) place; put; lay 2. (設立; 布置) set up; establish; arrange; fix up 3. (購置) buy; purchase
  1. Usually, the sun passes through vernal equinox, summer solstice, autumnal equinox and winter solstice on march 21, june 21, september 21 and december 21 respectively

    每年3月21日6月21日9月21日和12月21日前後,太陽便會分別運行至黃道上春分夏至秋分和冬至點的位置
  2. Consider the reflecting point halfway between geophone positions 10 and 11.

    反射點的位置在第10和第11道檢波之間。
  3. As the camshaft rotates, the lobe, or high spot of the cam, pushes against parts connected to the stem of the valve

    當凸輪軸旋轉時,凸輪凸起或者高點的位置,推動氣門座。
  4. Because of adopting fixed groundwork, position of every observation station is immovability, agility of instrument is poor, singular fixed stand can not meet the need of modern equipment

    由於採用固定地基方式,各觀測點的位置不動,儀器設備機動性差,單一固定站已不能滿足現代化裝備要求。
  5. Using the thermodynamic conditions describing the coexistence of two phases and the stability conditions of equilibrium state, we have calculated the normalized temperature and the normalized pressure of the triple point ( t1, p1 ), the melting curve, vapouring curve and the sublimation curve. the whole phase diagram of the 2d monatomic l - j system is obtained

    和杜宜瑾等人方法類似,我們先給出了系統在相變一些參數數值,在此基礎上,考慮占據率q因素,利用相平衡熱力學條件及平衡態穩定性條件,得到了二維單元l - j系統熔化曲線、汽化曲線、升華曲線以及三相點的位置,從而給出了該系統完整三相圖。
  6. When a building is selected and if a ground rally point is set the rally point will briefly animate

    當選中一個建築中並且它集結地已經設,那麼集結地點的位置將會簡單顯示。
  7. The identification of an " age " with a particular zodiac constellation is based on the sun ' s position during the vernal equinox

    十二星座「時期」鑒定是建立在太陽在春分點的位置基礎上。
  8. The main work includes : the kinematic properties of a planner 4 - bar linkage are researched deeply using the assur group theory. the displacement, velocity and acceleration of each joint point in a motion period are put forward and their curves of the relevant points are plotted

    通過運動學分析,得出平面連桿機構在一個運動周期中各鉸接點的位置、速度和加速度以及各桿件角速度、角加速度等運動學參數,並繪制出相應變化曲線。
  9. The basic idea is to take advantage of the ( known ) locations of beacon nodes and the constraints that these locations and the measurements ( e. g., distance, angle ) derived from their beacon signals must satisfy to detect malicious beacon signals

    基本想法是利用指標節點的位置,而且這些和測量(舉例來說,距離,角度)起源於他們指標訊號了一定要滿足發現懷惡意指標訊號
  10. An activity rule is creatively brought forward for the selection of measurement locations. the sample is divided into three parts, i. e. active section, inactive section and dead section. according to this rule the corresponding method for selection is proposed

    在試驗技術方面,本文創新地提出了篩選試驗測試活度規則,將試件分成活性區、惰性區和盲區,並以此來指導試驗測試點的位置選擇。
  11. It supposed that the circle of sliding surface run through the foot of slide. the factor of safety is transmitted to the function of x coordinate of the intersection point of the tangent at the scrap of the circle and x axis. so, the two - dimension area of searching is changed to one - dimension

    該方法先固定潛在滑動圓弧上、下邊界,利用滑弧后緣處切線與x坐標軸交點的位置確定了滑弧曲率,將二維搜索麵域簡化為一維搜索線域,搜索上、下限有嚴格界定,不存在漏問題。
  12. Firstly, the circumstances of focimeter, the working principle of automatic focimeter, the mcu arm and the picture sensor are introduced in this paper. and then based on the optical principle of the automatic focimeter, the research on the optical arithmetic of lens ’ parameters and the arithmetic on the picture point are presented. and after that, the design of the whole system, the design of the optical system, the design of the mechanical system and the design of the electrical system are discussed. and then the design of the hardware system and the design of the software system are emphatically discussed

    本文首先介紹了焦度計概況、自動焦度計工作原理、 arm單片機及圖像傳感器;然後結合自動焦度計工作原理,對焦度計中一些光學參數演算法以及中心像點的位置檢測演算法進行了研究和討論;接著介紹了總體方案設計、光路系統設計、機械繫統設計以及電氣系統設計;接下來重討論了硬體和軟體設計。
  13. In the simulation of close water test, varied profiles of velocity of flow are obtained at different leakage location along the detected pipe, the variety values of the water level in the check well are acquired with time, consequently the location of the leakage can be judged

    在閉水試驗時,通過模擬沿管道長度方向上不同滲水流速變化,以及得出窨井出口處隨時間變化值,來判斷管段中最有可能出現滲漏點的位置
  14. By omitting certain particular conditions inconsistent with actualities, we can also obtain a similar result in the position distribution of discrete eigenvalues and their limit points for this kind of operators

    在省略某些不符合實際特殊條件情況下,對這類運算元離散本徵值及其聚點的位置分佈,同樣獲得了一個類似結果。
  15. Exp ( n ) method was used to predict the end of transition process

    判斷轉捩點的位置採用工程上較為常用exp ( n )方法。
  16. Although kwai tsing is a residential cum industrial district, there are still a number of spots worth visiting for local people or tourists. you could start in the morning by visiting tsing yi, and then go to kwai chung to have lunch in a restaurant in the shopping centre there. in the afternoon, you might like to take a view of the kwai chung container terminals at lai king hill road

    雖然葵青是一個住宅及工業區,但也有不少可供外國或本港人士游覽好去處。葵青區分為青衣及葵涌兩部分,遊人可利用公共交通工具前往這些景。網頁內地圖清楚顯示各個景點的位置,只要跟隨地圖所指示方向便可找到你地。
  17. Innovation of the aero maintenance system based on augmented reality ( ar ) technology and eye tracking technology, which can give real - time instruction for maintenance, is vital for enhancing the accuracy of maintenance and reducing the cost of maintenance. in the paper, the study work include 3 sections, as following : firstly, deducing 3d registration algorithm based on markers, depicting the display and 3d display technologies of artificial matters, and realizing 3d registration function specifically ; secondly, establishing an eye - movement measurement system based on the infrared television method, making use of the thoughts of ranks superimposition to withdraw the pupil center coordinates, and giving the thaught of recombining the position relation of purkinje spot to determine the eye sight direction primarily ; finally, describing the basic theory of augmented reality maintenance guiding system in detail, and introducing the software function and hardware frame, which will provide the foundation for the further study of this system

    本文研究工作主要包括以下三個部分:首先,改進了有標志三維注冊演算法,並具體實現了三維注冊功能,最後試驗驗證了注冊演算法正確性,為將來基於無標志發動機維修誘導系統研究提供基礎和實踐經驗;其次,描述了基於紅外電視法視線跟蹤系統基本原理,對眼動信號處理技術做了初步研究,即利用了行、列疊加思想提取了瞳孔中心坐標和普爾欽( purkinje )斑坐標,闡述了結合瞳孔中心與普爾欽( purkinje )斑點的位置關系進行初步判定視線方向方法;最後,詳細描述了所構建增強現實維修誘導系統基本原理、軟硬體框架,為今後維修誘導系統深入研製提供基礎。
  18. In this paper, we study the influence factors about acid - base titration jump and the stoichiometric point deducing approximate calculation formula of acid - base titration. some useful results are obtained

    摘要本文推導出了強酸強堿、一元弱酸弱堿、多元弱酸弱堿滴定突躍、化學計量近似計算式,用公式說明了影響滴定突躍因素及化學計量點的位置,並得出了一些重要結論。
  19. As the infrared touch screen works with infrared. when sleeves touch the screen, the screen will respond, too when a finger touches the screen, the sleeves may also touch it. so the mouse cursor is likely to point at the finger point

    由於紅外屏工作原理是靠紅外線來工作,所以平時當衣袖等物碰到紅外屏時也起觸摸作用如用手觸摸屏時,衣袖也同進到屏上,就會出現鼠標指針不在手指點的位置上,這個問題不是漂移現象。
  20. Control to the bottom of the form near the center

    控制項拖動到窗體底部靠近中心點的位置
分享友人