aqueous layer 中文意思是什麼
aqueous layer
解釋
水層-
A method to calculate quantitatively the adsorption volume or adsorption space of per mass of adsorbent derived from both the adsorbed molecule volume and the maximum adsorbance of a solute in an adsorption isotherm under a given experimential condition is presented firstly for a solid / liquid adsorption system of the solute in a dilute aqueous solution. this method is suitable for not only mono - layer adsorption, but also mani - layer adsorption and micelle adsorpion of surfactant constructed by hydrophile and lipophile groups. therefore, the surface concentration of the adsorbate, cs, deduced from the adsorption volume is possessed of the meaning of true concentration, and the value of the patition coefficient of the adsorbate between solid and liquid phass, p, attained by the cs and the c, solution concentration of the adsorbate, can be accurate. the foregoing a set of calculations are presented for the solid - liquid adsorption systems consisted of the wool fiber and separately dodecyltrimethyl - ammonium bromide ( dtab ) and hexadecyltrimethyl - ammonium bromide ( ctab ) in this paper. this provides a strong basis for adsorption thermodynamic investigation of adsorbate
對稀溶液中溶質的固/液吸附體系，首次提出了根據吸附分子體積和實驗條件下吸附等溫線中的最大吸附量計算單位質量吸附劑的吸附體積或吸附空間的方法.此法適用於單層吸附，也適用於多層吸附和具有親水親油結構的表面活性劑分子的膠團吸附.由此，吸附質的表面相濃度cs具有真實濃度的含義，相應地，計算得到的溶質的固/液分配系數p就有了準確值.分別計算由溴代十二烷基三甲銨（ dtab ）和溴代十六烷基三甲銨（ ctab ）與羊毛纖維構成的液/固體系分配系數等，為溶質吸附的熱力學研究奠定了基礎 -
The study conducted research on the following four fields : firstly, the characteristics of the interfacial polymerization system of piperazine aqueous solution / trimesoyl hexane solution were systematically investigated. the results show that at a certain molar ratio between the two monomers, piperazine and trimesoyl, at the two phase interface, a dense functional layer of ultra low pressure, high permeating flux and high salt rejection formed by controlling the time of interfacial polymerization, such as the composite membrane ( i ), the concentration in water phase is 0. 4 %, and 0. 1 % in organic phase, and the polymerization time is 1 minute
本文主要進行了四個方面的研究，首先系統分析和研究了哌嗪水溶液均苯三甲酰氯正己烷溶液界面聚合體系特徵、界面聚合反應中各影響因素對膜性能的影響等，結果發現，當界面處兩相單體（哌嗪和酰氯）分子摩爾比為某一比值時，通過控制界面聚合時間（有機相處理時間） ，可以形成超低壓高通量高脫鹽的緻密功能層，如復合膜（ ） ，水相濃度為0 . 4 ，有機相濃度為0 . 1 ，聚合時間1min 。 -
It set up the development of the world recognized high performance nanofiltration composite membrane of aromatic polyamide, on the basis of reviewing the development, the importance in the membrane separation technology, the classification, the fabrication technique and the current development of the research and the application of the nanofiltration membrane. polysulfone was chosen as the material for making the porous substrate because of its excellent compress - to - denseness resistance, its cheap price and its great availability. by fabricating an ultra thin polyamide functional layer on the polysulfone substrate through interfacial polymerization taking piperazine as the monomer in aqueous phase and trimesoyl chloride as the monomer in organic phase, high performance nanofiltration composite membranes of ultra low pressure and ultra high permeating flux were prepared
選擇耐壓密性能優良，價廉易得的聚碸材料為制備復合膜基膜材料，哌嗪為水相單體，均苯三甲酰氯為有機相單體，通過界面聚合反應在基膜表面形成超薄功能層，制備了超低壓高通量聚哌嗪均苯三甲酰胺聚碸納濾復合膜，以0 . 1 mgso _ 4溶液為測試液，所得高脫鹽平板復合膜（ ）在0 . 4mpa下，脫鹽率為96 . 1 ，通量達85 . 2l -
The middle aqueous layer provides moisture and supplies oxygen and other important nutrients to the cornea
中間的眼房水層提供了水分、氧氣和其它角膜需要的重要的營養物質。
分享友人