axial strain 中文意思是什麼
axial strain
解釋
軸向應變-
Methods. apparent glucose diffusivity measurements were performed on 10 axial and 10 radial af specimens from bovine coccygeal discs. the dependence of diffusivity on compression was determined using 3 levels of strain ( 0 %, 10 %, and 20 % )
方法：測量來自牛尾骨椎間盤纖維環10個軸的和10個輻射的樣品來獲得葡萄糖近似擴散系數。壓縮狀態下的擴散系數決定於3個等級的拉伸（ 0 % ， 10 % ，和20 % ） 。 -
This paper simply introduces the device of on - line monitoring for the thrust of the rotating maching, then discu ed the finite dement analyses on the on - line monitoring elastic dement for measuring thrust in detail, in order to develop the performance of the se or and the device, we calculated the distribution of the stre 、 strain 、 axial di lacement in the elastic element using the finite element method when the axial forces f = 3 104n, the result is very satisfied
簡單介紹大型旋轉機組軸向力在線監控裝置，然後詳細介紹軸向力測力彈性元件的有限元分析，為了提高所研製的測力傳感器的性能，採用有限元方法計算了彈性元件在軸向力f = 3 104n時的應變、應力、靈敏度及軸位移等的分佈情況，分析結果表明：所設計的測力傳感器完全符合廠方的要求及儀表性能指標。 -
In different in terne die travel, the metal flow characterize in warm extrusion forming processes and the affection for the flow of metal stage which made by the difference between the blank bottom altitude and the axial direction limiting size in warm extrusion forming technique have been analysed we have gotten the equivalent strain field and the velocity field and other field variable that the blank in different in terne die travel and the die travel - load curve. at the same time, we have analyzed the contributing factor for the oil pump stator forming process optimized and achieve thereasonable die parameter for the war m extrusion forming finally, the optimized technics parameters were used into pilot production, then the qualified oil pump stator forging were produced, the analog results were compared with those of pilot production
論文具體分析研究了不同成形工藝過程中金屬流動的特點，並對不同凸模行程下溫擠成形過程中的金屬流動特點、坯料連皮厚度（底部高度）與溫擠壓成形工藝中的軸向界限尺寸的差值對金屬變形階段的影響進行了分析，獲得了坯料在不同凸模行程下的等效應變場、速度場等場變量及凸模行程-載荷曲線，同時對油泵定子成形過程的影響因素等進行了分析，優化並獲得了合理的溫擠成形工藝及模具參數。最後，利用模擬優化獲得的各項工藝參數進行生產實驗，得到實際生產出的合格油泵定子件，並將模擬結果與生產實驗結果進行比較。 -
It is determined that with accurate knowledge of the complete stress - strain curve of concrete in compression, steel in tension, and with an iterative computerized non ? linear method, it is possible to predict the entire moment - curvature, moment - flexural rigidity and axial rigidity relation ship of a cross - section of a structure member
可以確定，只要知道混凝土受壓和鋼筋受拉的完整的應力應變關系，採用選代的非線性計算方法，就有可能預測結構截面彎矩一曲率、彎矩一彎曲剛度和軸向剛度的關系。 -
Axial symmetric strain
軸向對稱應變 -
Columns under axial compression and biaxial bending. in the beginning of the paper, it summarized the history and the actuality of the nonlinear analysis of special - shaped columns and the capability of the sliding of reinforcement anchoring. on the basis of related papers, the full path of stress - strain relation of concrete and the sliding of longitudinal reinforcement anchoring are all considered
本論文主要內容是對鋼筋混凝土異形截面雙向壓彎柱（包括l形、 t形、十字形柱）進行非線形全過程分析，首先綜述了異形柱構件非線性分析以及粘結滑移性能研究的歷史與現狀，在有關文獻基礎上考慮了受拉縱筋和周圍混凝土的粘結滑移和混凝土應力?應變關系曲線的下降段。 -
The content of the paper is nonlinear analysis of complete response process for t, l - shaped and " + " shaped section r. c. columns under axial compression and biaxial bending. on the basis of related papers, the full path of stress - strain relation of concrete and the sliding of longitudinal reinforcement anchoring are all considered, simultaneously, the restriction effect for concrete by thickening of stirrups is also included
本論文主要內容是對鋼筋混凝土異形截面雙向壓彎柱（包括l形、 t形、十字形柱）進行非線形全過程分析，在有關文獻基礎上考慮了受拉縱筋和周圍混凝土的錨固滑移和混凝土應力?應變關系曲線的下降段，同時考慮到在箍筋加密區箍筋對混凝土的約束影響。 -
Objective. to determine the apparent glucose diffusivity in 2 directions ( axial and radial ) of bovine af under 3 levels of compressive strain ( 0 %, 10 %, and 20 % )
目的：測定牛纖維環在低於3個等級（ 0 % ， 10 % ，和20 % ）的壓縮應變下在2個方向（軸的和輻射的）上葡萄糖的近似擴散系數。 -
Here, fem is applied in the analyses of i ) fiber axial stress and interphase shear stress in fragmentation tests during initially applied strain, ii ) influence of temperature on the stress transfer across the interface, iii ) modulus and thickness of the interphase and their influence on interfacial stress transfer, iv ) interfacial debonding process, and v ) fragment aspect ratio, contact friction along the interface and their influences to the interfacial stress transfer efficiency
在論文的這部分工作中，使用有限元法描述和分析了逐節斷裂試驗中初始應變下的纖維軸向應力和界面相剪切應力，溫度對界面應力傳遞的影響，界面相模量和厚度、纖維節長寬比、界面脫粘過程、界面接觸中的摩擦效應等因素對逐節斷裂試驗中應力傳遞的影響。 -
Responsive mechanism of fiber gratings to temperature and axial strain
啁啾的長周期光纖光柵的透射譜特性 -
In the condition of the different confining stress and the temperature of 8. 8 ?, dynamic strain of the asphalt concrete is very little within 100 vibration times under rather big dynamic stress, the total axial strain is only about 1 % ~ 2 % within 3000 ~ 5000 vibration times
在不同圍壓和8 . 8條件下，對瀝青混凝土施加較大的動應力，在100振次以內所產生的動應變是很小的，即使施加3000 5000振次，軸向總應變也僅為1 2左右。 -
A switchable and spacing - tunable dual - wavelength linear cavity edfl is demonstrated experimentally using this kind of bragg grating for wavelength selection. it exploits the birefringence characteristic of the fbg induced by transverse strain. transverse strain loading on the fbg allows the wavelength spacing to be controlled while axial strain shifts both wavelengths together
2 .對軸向及側向應力共同作用下的光纖布拉格光柵的透射及反射光譜特性進行了理論及實驗研究，並首次把軸向及側向應力共同作用下的光纖光柵應用於光纖激光器進行波長選擇，得到了室溫下穩定工作的波長及波長間隔可調的可開關雙波長的摻鉺光纖激光器。 -
Commonly, ultrasound elastography can only obtain the axial strain distribution of tissues with an external compression
摘要超聲彈性成像通常只能得到組織在外部壓縮作用下的縱向應變分佈。 -
In this paper, a method by the use of the stress - strain relations and the iterative calculation based on the finite element analysis was proposed to reconstruct the elastic modulus distribution from the axial strain distribution of tissues
本文提出一種利用組織的應力應變關系和基於有限元分析的迭代計算方法，從組織的縱向應變分佈重建出組織的彈性模量分佈。 -
The reflection wavelength tuning of fbgs by applying axial strain and lateral strain is discussed, and the theoretic results in both of the above situations are presented
探討了光纖布喇格光柵的軸向應變調諧和橫向應變調諧機理，並對兩種調諧技術給出了理論分析結果。 -
The sensor utilizes the parallelism relationship of twisted axis twisting strain and torsion, axial strain and axial force, and also adopts signal transmission principle with non - contact
這種傳感器利用了受扭軸扭轉應變與扭矩、軸向應變與軸向力的對應關系，採用了信號非接觸傳輸原理。 -
5. the sensing properties of multimode fiber gratings was investigated experimentally and theoretically in this paper. experimental results show that the bragg wavelength of grating in multimode graded - index fiber is linearly dependent on its temperature and axial strain and its repeatability is good
五、對多模光纖光柵的傳感特性進行了實驗研究與理論分析，結果表明這種光柵三個反射峰的布喇格波長隨溫度和軸向應變變化均呈現出良好的線性關系，並且重復性相當好。 -
The pore air pressure gradually goes up with the developing of axial strain in the process of the dynamic torsional shear test of loess, but the pore water pressure hold the line or goes up a little in the last. the stress - strain dynamic constitutive relationship of intact loess and man - made loess show the hyperbolic model. there are some remarkable differences of strength and strain between unsaturated loess and saturated loess
研究結果表明：非飽和黃土在動力扭剪試驗過程中，隨著軸向變形的發展，孔隙氣壓力逐漸上升，而孔隙水壓力則基本保持不變或後期略有升高；原狀黃土和重塑黃土的應力應變本構關系呈雙曲線型；非飽和黃土和飽和黃土的強度及變形特性存在明顯差異；進而分析了含水量、固結應力和固結應力比對黃土動力特性的影響本文最後對非飽和土的有效應力計算公式進行了討論。 -
Multi - axial strain gauge
多軸應變計 -
It is shown from the research that the non - proportionally multi - axial strain - controlled cyclic deformation of 304 stainless steel at high temperatures has distinct dependence on temperatures and loading paths
研究表明： 304不銹鋼的高溫非比例多軸應變循環變形行為具有明顯的溫度依賴性和路徑依賴性。
分享友人