band pass signal 中文意思是什麼

band pass signal 解釋
帶通信號
  • band : n 1 帶，繩；帶形物；箍；箍條；嵌條；鑲邊；鋸條； 〈pl 〉 （法官等的）寬領帶。2 束縛，羈絆；義務；...
  • pass : vi （passed passed past ）1 經過，通過；穿過；越過；超過；掠過；前進。2 （時間）流逝，推移；轉化...
  • signal : n 1 信號，暗號；信號器。2 動機，導火線 （for）。3 預兆，徵象。adj 1 暗號的，作信號用的。2 顯著的...
  1. For phonetic signal modulation, if the pass band range of the band pass filter ( bpf ) is 300hz - 3400hz, the anti - noise properties of laser are approximately independent of bias current and parameters of the cavity ; when the pass band range of bpf increases to a certain degree, modulating bias current and parameters of the cavity can improve the anti - noise properties of laser

    對語音調制情況，如帶通濾波器的通帶范圍取為300hz - 3400hz ，則激光器的抗噪聲性能基本不依賴于偏置電流和腔內參數；當帶通濾波器的通帶范圍增大到一定程度，調整偏置電流和腔內參數可以實現半導體激光器的高抗噪聲性能。
  2. First, how to conduct sample and quantification of continuous time signal which is prior condition of sdr is explored in detail, and the comparison and analysis of some sample modes are given in which band pass signal sampling theorem is most important. second, multi - sample rate signal processing which is an important basis of sdr is studied. emphasis are put on decimation and interpolation those are the most fundamental process and the realization of decimation and interpolation filter

    在基於中頻采樣的軟體無線電結構框架下，首先詳細探討了軟體無線電的前提條件，即如何對連續時間信號進行采樣量化，比較分析了幾種采樣的方式，其中最為重要的是帶通信號采樣定理；然後探討了軟體無線電的一個重要基礎，即多采樣率信號處理，重點討論其最基本的兩個過程抽取和內插以及抽取器和內插器的實現；接著介紹了結構簡單、適用於一級抽取的cic濾波器和適用於做2倍抽取的半帶濾波器；再次論文在總結了傳統的調制解調基礎上，結合軟體無線電器件的特點，系統的探討並實現了基於正交思想的am 、 fm 、 ask 、 fsk 、 bpsk 、 qpsk的正交調制解調演算法。
  3. Eddy - current sensor conversion circuit consist amplification circuit, band - pass filter circuit, demodulation circuit, differentiation phase and data sampling circuit. these circuits are used to convert the test signal of eddy - current sensor to discrete signal tend to process. the microprocessor system that formed of dsp chip is used to data fitting of test system, data displaying and data communicating with personal computer, etc. the interference questions of hardware design and the measure of eliminating interference signal in the subject are introduced in the last of this chapter

    硬體電路的設計主要分三大部分來實現：激勵源電路部分，由分頻電路和頻率合成電路組成，產生頻率穩定的激勵信號以確保檢測任務的正常進行；傳感器變換電路部分，由放大電路、濾波電路、檢波電路、鑒相電路和數據採集電路組成，主要將電渦流傳感器檢測線圈檢測到的信號變換成只含有被測信息的離散信號，易於后續電路處理；由dsp晶元構成的微處理系統，主要完成檢測系統的數據擬合、顯示及與主機通信等功能。
  4. This paper presents the means of obtaining the parameter of signal converter and formulas for achieving the value of every parameter through math illation. the design means for band - pass filter involved in this subject is discussed and particularly, the steps and formulas for designing butterworth band - pass filter are expounded and the transfer - function of band - pass filter used in this subject are also given

    通過神經網路的曲面擬合，很好地解決了本課題中所涉及的多個相互耦合的被測參數的解耦問題和標度變換問題，同常規s型非線性響應函數bp神經網路數據擬合相比，減小了計算量，節省了檢測系統在檢測過程中的計算時間，擬合結果表明。
  5. Parallel structure of poly - phase decomposition and parallel mixer is applied in the ddc circuit, it solves the bottleneck in mixing and increases the handle speed. the partition of the tuning channel according to the digital mixing sequence, and the ddc by means of decimating first, the low - pass filtering and mixing realize efficiently the down - conversion of the variable carrier frequency band - pass signal. according to the structure of the ddc and the requirement of the frequency

    短數據快速測頻演算法的具體實現:使用并行流水線的設計方法，提高了系統的數據吞吐率，在100mhz的系統時鐘下，能夠實時處理400mhz ~ 600mhz速率a / d采樣的數據，在64點采樣， 100mhz系統時鐘情況下，初次測頻佔用時間640ns ，以後每次測頻佔用時間縮短到160ns ，實時地提供多相濾波下變頻所需的載頻位置信息，縮短了接收機的調諧時間。
  6. Filter poly - phase decomposition method is adopted in this dissertation. the partition of the tuning channel according to the digital mixing sequence, and the digital down - conversion by means of decimating first, the low - pass filtering and mixing realize efficiently the down - conversion of the variable carrier frequency band - pass signal

    本文採用濾波器多相分解方法，按數字混頻序列劃分調諧通道，使用先抽取，后低通濾波，再混頻的數字下變頻結構，高效實現了變載頻帶通信號數字下變頻。
  7. After that, it discusses the principle of the band - pass technology, illuminating the feasibility of the digital intermediate frequency system based on the sampling speed which is two times lager than the signal band but unsatisfying the nyquist theorem

    隨后討論了帶通采樣技術的原理，說明可以使用不滿足奈奎斯特低通采樣定理但大於信號帶寬兩倍的采樣速率進行中頻數字化，減輕基帶處理負擔。
  8. Then ， we complete the intermediate frequency digital acquisition and tracking circuits according to the band pass sample theory, digital signal processing theory, multiple rate signal processing theory and digital filter theory

    接著，基於帶通信號采樣理論，數字信號處理理論，多速率信號變換理論，數字濾波器理論，設計出了中頻數字捕獲與跟蹤電路。
  9. Sampling theorem for band - limited low - pass signal with disturbance from a sine signal

    正弦信號干擾下低通帶限型頻譜信號的采樣
  10. The exact design methods of switched - current filters are summarized, such as the director synthesis of z - plane, euler mapping, state variable analysis, matrix decomposition, and signal - flow - graph simulation of the lc and switched capacitor prototypes. at the same time, a modified left decomposition matrix method is proposed to overcome the usual problems of large silicon area, high sensitivity and component spreads by minimizing the input circuits. examples of switched - current low - pass, high - pass and band - pass filters are given to verify the feasibility of these methods

    總結分析了實現高精度開關電流濾波器設計的各種實用方法，包括z域綜合法、歐拉映射法、模擬無源lc網路和開關電容網路的狀態變量法、矩陣分解法和信號流圖轉置法，並對左分解法加以整理改進，提出一種更為簡潔的設計結構，通過減化輸入電路克服一般電路中存在的佔用矽片面積大、靈敏度高等問題。
  11. A new model about measuring harmonics on - line is proposed in this paper. after band pass filtering, sampling storage and the monitoring on - line with artificial neural network ( ann ), we can obtain the harmonics signal, which is used to compensate harmonics. using the basic principle of analog parallel harmonics measurement and a special multi - layer feedforward neural network, a corresponding harmonics measurement on - line is built

    在本文中提出了一種新型電網諧波監測系統模型，通過帶通濾波器，采樣存儲器以及神經網路組成的監測系統可以實時監測電網諧波，當電網中的3次、 5次、 7次諧波超過容許值時，給出控制信號啟動以記錄儀記錄諧波，並可以控制諧波補償，最終達到監督電網，抑制諧波、減小諧波的目的。
  12. Simulation indicates : using band - pass sampling is right in digitalizing if signal ; it is necessary to use special chip to process if digital signal ; at the same time, it is feasible to process base - band low speed signal ( am, fm etc. ) by software

    模擬表明：中頻數字化技術，使用帶通采樣方案是恰當的；現階段對中頻采樣信號使用專用晶元作降速率處理是必然選擇；同時，對基帶低速率信號（如am 、 fm 、 bpsk信號）作全數字化軟體處理是切實可行的。
  13. In vibration test, the signal is always along with noise. if the noise belongs to white noise, fourier transform is very suit to identify and process it, after then remove it. but when there exists low energy impact signal, traditional band pass filter remove noise and the precise position of impact signal is blured

    對于白噪聲，由於它是穩定信號，所以也可以使用fourier變換定位，以便在合適的頻段進行提取。但是對于低能量突變瞬態信號，在信噪比比較低的情況下，由於帶通濾波的平滑作用，瞬態信號的位置信息也變得很模糊了。
  14. Band - pass signal sampling theory in software radio

    軟體無線電中帶通采樣理論的研究
  15. The key problem of signal sampling in software radio is then discussed. at the end of the chapter, an application of band - pass sampling used in a radio receiver is described

    然後對常見的幾種采樣方案作了分析比較，說明了在軟體無線電盲接收應用中選擇帶通采樣方案的理由。
  16. Firstly, the theory and the architecture of hardware system are described, secondly, the steps of the signal processing are discussed in detail. based on the experiments and the characteristics of the signal, we pre - process the signals with band - pass filter, proportional amplifier and coherent demodulator. after sampling and analysis doppler information, we display the final results distinctly to alarm in time

    然後，結合系統中各主要部分的任務，詳細介紹了信號處理的各個步驟：通過實驗比較，並結合接收信號的特點，選用帶通濾波器、比例放大器、相干檢波等技術對信號進行預處理；然後對獲得的多卜勒信息進行采樣和頻譜分析；最後，用比較直觀的形式顯示數據結果，以及時準確地告警。
  17. Direct sampling theorem of band - pass signal

    帶通信號的直接采樣理論
  18. This paper discusses key technology in the digital intermediate frequency receiver with wide band based on software radio, including down - converter on condition of band - pass - sampling, digital down - converter, multi - rate digital signal processing, band - pass signal decimating, and achieves software system simulation based on under - sampling

    摘要分析了基於軟體無線電的寬帶數字中頻接收機中的關鍵技術帶通采樣下變頻技術、數字下變頻技術、多速率處理技術，並實現了欠采樣技術條件的軟體系統模擬。
  19. In this paper they study a position - detecting system based on microprocessor and psd ( position sensitive detector ). the method is as follows : when the ac - signal from psd which is illuminated by modulated light source passes through an active band - pass analog filter, it filters the ac signal which represents the object light source. then the dc - converter circuit transforms it into dc - signal which is used to calculate the position

    這一系統採用的方法是通過對位置敏感探測器psd受到調制目標光源照射后輸出的模擬交流信號進行有源帶通濾波，提取出代表目標光源的調制頻率成份，再將該信號轉變為用來參與位置解算的直流信號，然後選用單片機組成硬體電路，對直流信號進行採集處理並與計算機建立通信，把數據送入計算機進行位置解算，分析判別目標光源和psd器件的相對位置。
  20. The application of saw in spread spectrum communication was studied. 2. the direct band - pass sampling on the intermediate frequency despread and demodulation algorithm of ds / d8psk signal was investigated, a new despread and

    2 .詳細研究了ds / d8psk信號的中頻直接帶通采樣解擴解調演算法，提出了適合於ds / d8psk信號的優化的通用解擴解調演算法。
分享友人
分享到 Line

分享到臉書