blow ratio 中文意思是什麼

blow ratio 解釋
吹脹比
  • blow : vi （blew blown ）1 （風）吹。2 （汽笛等）叫，鳴，響。3 喘氣；吹氣；（鯨等）噴水；噴氣。4 （輪胎...
  • ratio : n. （pl. ratios）1. 比，比率，比值；比例；系數。2. 【經濟學】復本位制中金銀的法定比價。vt. 1. 用比例方式表達；求出…的比值；使…成比例。2. 將（相片）按比例放大或縮小。
  1. Based on the numerical simulation and accuracy analysis to previous slab ' s test with the ansys program, the study of composite wall, with various detail design under potential load action respectively or jointly is carried on and the wall ' s atress behavior and failure mode is obtained, also the influence to wall ' s stiffness and bearing capacity by kinds of factors, including wall ' s shear span ratio, member ' s section, bar arrangement, etc. based on the hammer blow test and stiffness test, a 1 / 3 scale ten - bay model ' s modality parameter and elastic deformation characteristic is analyzed

    在對密肋復合墻板運用ansys ~ （ （ ? ） ）程序進行數值模擬、分析驗證的基礎上，對典型組合墻體在不同連接構造和不同荷載效應組合作用下的受力形態和破壞模式進行研究；計算分析了復合墻體剪跨比、邊框柱截面尺寸、邊框柱配筋大小以及墻板內肋梁肋柱配筋等諸多因素對密肋復合墻體承載力及剛度的影響，得出其變化規律。
  2. The results showed that the discharge coefficient of film cooling hole was greatly increased with the increase of blow ratio when the blow ratio m is lower, buta it had a little increase with the increase of m when m is larger

    實驗結果表明，在吹風比較小時，隨吹風比的增加流量系數大幅度增加，當吹風比較大時，隨吹風比的增加流量系數增幅減小。
  3. The effects of blow ratio and rows on film cooling effectiveness and heat transfer coefficient was studied

    研究了吹風比、孔排等因素對氣膜冷卻效果和換熱系數的影響。
  4. We must think of three factors to make a best capital structure. first factor is margin tax shield, namely, the ratio of firm value ' s increment for liability and the increment of liability blow. second factor is finance crisis net lost that is bought in future. thirdly. we must make much of the market action and adjust capital structure

    確定一個最優的資本結構主要考慮以下三個要素：第一，邊際稅盾，即由於負債導致企業價值增量與負債額的增量的比值，以邊際稅盾為零作為界點；第二，估計未來可能招致的財務危成本；第三，密切關注市場的反應，不斷調整資本結構。
  5. With increasing blow up ratio, both the axial orientation and the crystallinity of tubular films increase. with increasing draw down ratio, only the axial orientation increases while the crystallinity does not change significantly

    管膜的結晶度隨吹脹比的增加而增大，當拉伸比增加時結晶度沒有明顯變化。
  6. The height of media 、 the ratio of gas to liquid 、 hydraulic loading 、 the organic and ammonia loading of influent are the key factors influence the performance of one - stage aerobic baf. the conclusions of the experiment are as following : the best height to remove the organic matter and ammonia is at 60cm 、 120cm from the influent side respectively. the best ratio of gas to liquid is 3 : 1 4 : 1 ; the organic and ammonia loading of influent have litlle influence on the performance of one - stage aerobic baf when the concentration are low ; whe the ratio of gas to liquid is 3 : 1, the ammonia loading is blow 0. 87kgnh _ 4 ~ + - n / m ~ 3. d, the enfluent concentration of ammonia is blow 5mg / l which satisfies the water reuse standard ; at different organic loadings, the removal of organic matter keeps 35 % 45 %. hypothermia is unfavourable to nitrification for one - stage aerobic baf to removel ammonia, the influent concentration of ammonia can ’ t satisfy the water reuse standard

    試驗表明:對有機物的去除主要發生在進水端60cm內，對氨氮的去除主要發生在進水端120cm內;曝氣生物濾池運行的最佳氣水比為3 : 1 4 : 1 ;在進水有機物和氨氮濃度比較小時，水力負荷對其去除率影響不大;在氣水比為3 : 1 ，進水氨氮負荷小於0 . 87kgnh4 + - n / m3 （濾料） ? d時，出水氨氮小於5mg / l ，滿足回用水的要求;在不同有機負荷下，有機物去除率保持在35 % 45 % 。
  7. Putting the potassium permanganate into the filter can improve its effect, the removal of organics and ammonia is increased, the influent concentration can satisfy the water reuse standard. but the turbidity of influent is unsatisfactory. the c / n ratio is the key factor to influence the nitrogen - removal of the anoxic / aerobic two - stage baf when the reflux ratio 、 hydraulic loading and the ratio of gas to liquid in aerobic filter are fixed. the anoxic / aerobic two - stage baf has a good removal of organics at different c / n ratio when the reflux ratio is 2, hydraulic loading is 2. 55m ~ 3 / m ~ 2 ? h and the ratio of gas to liquid in aerobic filter is 3 : 1. the influent concentration of organics is blow 7mg / l. from the beginning to 30cm of the anoxic filter, the removal of the organics is significant ; as the c / n ratio increasing, the influent concentration of ammonia is decreasing. when the c / n ratio is 3. 60, the enfluent concentration of ammonia is 3. 05mg / l which satisfies the water reuse standard. when the c / n ration is less than 3. 60, because of the imperfection

    迴流比為2 : 1 ，水力負荷為2 . 55m3 / m2 ? h ，好氧柱氣水比為3 : 1時試驗表明:不同的c / n （ 1 . 05 7 . 45 ）下，兩級曝氣生物濾池對有機物有很好的去除作用，出水有機物濃度小於7mg / l ，其中在缺氧柱進水端30cm內對有機物的去除最為明顯;隨著c / n的增加，系統出水氨氮濃度降低，當c / n為3 . 60時，出水氨氮濃度降到3 . 05mg / l ，已經滿足回用水的氨氮標準; c / n < 3 . 60時，因為缺氧柱的不完全反硝化，體系中硝酸鹽氮和亞硝酸鹽氮發生積累影響了好氧柱的硝化反應使氨氮降解效果較差;系統對總氮的去除隨著c / n的增加而增加，當c / n為3 . 60時，出水總氮已經降到11 . 18mg / l ，滿足回用水的要求。
  8. In the thesis domestic and foreign relation model of standard penetration blow count and shearing velocity, standard penetration blow count and deformation modular, shearing velocity and foundation bearing capacity are analyzed. on base of these analysis a new calculation model that applying rayleigh wave velocity to calculate the stress ratio of pile and soil between piles is established. because of the difference of region and soil character, the new model own three branch model, ie, japan model, wuhan model, xia liaohe mo del, in three different conditions

    文章通過分析國內外標準貫入擊數與剪切波速、標準貫入擊數與變形模量、剪切波速與地基土承載力之間的關系模型，並考慮到地區性和土質類別的差異，分別選用日本公路橋梁抗震設計新規程模型（日本模型） 、武漢地區模型、下遼河平原模型三種模型建立了新的樁土應力比計算模型? ?應用瑞雷波速求解樁土應力比之間的計算模型。
  9. However, the cellulose chains of tubular films have obvious axial orientation with respect to the machine direction. moreover, the casting speed, draw down ratio and blow up ratio also have significant influences on the film mechanical properties and supermolecular structure

    上述研究，對nmmo法纖維素膜的工藝條件、結構、性能和成形機理有了一個全面深入的認識，為該膜的進一步應用開發提供了實踐指導和理論基礎。
  10. The simulation results show that the shaped degree is decreasing when the spinning temperature and intrinsic viscosity are increasing ; the spinning speed has little effect on the shaped degree when the pump mass throughput is constant ; the shaped degree is increasing with the increasing of pump mass throughput when the spinning speed is constant ; the cross air - blow conditions have much effect on the shaped degree ; the scope of shaped cegree is increasing when the aspect ratio of spinneret hole is increasing ; the shaped degree has obvious decreasing tendency in the small zone of spinning path and this decreasing became gently when the pump mass throughput is increasing

    模擬的結果表明：扁平纖維的異形度隨著紡絲溫度及特性黏度的升高而降低；泵供量一定時，紡速對異形度的影響不大；紡絲速度一定，異形度隨著泵供量的增大而增大；吹風條件對異形度的影響較大；隨著噴絲孔的長寬比的增大，異形度增加的幅度也較大；異形度在紡程上較小的區間內有明顯的下降趨勢，並隨著泵供量的增加其下降的趨勢變緩。
  11. The results show that : blow ratio is a main influential factor to the film cooling effectiveness, the film cooling effectiveness decreases with the increasing of blow ratio ; the film cooling effectiveness of discrete holes fluctuate dramatically across the transverse section, and dead zone is prone to occur be tween two discrete holes

    結果表明：吹風比對氣膜冷卻效果的影響很大，冷卻效果隨吹風比的增大而降低；圓孔氣膜冷卻效果沿橫向位置波動較大，孔之間容易形成冷卻死區。
分享友人
分享到 Line

分享到臉書