chamber wall temperature 中文意思是什麼

chamber wall temperature 解釋
燃燒室壁溫度
  • chamber : n 1 〈古、詩〉室，房間；寢室，臥室；〈pl 〉套房；〈pl 〉律師[法官]辦公室。2 會議室，會場；議會，...
  • wall : n 1 墻壁；（石、磚等的）圍墻；城墻。2 （形狀、用途）像墻壁的東西，障壁；土堤，堤防。3 （礦井、容...
  • temperature : n. 1. 溫度，氣溫。2. 體溫。3. 〈口語〉發燒，高燒。
  1. By analyzing and experimentally verifying the model, new ways of improving mixer performance were put forward. ( 1 ) heat water should be used in the mixer ' s temperature control to make the mixer work with optimal parameters. ( 2 ) the surface materials of the mixing chamber and rotors should be chosen rationally to change material surface energy and increase friction on them. ( 3 ) when the compound was processed under higher pressure of floating weight, shallow groovers or stripes parallel to the axle of the rotor should be made on the mixing chamber internal wall to increase the real contact area and improve mixing effect

    通過對模型的分析和實驗驗證，提出了提高密煉機混煉效果的新途徑： （ 1 ）密煉機溫度控制採用溫水冷卻，使密煉機處于最佳工作狀態； （ 2 ）通過合理選擇密煉室和轉子表面材料以改變材料表面能來增大膠料與它們之間的摩擦力； （ 3 ）在上頂栓壓力較大的條件下，在密煉室內壁與轉子軸線同方向加工淺的光滑槽可明顯改善混煉效果。
  2. The ignition processes of two stages pc are studied. the influence of particle diameter distribution, parameters of two coal - air mixture, wall temperature of first ignition chamber is investigated

    數值模擬方法的建立，為感應加熱煤粉無油點火的研究開拓了研究思路，提高了研究進度，降低了研究成本。
  3. Test results show that the ignition process of pc in ignition chamber includes three stages. the effects of velocity, pc concentration and wall temperature on the ignition of pc are studied

    試驗結果證實煤粉氣流在感應加熱點火室內的著火過程分為三個階段，揭示了煤粉入口速度、煤粉濃度、點火室壁面溫度對煤粉氣流著火的影響規律。
  4. It is discovered that the combustion condition of the second stage pc is up to the outlet temperature of the first stage pc and the content of combustible gases in first stage flue also plays positive effect on the ignition of second stage pc. the effects of parameters of two coal - air mixture, wall temperature of first ignition chamber and annular filling air on imfit are studied experimentally in this thesis. in this thesis, the numerical simulations of ignition and combustion of pc in imfit are conducted

    本文通過建立數學模型，對感應加熱煤粉多級無油點火進行數值模擬，研究了一級煤粉煤粉在點火室內的著火過程和二級點燃過程、煤粉粒徑分佈對煤粉多級無油點火的影響，研究了一級點火室壁面溫度、一級煤粉氣流和二級煤粉氣流的風粉參數在煤粉多級無油點火過程中的影響規律；根據二級點燃段的流場和溫度場分佈，研究了環形夾心風推遲二級煤粉著火的機理。
  5. The combustor do n ' t fail if transient rise of temperature field is neglected, the stress field of combustor can n ' t cause gas film wall rupture. 2. combustor ' s creep and relaxation is calculated in steady temperature field, the results show that creep and relaxation is not main reason destroying combustor chamber

    對穩態溫度場下的蠕變鬆弛計算表明，高溫下的蠕變鬆弛促使火焰筒的熱應力下降，在所考慮的條件下穩態溫度場導致火焰筒的蠕變變形不是火焰筒破壞的主要原因。
  6. Great difference in pressure for two flow made pressure wave system and it help to extend the delay time for gas in chamber, which increases combustion effusion. second, to increase combustion effusion, the inlet temperature of air and gas should be enhanced in the range of heat releasing in chemical reaction. third, the first work condition is unburned absolutely and the second work condition is burnt in shear layer of inlet and the end of down wall zone in straight segment

    對于壓力差很大的兩股氣流，所形成的壓縮波系的結構可以增加燃氣駐留時間，提高燃燒穩定性;為了提高擴散燃燒的效率，在保證能放熱的化學反應溫度范圍之內，應適當提高燃氣及空氣的來流入口溫度;燃氣噴嘴應居於燃燒室軸線上，是改進超音速燃燒室結構的一種思路。
  7. The research indicated that, if the secondary combustion chamber was looked on as a controlled object, with the adjusting valve as a input, the pressure and the temperature of a selected point on the inside wall of the combustion chamber as outputs, then such controlled system would be a strongly non - linear, time varying system with number of random disturbances, which resulted in huge difficulty to build an analyzed mathematics model for the spray burning of the liquid fuel, so that classic control methods were all invalid

    研究表明，若將rbcc發動機的二次燃燒室視為一個控制對象，同時以燃燒室內壁面取定點處的壓強、溫度和調節閥的開度為輸入輸出變量，則該系統將是輸入?輸出特性非線性很強、隨機干擾嚴重的復雜時變系統。這導致建立燃油噴霧燃燒具體模型的很大困難，從而宣告了經典控制方案的失效。
分享友人
分享到 Line

分享到臉書