characteristics under load 中文意思是什麼

characteristics under load 解釋
負載特性
  • characteristics : 產品性能描述
  • under : adv 1 在下，從屬著，服從著。 bring under get under keep under 等〈參看各該動詞條〉。 The ship wen...
  • load : n 1 裝載，擔子；負擔；工作（負荷）量。2 （車船等的）裝載量；一馱，一車，一飛機。3 【電、機】（機...
  1. Determination of dimensional characteristics of sleeping bags - volume under load and easiness of packing

    睡袋尺寸特性的測定.加載下的容積和易包裝性
  2. Determination of dimensional characteristics of sleeping bags - part 3 : volume under load and easiness of packing

    睡袋尺寸特性的測定.第3部分:受載下的容積和易包裝性
  3. The dynamic characteristics of wharf piles subjected to lateral load is analyzed, used the dynamics theory. it gives an analysis and research to the functional mode of wharf foundation pile under flood tide torrent

    論文對水平荷載下碼頭基樁的動力特性進行分析，用振動力學理論對碼頭施工中的基樁進行動力分析。
  4. The products is of high water hydrophobe device usedin suitable and has the characteristics of aging resistance, resistance, tracking resistance, and corrosive resistance. it can withstand high bent load, strong impact force fn12 - 12 series indoor use high voltage load switch fn12 - 12 and fn12 - 12r is of three phases indoor use ac high voltage load switch for breaking and making the circuit of 50hz, 12kv system under rated loading

    Fn12 - 12和fn12 - 12r組合電器是額定電壓12kv額定頻率50hz的三相高壓開關設備用於分合負荷電流閉環電流空載變壓器和電纜充電電流關合短路電流配裝接地開關的負荷開關，可以承受短路電流
  5. Meanwhile, by using delaminating combination finite element method and macro finite element analysis methods, the paper present two kinds of analysis programs. based on the aforementioned analysis program, the failure form, distribution of plastic hinge, load - carrying capacity, displacement and ductility characteristics are investigated to reveal the failure mechanism and the failure proceeding under seismic effects. the results are in good agreement with the test results, indicating the precision of the aforementioned two programs is satisfiable to the practical engineering design

    分別採用分層組合式有限元和宏觀有限元分析方法，編寫了2種鋼筋混凝土中高帶邊框柱剪力墻結構的彈塑性有限元分析程序，同時利用上述2種分析程序，研究了模型結構的破壞形態、塑性鉸的分佈、承載力、位移及延性性能等特性，探討了這類結構在地震作用下的破壞全過程與破壞機理，得到其主要受力特性和抗震性能的一般規律，所得結果與試驗值吻合較好，表明上述2種程序分析結果的精度均可滿足實際工程的設計要求，因此可用於這類結構的抗震性能分析與設計。
  6. This paper uses for reference with an example of frame - shear wall structure and studies the conceptual design and method for optimizationof structural system. through establishing frame - shear wall structure unisonous differential eguation and finding a result, the side shifting curve, moment and shear force distribution curve are obtained under inverted triangle load action on the frame - shear wall structure. after analyzing and comparing, the range of best rigid characteristics for such structure has be gotten

    本文結合框架-剪力墻實例，研討了結構體系的概念設計和整體優化方法。通過建立框-剪結構協同工作的微分方程及求解，得出框-剪結構在倒三角形荷載作用下的側移曲線、彎矩、剪力分佈曲線，經分析對比，得出框-剪結構最佳剛度特徵值區間。
  7. Utilizing the characteristics of quick response, easy for automatization and easy to realize frequent commutation of the hydraulic system, this mechanism can be employed in composing the compound movement in horizontal and vertical direction, which could realize accurate simulation of the motion law for motorcycles and automobiles under the effect of random load in high frequency

    利用液壓系統反應快、便於自動化、易於實現頻繁換向的特點，該機構可用來合成水平、垂直方向的復合運動，實現對摩托車、汽車等在高頻隨機載荷作用下運動規律的精確模擬。
  8. When the transportation load is long - term evenly distributed, the influences of each relevant factor, i. e. pipeline depth, diameter, deformation module of foundation, poisson ratio of soil and tyre pressure of vehicles, toward mises stress and vertical displacement of pipelines are discussed. when the transportation load is movable and invariable, the changing rules of mises stress and vertical displacement during the vehicle ' s movement are calculated and analyzed, and effects of vehicle velocity and tyre pressure toward these two mechanical characteristics are discussed. when the transportation load is stable and simple harmonic, the changing rules of mises stress and vertical displacement during the time of load function are calculated and analyzed, and effects of vehicle velocity and tyre pressure toward these two mechanical characteristics are also discussed. in three - dimensional analysis, mises stress and vertical displacement of pipelines under three kinds of transportation loads are calculated, and the analysis and discussion of correlative factors are also made

    當交通荷載為長期均布荷載時，討論了各相關因素，包括管道埋深、管徑、地基變形模量、地基泊松比和車輛輪壓大小分別對管道mises應力和豎向位移的影響；當交通荷載為移動恆載時，計算並分析了車輛行駛過程中管道mises應力和豎向位移的變化規律，討論了車速和車輛輪壓對這兩個管道力學性狀的影響；當交通荷載為穩態簡諧荷載時，計算並分析了荷載作用時間內管道mises應力和豎向位移的變化規律，討論了車速和車輛輪壓對管道力學性狀的影響。
  9. After keep working more than 48 hours with full load under normal temperature, the charger should work as usual and no deviation upon the characteristics

    在常溫下?充電器以滿載工作連繼48小時后充電器會正常動作?特性無任何改變。
  10. Considering the relations between idle load characteristics and armature winding parameters of the salient pole propulsive synchronous motor ( spsm ) with its structure, stator tooth and magnetic saturation, the analysis of numerical method for the back electromotive force calculation of spsm is given under various exciting current values

    摘要針對凸極式同步推進電機的空載特性及其繞組參數與電機結構、定轉子齒槽、磁場飽和等緊密相關的問題，分析了在不同勵磁電流下同步推進電機相反電勢的數值計算方法，提出了採用電機磁場能量微動法計算相繞組的參數，並對一臺十二相同步推進電機的繞組參數及其空載特性進行了計算和測量。
  11. After leaving capacitors under no load at 105 for 1000 hours ur to be applied for 30 minutes, capacitors shall meet the specified value for load life characteristics listed above

    電容器在105 ，貯存1000小時后，加額定工作電壓處理30分鐘，測試其電性能應滿足上述耐久性實驗參數要求。
  12. After leaving capacitors under no load at 105 for 1000 hours ， ur to be applied for 30 minutes, capacitors shall meet the specified value for load life characteristics listed above

    電容器在105 ，貯存1000小時后，加額定工作電壓處理30分鐘，測試其電性能應滿足上述耐久性實驗參數要求。
  13. Secondly, the mechanical respond of a typical asphalt pavement structure under heavy load was analyzed according to multilayer system elastic theory and characteristics of heavy loads, and analysis method of ultimate bearing capacity of asphalt pavements was advanced

    其次，利用彈性層狀體系理論，根據重載的荷載特性，分析了典型瀝青路面結構在重載下的力學響應，研究了瀝青路面極限承載力的分析方法。
  14. This study is done for the first time in domestic torpedo business, the mathematic model of cowterrotating motor is established and some special characteristics of torpedo ' s drive cowterrotating dc motor under the load of constant torque or the load of cowterrotating propellers are exposited

    這項研究在國內同行中還是首次進行，它建立了魚雷雙轉推進電機的數學模型，揭示了魚雷雙轉推進電機在恆力矩負載和對轉螺旋槳負載下的一些特殊特性。
  15. In the master thesis, the fatigue characteristics of the ferroelectric films under thermal load and electrical load were investigated. the thermal load was induced by a pulse laser beam of nd : yag and the electrical load was made by rt6000s ferroelectric tester t o act on the films respectively. the effect of thermal or electric loads on the films properties was discussed

    本文對鐵電薄膜在循環的熱載荷和電載荷作用下的疲勞特性進行了研究，分別用nd ： yag脈沖激光器模擬熱載荷、用rt6000s鐵電測試儀模擬電載荷作用於鐵電薄膜，根據實驗結果探討了這兩種載荷對鐵電薄膜性能的影響。
  16. Firstly, its natural vibration characteristics are analysised, and the model used for calculating is checked at the same time. then the static analysis under wind load is performed before linear buffeting analysis is done

    對該橋首先進行了自振特性分析，並藉此檢驗所建橋梁計算模型的正確性，其次進行靜風響應分析，最後對全橋做線性抖振分析。
  17. A 1 / 7 - scale model of three - bay, three - span frame - bent r. c. structure is the first and the largest size in the same testing field in china by now. following studies are chiefly conducted in this chapter : the mechanism behavior of the structure under horizontal earthquake load, including the characteristics of seismic force, the deformed performance, yielding sequence, energy dissipation capacity etc. ; the changing rule of the dynamic characteristics and the stiff degrading in different experimental stages ; the location of the weak stories and the seismic capacity of the structure

    在試驗中主要研究了以下內容：在水平力作用下框排架結構的整體變形能力以及各層的層間變形的大小；框排架結構在不同階段的動力變化規律；框排架柱的變形和承載能力；錯層對結構性能的影響、模型結構裂縫開展過程及塑性鉸形成的先後順序、不同階段該結構的剛度退化規律及滯回耗能特性等。
  18. Taking the traffic load as moving point load, the deformation characteristics of longitudinal section of pavement and composite foundation under moving point load are analyzed, considering the effect of pore pressure, traffic velocity, parameters of pavement structure and subgrade. finally, two examples of pavement section and soft subgrade, longitudinal section of airport runway and composite foundation are calculated

    將交通荷載簡化為移動的集中荷載，計算分析了單次移動加載和循環移動加載條件下道路縱截面與復合地基共同變形特交通荷載作用下道路與軟土復合地基共同作用性狀研究性，探討了孔壓、行車速度及道路結構層和地基參數對道路變形的影響。
  19. Under load conditions, the stress - producing characteristics of the dowel increased with shorter lengths and smaller diameters

    而根柱較短其應力集中也是較明顯，直徑較大者則稍形緩和。
  20. Determination of dimensional characteristics of sleeping bags - part 3 : volume under load and easiness of packaging ; german version en 13538 - 3 : 2002

    睡袋尺寸特性測定.第3部分:有效容積和易包裝性;德文
分享友人
分享到 Line

分享到臉書