circuit impedance 中文意思是什麼
circuit impedance
解釋
電路阻抗-
2000hours low impedance, suit for use in switching power supplies and high frequence circuit
2000小時，低阻抗，適用於開關電源及高頻電路 -
Analysis on impedance peak in rl - c parallel circuit
並聯電路阻抗極值的分析 -
The quot; q quot; calculate and discuss about impedance peak in rl - c parallel resonance circuit
值的計算和阻抗峰值的討論 -
The way of taking one nth out of capacitor ' s the first harmonic capacitive reactance as its nth harmonic impedance is verified whit the data from tang7c. according to the approximately estimating method, the first harmonic impedance of 220kv system is calculated. on the basis of the models, this paper gives the harmonic equivalent circuit of substation and gives the b ( n ) function of the harmonic time n. when the capacitors has different combination, b ( n ) ' s value will also change, with the inputting local measurement data, the paper studies the series and parallel resonance at the substation, and deduces that the reason the capacitor ' s fuse of tang6c is frequently interrupted is that its capacitor current contains a large number of 5th harmonics, and that the reason the discharging pt of tang7c capacitor being exploded is also that the 7th and 9th harmonic currents are amplified
據此，對該站進行了串聯諧振分析和並聯諧振分析，並結合測試數據和有關變電站的運行記錄，指出了導致該站電容器湯6c頻繁燒保險的主要原因是5次諧波電流含量偏高，引起湯7c放電pt爆炸也是因為7次和9次諧波電流被放大。針對這些導致湯陰變電站補償電容器故障的原因，提出了相應的諧波治理措施，包括針對湯6c電容器5次諧波電流含量偏高的原因，提出了停運湯6c電容器或者通過把湯sc電容器的部分容量併入湯6c電容器（湯sc其餘部分停運）以增加湯6c諧波承受能力的措施;針對# 2變低壓側7次和9次諧波電流被放大的現象，提出了在湯7c電容器上加裝一定百分比的串聯電抗器的措施。 -
It combained potentiostat, potentiostatic circuit instrument and ac impedance measurement organticace, which can measure usual dynamic potentio - scan, experiment of dynamic potentio - scan, but also unique measurement of ac impedance measurement, also, this new type electrochemical workstation can carry on complex experiment, sucn as potentio / current scan ac impedance measurement procedural measurment, life - span - circle ac impedance measurement procedural measurement in order to fullfill the goal of track and analysis of parameter in various electrochemical conditions. this graduation thesis indicate the structure, function of the multifunct - ional electrochemical workstation
它把恆電位儀，恆電流儀和電化學交流阻抗分析儀有機地結合到一起，既可以做常規的基本測試如動電位掃描、動電流掃描試驗和電化學交流阻抗測量，也可以做基於這三種基本試驗的程式化試驗，如恆電流充電-電化學交流阻抗測量，電池壽命循環試驗-電化學交流阻抗測量試驗，從而完成多種狀態下電化學體系的參數跟蹤和分析。 -
Since the secondary winding is normally operated into a high-impedance circuit, the secondary current is quite small.
因為次級繞組通常輸入高阻抗的電路，因此次級電流很小。 -
This paper researches and analyses the developments of web technology and magnetostrictive transducers from world wide region. the paper also analyes the characteristics curve of magnetostrictive transducers based on its equivalent circuit and researches the method how to make sure its syntony frequency and its electric simulation network parameters. at the same time, by using jsp technology, a magnetostrictive transducer electric simulation application is designed based on b / s three - tier system structure. the experiment data is fitted by curve fitting module. the equivalent input impedance of it with stimulate loop is separated based on the results of curve fitting and the syntony frequency and electric simulation network parameters of magnetostrictive transducers is determined by the input impedance. the method presented in this paper can determine the syntony frequency and electric simulation network parameters of magnetostrictive transducers with a better accuracy than the testing method of syntony & anti - synton y. further more, jsp, the advanced technology at current, has been used to realize a magnetostrictive transducer web electric simulation system. the system has good human computer interface and the function of resource sharing and information publishing. the research of this paper and its achievements have some practical merits in the researchful and applied fields of magnetostrictive transducer
用java編程語言編寫的曲線擬合模塊，對輸入的實驗數據進行了最小二乘法的曲線擬合；根據曲線擬合結果可從帶激勵線圈的磁致伸縮換能器的輸入阻抗中分離出磁致伸縮換能器鐵芯在無激勵電流時由機械振動形成的等效輸入阻抗，並由此輸入阻抗確定磁致伸縮換能器的諧振頻率及電氣模擬網路參數。本課題提出的方法與傳統的諧振?反諧振法相比，能更準確地確定磁致伸縮換能器的諧振頻率及其電氣網路參數。同時，採用當前比較先進的web技術，實現了基於jsp的磁致伸縮換能器web電氣模擬系統，該系統具有良好的人機界面和資源共享、信息發布功能。 -
Ic impedance cardiography integrated circuit
阻抗心動描記術 -
On the basis of the equivalent circuit diagram the solid - solid and the composite - electrolyte interfaces, contributed their impedance in the relatively high and low frequency regions
第三部分是探討不同粒徑大小氧化釕奈米微粒復合電極在不同電位下之阻抗頻譜的變化，進而由等效電路圖來解釋其涵蓋的物理意義。 -
For multi - infeed hvdc systems, when the minimum eigenvalue of the system becomes zero, the voltage stability graph can be plotted effective short circuit ratio as function of coupling impedance
對于多饋入hvdc系統，在最小特徵值為零的情況下，可以根據這種關系作出有效短路比?連接阻抗圖，即電壓穩定圖。 -
As the experiment results show, multiple reasons led to the offset of oscillating frequency, including diode ’ s nonlinear characteristic, fluctuation of electrical source voltage, traction of load impedance, change of environmental temperature and humidity and the design of circuit
實驗結果表明多種因素引起了振蕩頻率的偏移，包括二極體的非線性、電源電壓的波動、負載的牽引、環境溫度濕度變化以及電路板設計方面的因素等。 -
In accordance with the driving characteristics of ac driving locomotive, the working status of its traction transformer is analysed. the questions that should be considered in the traction transformer design of ac driving locomotive are mentioned. these questions are the large short - circuit impedance of traction winding, higher harmonic current, over - excitation and dc magnetization caused by large variation of the network voltage, etc. some disposal methods are given
針對交流傳動電力機車的傳動特點，對其中的牽引變壓器的工作狀態進行了分析，指出交流傳動電力機車用牽引變壓器設計時需考慮的牽引繞組的短路阻抗大、電流的高次諧波、網壓波動大可能引起的過勵磁以及直流磁化等問題，同時給出了相應的一些解決方法。 -
After analyzing the noise in the high frequency carrier channel and computing the parameter of channel, we solved the kernel problems of coupling and matched impedance. separate designing the power, power amplification, port, transceiver and other circuits, we fitted together all circuits become the whole lonworks node circuit, and then triumphantly debugged it
經過對高頻載波通道的干擾特性分析和線路參數的計算，解決了耦合和阻抗匹配等核心問題，並對電源、功放、介面、收發器等部分電路分別設計，最後形成了完整的lonworks節點硬體電路，並調試成功。 -
According to the eer theory, using the amplified envelope signal as the power supply of the class - d amplifier, the envelope will modulate the magnitude of the rf signal. the modulated impulse rf signal is added to the impedance match circuit, so the amplified am signal is achieved
將放大的包絡信號作為class - d載頻放大器的電源，根據eer原理， class - d載頻放大器輸出載頻信號的幅度將受到包絡信號的線性調制，達到同時實現對載頻信號的放大和am調制的目的。 -
Above all, we introduce the development of millimeter - wave power combiner and the novel study production at home and abroad. taking circuit form into consideration in the design of millimeter - wave power combiner, the gauge of high reliability and high performance must be defined. we design two kinds of waveguide - to - microstrip transition, the first kind of transition based on the achievement of a matched impedance probe show excellent performance, the second transition can also have good performance on some conditions through numerical simulation
介紹了國內外毫米波功率合成的發展狀況和最新的研究成果。考慮擬以電路合成方式做毫米波功率合成器，必須解決與功率合成有關的相關組件的高可靠高性能指標問題，因此設計了兩種波導微帶過渡結構，其中探針式過渡測試達到了較好的效果，並對所提出的一種新型微帶波導過渡進行了模擬，在一定條件下具有較好的性能。 -
Both ends of the shield are a " floating " ground in most cases, and this creates a complex circuit network consisting of the complex impedance to ground of the output circuit at one end, the complex input circuit impedance at the other end, and the resistance, capacitance, and inductance of the cable in between
大多數情況下屏蔽線兩端是「漂移」的接地端，這就形成了復雜的電路，這個電路的一端相對輸出端的接地點有復雜的阻抗，另一端又有復雜的輸入阻抗以及連接線的電阻，電容和電感。 -
Some design guide lines are discussed based on the structure of the system. the mutual inductance coupling model of the system is introduced. the circuit impedance is analyzed
針對非接觸感應電能傳輸系統的構成，討論了非接觸感應電能傳輸系統的設計準則，介紹了變換器的互感等效電路模型，並進行了阻抗分析。 -
Elements of electrical and optical connection - test methods - electrical elements - measurement of open circuit impedance of couplers
電氣和光學連接元件.試驗方法.電氣元件.耦合器開路阻抗的測量 -
Aerospace series - elements of electrical and optical connection - test methods - part 701 : electrical elements - measurement of open circuit impedance of couplers
航空航天系列.電氣及光學連接元件.試驗方法.第701部分:電氣元件.耦合器開路阻抗的測量 -
Aerospace series - elements of electrical and optical connection ; test methods - part 701 : electrical elements ; measurement of open circuit impedance of couplers ; german and english version en 2591 - 701 : 2001
航空航天系列.光電連接件.試驗方法.第701部分:電氣元
分享友人