concentration boundary 中文意思是什麼

concentration boundary 解釋
浮冰群間的界線
  • concentration : n. 1. 集中。2. 【化學】提濃，蒸濃，濃縮；濃度；稠密度；【礦物】汰選，選礦，富化。3. 集中注意，專心。
  • boundary : n 邊界，疆界，限界 （between）;（球場）邊線；界標；界限，范圍，分野。 aboundary dispute 邊界糾紛...
  1. Here the conductance, carrier concentration and hall mobility ect parameters of er doped cdte films have been given. using seto model, we calculate the grain - boundary barrier of er doped cdte films and analyze the varing dose influence on the grain - boundary resistance

    討論了不同er離子注入量對硅基底上沉積的cdte薄膜結構和光電性能的影響，並具體給出了摻雜cdte多晶薄膜的電導、載流子濃度及遷移率等參數值。
  2. In this paper, some characteristics of flow movement and sediment transport are analyzed by using the flume experiment data. the cross section of compound channel can be divided into four regions : the undisturbed region in main channel, the interactive region between channel and plain, the undisturbed region in flood plain and the boundary region. in the undisturbed regions, the distribution of longitudinal velocity along the depth has the feature of lograithmic. whereas, in the interactive region, the longitudinal velocity does not obey the logarithmic distribution law, but it can expressed as a revised logarithmic function by using a wake function. on the basis of the kinematic equation the velocity distribution of transverse velocity is obtained. in the boundary region, the longitudinal velocity obeys the law of parabolic distribution. furthermore, according to the simplified diffusion equation, the transverse distribution of sediment concentration in the interactive region is deduced. the analysis is in good agreement with the measured data

    本文根據漫灘水流的運動特點，將漫灘水流的復式斷面分為主槽平衡區、灘槽交互區、灘地平衡區及邊壁區等4個區，並給出了各區寬度的經驗公式.根據灘槽交互區垂線流速分佈的變化特點，提出了附加尾流函數的對數流速分佈公式.在簡化水流運動方程和泥沙擴散方程的基礎上，對灘槽交互區內垂線平均流速及含沙量沿橫向分佈進行了理論分析，提出了反映灘槽水流動量交換強度的橫向渦量粘性系數及橫向擴散系數的表達式，得到了漫灘水流垂線平均流速及含沙量沿橫向分佈的解析解，並與實測資料吻合較好
  3. The electronic - ceramic capacitive - type sensor for coi is based on the nanometer and semiconductor theories. according to the mechanism of the gas surface absorbing actions and the mechanism of grain boundary effect of semiconductors, the capacitance of the sensor can be changed with the variation of co2 concentration

    Co _ 2氣敏陶瓷電容型傳感器將納米理論和半導化理論引入了傳感器的研製過程中，這種傳感器通過氣體表面吸附，及在半導體介質的晶界層產生的晶界效應，使得不同濃度co _ 2氣體產生不同的電容值。
  4. The finite element model and result are given. the influence on displacement of different finite element model ' s lateral boundary and the cavities " radius and the variety of dynamic stress concentration at different ratio of long - axis divided to short - axis and material are discussed

    給出了有限元模型和計算結果，討論了有限元橫向邊界不同和孔徑大小不同的情況下對位移的影響，還討論了不同長短軸比和不同材料情況下動應力集中系數的變化。
  5. The metals transported in the various forms by the above processes can be co - consolidated with carbonate precipitation in the top soil, can easily be extracted by ho ac. the structure, weight and mineral constituents of loess change with varies on concentration of ho ac : the boundary between the grain become unclear after different gradually, but when hoac > 3 %, the weight change become smaller. also with increasing of ho ac concentration, the carbonates in loess decreases gradually, while hoac > 3 %, the change become smaller

    不同濃度醋酸提取，黃土的結構、重量和礦物組成發生不同變化：黃土團粒界限變得模糊並出現孔洞，可能說明次生碳酸鹽在黃土中主要成膠結物存在；隨醋酸濃度增高，黃土重量逐漸降低，但當醋酸濃度大於3后，重量變化明顯變小；黃土中碳酸鹽礦物含量逐漸降低，當醋酸濃度3后，變化范圍明顯變小。
  6. Using fcc flow - reaction mathematical model and boundary condition developed in paper ( i ) and the operational constants in commercial fcc riser, the hydrodynamics of catalysts and the distribution of concentration of catalytic cracking products, as well as the temperature of two - phase along the riser are simulated and predicted

    運用已經建立的催化裂化反應的數學模型和模型邊界條件及求解方法，結合煉油廠工業提升管的實際操作參數，模擬預測了催化裂化提升管反應器內催化劑顆粒的流場特徵和原料油反應產物的濃度及氣粒兩相平均溫度的沿程分佈特徵。
  7. Then author discusses the writing and debugging of the program. the ventilation of a typical chamber with a stable fixed pollutant emission is studied by founding different boundary conditions ( here, they are the both up inlet and outlet on opposite side, the up - inlet and down - outlet on opposite side and the up - inlet and down - outlet on the same side. ). and accordingly dividing different grids. using the program, the velocity values and the pollution concentration values of the chamber are worked out

    對所研究的具有單個固定污染源的典型房間的室內通風，通過對異側上送上排、上送下排以及同側上送下排等幾種方式下，建立相應的邊界條件並劃分網格，運用編制的程序對它們進行數值模擬，所得的計算結果再用excel軟體分別進行顯示與處理，得到相應條件下的流場、濃度場，而後再算出相應的通風效率。
  8. The one dimensional continuity equations of n - on - p planar pn junction are solved at different boundary conditions. generalized solutions of photocarrier concentration are given in this paper

    摘要對一維情況下平面pn結的連續性方程進行了求解，給出了不同邊界條件下光生載流子濃度的一般形式解，並對結果進行了分析討論。
  9. Boundary integral method for thick rectangular plants under concentration bending moment

    厚矩形板在集中力矩作用下的邊界積分法
  10. The simulation was began based on defining the boundary which was coupled with heat and mass transfer. numerical simulation was performed with different inlet velocity, temperature, water vapor concentration and channel width

    對于數值模擬的結果，採用后處理工具tecplot等進行處理，得到了一、二次空氣通道內的壓力、速度、溫度以及水蒸汽濃度的分布圖。
  11. The analytic results of the effects on the micromorphological structure of the film by the electrochemical condition ' s showed that the carbon is apt to improve the boundary combination between the scfs and the surface of the cathode and the seperation of the films, and that the micromorphological structure of the mpgcfs is greatly affected by the dring and the power voltage, which remarkably affluence ion move in swelling cathode film, and that higher temperature and concentration of cu2 + in the medium solution are also advanagable to the deposition of cu in scfs. the plot of deformation behavior of mpgcfs showed that the maximum strench ratio decreases and the brittleness increases due to the existence of the metal phase, and that the strengh trend of the composite films is fistly up and down followed with the content of metal phase because of the change of the role of the metal phase from acting as the physical cross - linking to weakening the films due to destroying the whole structure of the polymer

    另外它作為基體的另一個突出的優點是制備的溶脹復合膜（ scf ）中的溶劑與電解液中的溶劑相同都是水，克服了以前膜內外不同溶劑之間擴散的問題，結果使得電流最終趨於一種穩態，因此可以更好實現用電化學條件來控制mpgcf的形態結構；硬質石墨材料的多孔的結構和石墨本身的結構性能特點使得碳作為陰極材料時有利於溶漲復合膜（ scf ）與電極表面的結合以及膜的剝離，因此是作為陰極的理想材料；電化學條件中的乾燥程度和電壓能夠明顯的影響離子在膜內的遷移，從而對mpgcf的形態結構造成較大的影響；而提高反應溫度和增大電解液中銅離子的濃度也有利於銅在膜中的沉積生長。
  12. In order to study the regeneration mechanism of dpf in detail, we still need a mathematical model of the channel unit, which present temperature field and the soot reaction rate of the channel. finally, it points out the influences of various factors to the regeneration process by computing the numerical solution of model under different boundary conditions and geometry parameters, such as the initial temperature, the gas flow rate, the oxygen concentration, the sediment quantity and the wall thickness of the filters, and so on. in this way, the paper provides theoretical guidance for optimization design of the dpf

    首先研究了干凈壁流式過濾體的加熱特性，然後在加熱和燃燒理論的基礎上建立了微粒捕集器再生過程的數學模型，並對模型進行了數值計算，得到了捕集器內部的三維溫度場分佈以及溫度梯度分佈，結果與實驗值吻合較好，驗證了模型的正確性;為了詳細的研究微粒捕集器的再生機理，建立了孔道單元數學模型，得到了孔道內的溫度場分佈和微粒反應速率分佈;最後，通過求解模型在不同邊界條件和不同幾何參數下的數值解，分析了各種因素對再生過程的影響，如過濾體初始溫度、過濾體內氣流的流動速率、氧濃度、微粒沉積量以及過濾體壁面厚度，為微粒捕集器的優化設計提供理論指導。
分享友人
分享到 Line

分享到臉書