condensation point 中文意思是什麼

condensation point 解釋
【物理學】凝點。

  • condensation : n. 1. 濃縮；【物理學】冷凝（作用），凝聚（作用）；壓縮；縮合；凝塊。2. （著作等的）壓縮；壓縮后的形式，節本。
  • point : n 1 尖頭，尖端；尖頭器具；〈美國〉筆尖；接種針，雕刻針，編織針；小岬，小地角；【拳擊】下巴。2 【...
  1. In this process, the moisture of the initial field between the lifting condensation level and the cloud top at the point where rain is observed is adjusted to allow precipitation process to be switched on

    在這個過程中，初始場中降雨區域上空，位於抬升凝結高度與雲頂之間的濕度會予以調整，作用是要啟動降水過程。
  2. At the beginning of this article, we give the analysis about the principle of external condensation. we find out that the most important factor in the condensation is the temperature of the air in the system. and we point out the factors which can make influence in the external condensation, such as the temperature and the humidity of the environment, the temperature and the pressure of the supplying air, the load of the system, the area of passage of speed control valve, and so on. next, we give the mathematics model of the pneumatic system using the knowledge of aerodynamics and heat transfer theory. and using the finite difference method and the numerical analysis we can get the solutions of the model. we use c program to simulate the model

    本文首先對氣動系統外部結露的原理進行了分析，指出了氣動系統內部氣體溫度下降是氣動系統外部結露根本原因，提出了影響氣動外部結露的主要因素，包括環境溫度、環境濕度、供氣壓力、供氣溫度、氣缸負載和調速閥開度等。然後應用氣體動力學、氣體熱力學和傳熱學對氣動系統建立數學模型，用逆步進有限差分法和數值分析演算法對所建模型進行求解，利用c語言編製程序對氣動系統模型進行模擬，給出了氣管及氣缸內氣體的各個時刻的狀態參數。
  3. When the temperature get to the environment dew point, there will be dew on the surface, when the temperature is below zero, we even can find ice on the components. this is the external condensation problem. this problem is a great threat to the safety and service life of the pneumatic system. so this article is the research about it, we try to find out the principle of the external condensation and get a effective method to judge when it will happen, this will give great help to the designer

    氣動系統在運行中會出現系統元件表面溫度下降的情況，當元件表面溫度達到環境露點溫度以下時就會發生結露，當溫度降到零度以下時就會發生結冰，這就是氣動系統的外部結露問題。外部結露對氣動系統的安全和使用壽命都有很大的影響，本文就是針對這一問題進行研究，通過對氣動系統外部結露的原理和實驗及模擬的分析，找出判斷一個氣動系統是否會發生外部結露方法，以對氣動系統的設計提供幫助。
  4. " dew point " refers to water vapour condensation beginning of the formation of small droplets of temperature, time in a container on the " fog rain ", its container transport pose great harm

    「露點」是指水蒸汽開始凝結形成細小水滴的溫度，此時在集裝箱內就形成了「霧雨」 ，它對集裝箱運輸的危害性很大。
  5. This paper with the actual needs of metal physical doping of icf target material and laser - x - ray conversion material is starting point, major for flow - levitation method principle, technology parameter control particle grain size, structure and thermal stability of phase composition that prep aration metal and alloy nanoparticle go deep into research. the principle of preparation metal nanoparticle by flow - levitation method is difference with other evaporate condensation method

    本文以icf靶材料金屬物理摻雜和激光- x光轉換材料的實際需要為出發點，主要對自懸浮定向流技術制備金屬與合金納米微粒的原理、過程和工藝參數控制微粒粒徑大小，所制備納米微粒的結構、物相組成以及組成相的熱穩定性等方面進行了深入研究。
  6. Analysis of fuel gases - general methods - determination of water dew point and relative humidity - principles of cooled surface condensation hygrometers and general description of their use

    氣體燃料分析.第10部分: :通用方法.第3節:水露點和相關濕度測定.第1小節:表面冷卻冷凝濕度計原理及使用說明
  7. Determination of the water dew point of natural gas - cooled surface condensation hygrometers

    天然氣水露點的測定冷卻鏡面凝析濕度計法
  8. Gas analysis. determination of the water dew point of natural gas. cooled surface condensation hygromete % rs

    氣體分析.天然氣露點的測定.表面冷卻露點濕度計
  9. The retrograde condensation impact tends to be unavoidable because the phenomenon that bottomhole producing pressure is lower than dew point pressure is easy to be found in productivity well test

    而在產能試井中很容易出現井底流壓低於露點壓力的情況，因此反凝析現象不可避免。
  10. I set up the mathematics model of heat transfer of the thermal bridge of the building and utilize numerical method to analysis whether occur condensation problem on the internal surface in the thermal bridge or not. through the analysis and studying of this subject, we can make conclusion as followed : because the internal surface of the bared wall body incline to be lower than the air dew point indoor, which apt to dew, with the reducing of out air temperature and increasing of the air temperature indoor

    另外，通過建立建築熱橋的傳熱數學模型，利用數值求解的方法，分析了外墻熱橋部位內表面是否結露的問題，研究得出裸露墻體內表面極易低於露點溫度而結露，並且隨著室外溫度的降低，室內溫度越高，外墻熱橋部位的內表面越容易結露。
  11. It is considered from the analysis of reservoir space distribution and oil physical property that the major causes that controls the reservoir are the position, high oil density, high viscosity and high condensate point, by which the oil migration and accumulation are controlled and not beneficial for oil migration, while beneficial for oil accumulation because of its self condensation and traps

    控制油藏分佈的主要因素為油源位置、原油的高密度特徵、原油的高粘度特徵和高凝固點特徵、原油高密度、高粘度和高凝固點特徵控制了原油的運移和聚集，使原油不利於運移的同時，由於自凝固圈閉而利於聚集成藏。
  12. Surface active agents - determination of cloud point of non - ionic surface active agents obtained by condensation of ethylene oxide ; german version en 1890 : 1999

    表面活性材料.用環氧乙烷冷凝的非離子表面活性劑的濁
  13. To avoid any condensation on the floor slabs in summer, the air supplied is kept at a dew point of 14oc to keep some reserve for the pick up of moisture in the room and to stay below the surface temperature of the ceiling

    為了避免夏季樓板上的凝露，送進的新風保持在14攝氏度的露點溫度，以保證能夠除去室內濕氣，並使其露點溫度低於天花板的表面溫度。
  14. Secondly, when the supply pressure is constant, experiments were carried out with different supply air dew - point and volume ratio of the system. then record the system whether occurring internal condensation or not as the experiment result

    其次，當供氣壓力一定時，對不同容積比的氣動系統，改變供氣露點溫度，進行大量實驗，觀察系統是否發生內部結露，記錄實驗結果。
  15. This paper gives a suggestion after analyzing misconceptions in several other projects that the most crucial point of ventilation designing for indoor swimming pool is to prevent condensation on surfaces of building envelopes

    對于游泳池通風空調設計，本論文結合游泳池設計中普遍存在的許多問題，分析了游泳池環境的特殊性，指出了在游泳池空調通風設計中需要注意的一些問題。
分享友人
分享到 Line

分享到臉書