conventional test 中文意思是什麼

conventional test 解釋
標準試驗
  • conventional : adj 1 因襲的,傳統的。2 習用的;平常的,常規的;形式上的。3 約定的,協定的;會議的。n ism 依從俗...
  • test : n 1 檢驗,檢查;考查;測驗;考試;考驗。2 檢驗用品;試金石;【化學】試藥;(判斷的)標準。3 【化...
  1. This test chooses general industrial vc / vac copolymer as raw material, various supplement material additives are also the common conventional avirulent additive on industry ; the plastic material processing routine is also the universal method to make the thermoplastic plate of low temperature of vc / vac copolymer that accords with medical requirement that its softening temperature is 55

    本試驗選用氯醋共聚樹脂為主要原材料,所用輔料添加劑也是工業上常見的無毒性常規添加劑;採用常規的塑料加工成型方法及設備製造出軟化點為55的、符合醫用要求的低溫熱塑性氯醋共聚樹脂板材。
  2. Adhesives for load - bearing timber structures - test methods - determination of the conventional pressing time

    承重木結構用膠粘劑.試驗方法.常規加壓時間的測定
  3. Adhesives for load - bearing timber structures - test methods - part 6 : determination of the conventional pressing time

    承重木結構用膠粘劑.試驗方法.第6部分:常規壓縮時間的測定
  4. Adhesives for load - bearing timber structures - test methods - part 6 : determination of the conventional pressing time ; german version en 302 - 6 : 2004

    承重木結構件用膠粘劑.試驗方法.第6部分:常規加壓時
  5. An one - dimensional non - equilibrium mathematical model was established to describe the performances of unit adsorbent bed. finite difference forms of the equations were written in matlab. a conventional test bed for investigating the inner properties of cacl2 - nh3 unit tube was developed and the real data were used to test the model

    在前人研究經驗的基礎上,建立了單元管吸附床內一維非平衡吸附條件下的傳熱傳質數學模型,提出了該模型的數值求解方法,並給出了數值模擬算例。
  6. Through numders of analysis on the formation mechanism of modified ashalts used in beijing area, also by conducting conventional test, non - conventional test, special test in laboratory and application on highway paveraent, this research studies the effect of different denaturing agents in modified asphalt. lt makes also before - after studies, comparing different denaturing agents, comparing effect on different basic materials after modification and results in the adaptability of different modified asphalt under different climate and traffic conditions, thus provides a good technical support for the application of modified asphalt on the highway asphalt pavement

    通過對北京地區使用不同種類改性瀝青形成機理的分析、改性瀝青室內常規、非常規、特殊實驗和改性瀝青混合料在公路路面上的實際應用,研究了各類改性劑對改性瀝青所起到的改性效果。並通過改性前後的實驗結果、不同種類改性劑的對比實驗、不同基質瀝青改性后實驗結果的對比,提出對各種改性瀝青在不同氣候條件、交通條件下的適應性,為改性瀝青在公路瀝青路面中的應用提供了良好的技術支持。
  7. According to the working principle of closed cycle diesel engine, the whole solution including charge intake system, seawater management system and monitoring system was put forward in this paper. test - bed of closed cycle diesel engine was established based on a conventional diesel engine with its type 4102bg

    針對本文的主要工作,提出了閉式循環柴油機進氣控制系統和監測系統的具體實施方法,並以4102bg型非增壓柴油機為主機,完成了閉式循環柴油機裝置的試驗臺架建設。
  8. The based - on pc noise test technology on conventional weapons

    技術的常規武器噪聲測試技術
  9. The corrosion behavior of nanocrystalline ( nc ) copper bulks with various grain sizes prepared from igc ( inert gas condemsation ) and vacuum annealing in comparison with conventional microcrystalline ( mc ) copper ( as - rolled and electrolytic ) in acid copper sulphate solution and neutral solution containing chlorides under free corrosion conditions and anodic polarizations has been studied using potentiodynamic polarization, potentiometric analysis, cyclic voltammetry and electrochemical impedance spectroscopy. x - ray diffraction was used to estimate the grain size of the annealed nc copper. field emission gun scanning electron microscopy and x - ray energy - dispersive spectroscopy was used to characterize the surface morphology and analyze the surface composition after the polarization and potentiometric test of both nc and mc copper

    本文研究了用igc (惰性氣體蒸發凝聚原位溫壓法)制備並真空退火到不同晶粒尺寸的納米晶銅和微米晶銅(冷軋紫銅、電解銅)在酸性硫酸銅溶液和中性含氯溶液中,在自腐蝕狀態和陽極極化狀態下的腐蝕性能。使用了動電勢極化、電位測定、循環伏安法( cv )和電化學阻抗譜( eis )等方法。 x -射線衍射( xrd )的方法用來估算納米晶銅晶粒尺寸。
  10. In accordance to the defects presented in using the chinese road asphalt technical standards to assess the asphalt performance as well as the facts that the shrp test equipment of usa can not be widely employed in china since its being very expensive, the shrp rheological concept is utilized in the research project to carry out the exploration of the rheological properties of modified and non - modified asphalt by using conventional tests such as penetration and ductility. the conclusions obtained by using the conventional test rheological index to assess asphalt performance are compared with those by using the shrp rheological index and their certain correlation are found

    針對目前我國道路石油瀝青技術標準評價瀝青路用性能存在的種種缺陷,以及美國shrp試驗設備因其昂貴性而暫時無法在國內大量推廣應用這一事實,本課題試圖利用shrp流變思想,採用針入度、延度等常規試驗設備進行改性及非改性瀝青流變特性的研究,並將常規試驗流變指標評價瀝青路用性能的結論與shrp流變指標評價結論作比較,找出它們之間的相關關系,從而肯定了採用常規試驗設備進行瀝青流變特性及路用性能研究的有效性。
  11. Plasticsplasticized pvc sheets. conventional test method for high frequency welding

    塑料.增塑聚氯乙烯塑料薄板.高頻焊接試驗常規方法
  12. The update report about testing surface acoustic speed shows that the method of test is either destroyed checkout or complicated process in and out aboard. so it ca n ' t be used as a conventional test in batches of producing

    在目前國內外對表面聲速檢測的報告中,檢測方法不是破壞性檢驗就是過程復雜,均不可能作為批生產中一種常規的檢測手段。
  13. Sanitary appliances. resistance to acids at ambient temperature of enamelled surfaces. conventional test method

    衛生設備.搪瓷表面在室溫下的耐酸性能.常規的試驗方法
  14. Roofing and wall cladding. fasteners. determination of the bending characteristic resistance. conventional test method for bending of self - drilling and self - tapping fasteners longer or equal to 70 mm

    屋面和墻壁覆面.緊固件.彎曲抗性的測定. 70mm及以上的自鉆和自攻螺紋緊固件彎曲性的常規試驗方法
  15. Roofing and wall cladding - determination of the bending characteristic resistance - conventional test method for bending of self - drilling and self - tapping fasteners longer or equal to 70 mm

    屋頂和墻面覆蓋層.耐彎曲性的測定.大於或等於70mm的自鉆孔或自攻絲緊固件的常規彎曲試驗方法
  16. Based on the engineering geologic investigation reports of 22 buildings and the author ' s own tests in lab ( which includes 18 groups of conventional test and compression test, 8 groups of unconsolidated undrained triaxial test and 8 groups of quick direct shearing test ), taiyuan silt is studied in the paper. firstly, the variability of silt indexes is analyzed. the analyses results show the change laws on variability, in addition, the average value and variability coefficient ranges of silt indexes are given for reference

    本文以太原地區粉土為研究對象,在收集、整理了22個建築工程場地勘察報告和作者室內試驗成果( 18組常規試驗和壓縮試驗、 8組不固結不排水三軸剪切和8組直剪快剪試驗)的基礎上,對太原粉土作了以下方面的分析研究:首先研究了粉土工程性質指標的變異性,得出了變異系數的變化規律,給出了各工程性質指標均值和變異系數范圍的建議值。
  17. Sanitary appliances. resistance to hot alkaline products of enamelled surfaces. conventional test method

    衛生設備.搪瓷表面耐熱堿物質作用的性能.一般試驗方法
  18. Now it is realized that an oo system ca n ' t be effectively tested with conventional test techniques and more and more people are seeking oo testing methods and techniques

    隨著人們發現傳統的軟體測試技術和方法在測試面向對象軟體時效果很差,這方面的研究也越來越得到重視。
  19. Alongside conventional test procedures like water bubble test and the differential pressure test, our particular speciality is the leak detection by means of carrier gas, where our principle focus is on helium leak detection

    在傳統的諸如水泡測試法和壓差測試法之外,我們的特殊專長是用氣體載體- -氦氣- -來發現泄漏。
  20. The efficiency of using conventional test equipment to study the rheological properties and road performance of asphalt, therefore, are proved. additionally the modification mechanism and the microscope characteristics of modified asphalt are analyzed in the paper to provide some theoretical base for future effective modification to asphalt

    此外,本文通過對瀝青改性前後流變特性的研究,進一步分析了改性瀝青的改性機理及微觀特性,為今後瀝青進行有效改性提供了一定的理論依據。
分享友人