dead weight load 中文意思是什麼
dead weight load
解釋
不變載荷-
Modeling the general solid web continuous box girder and opening - in - web ( open web ) continuous box girder by ansys finite element modeling tool, node stress of governing section and corresponding shear lag values are analyzed. the solution is validated by comparing with variational results and modeling test values. based on the model, the section shear lag induced by dead load, prestress tendons and car loads under the most unfavorable condition and lateral symmetry are also approached. the influence of shear lag effect in double - level continuous box girder is considered with opening - in - web and the web location. the analysis indicates that double - level - load arouses less shear lag effect than one - level - load. when self - weight and prestressed tendons act on together, the shear lag effect on box girder take on a evidently change
基於所建立的有限元模型，本文分別對實腹和腹板開孔兩種箱梁在恆載、車載、預應力荷載作用時，各主要截面的剪力滯效應進行分析，通過施加縱向最不利的和橫向對稱的車輛荷載，研究實腹連續箱梁和空腹連續箱梁在承受雙層荷載和單層荷載時引起的剪力滯效應，並考慮腹板開孔及開孔位置對于連續箱梁剪力滯效應的影響。分析表明，雙層車載對于箱梁引起的剪力滯系數比單層車載的影響要小，對于箱梁中存在引起的剪力滯后現象有一定的改善作用。 -
D finite element local analysis is done for hv porcelain post insulator by abaqus finite element software. the stress distribution of one - piece structure under dead weight, erection deviation, temperature change, wind load and short - circuited load is analyzed, which provides the scientific basis for security assessment of post insulator
以高壓瓷瓶支柱絕緣子為研究對象，採用abaqus有限元軟體進行三維有限元局部分析，分析了整體結構在自重、安裝偏差、溫度變化、風載以及短路電流載荷作用下的應力分佈，為支柱絕緣子的安全性評定提供了科學的依據。 -
The composer anatomizes the present compacting ratio value with the stress distribution property under vehicle load and dead weight load, then pures the smallest stress place in the embankment according to the stress distribution property, and suggests a actual compacting ratio value for embankment firstly according to internal load stress distribution curve. and questions simplified calculation methods for the settlement of embankment
通過路堤在車輛和自重的荷載作用下的應力關系，對現有壓實度標準進行剖析，依此受力特性推導出路基中最小應力發生的位置，根據高路堤內部荷載應力分佈曲線，首次提出符合路堤受力特性的壓實度標準。
分享友人