detector for error 中文意思是什麼

detector for error 解釋
誤差探測器
  • detector : n. 1. 發覺者。2. 偵查器。3. 【化學】檢定器。4. 【電學】檢電器。5. 【電訊】檢波器，指示器。
  • for : FOR f o r ＝ free on rail 【商業】火車上交貨（價格）。1 〈表示目標、去向〉向，往。 leave [sail] f...
  • error : n. 1. 錯誤；失錯。2. 謬見，誤想；誤信；誤解。3. 罪過。4. 【數學】誤差；【法律】誤審，違法；（棒球中的）錯打。adj. -less 無錯誤的，正確的。
  1. Measurement method of the error of signal amplitute for ultrasonic flaw detector

    超聲探傷信號幅度誤差測量方法
  2. Measurement method of the error of signal amplitute for eddy current flaw detector

    渦流探傷信號幅度誤差測量方法
  3. In order to remedy the faults of the traditional pipe - leak detector based on the straight - correlation analysis method which has high demand for hardware and high price, the pipe - leak detector based on the polarity correlation algorithm with the cross - zero method is presented, the hardware design and the test is finished, the result only with the error from 1 % to 3 % is gained, and its feasibility is testifies

    針對採用直接相關法的傳統相關測漏儀對硬體要求高、價格較貴的缺點，將極性相關的過零演算法應用於相關測漏，並設計了硬體結構，進行了實驗模擬，在實驗室條件下，測量誤差約為1 % ~ 3 % ，驗證了其可行性。
  4. The error compensation technique for dynamic leadscrew detector based on 5m laser

    激光絲杠動態檢測儀的誤差補償技術
  5. Then we focus on decision feedback equalization ( dfe ) algorithm which is widely used in mimo signal detection. subsequently, a minimum mean squared error ( mmse ) detector based on wl detection combined with the decision feedback strategy for ca - mimo is derived. meanwhile, the issue that how to use wl detection in da - mimo system is discussed and a solved project is also presented

    本文第四章在介紹了寬線性檢測技術的基礎知識之後，著重針對mimo信號檢測演算法中使用廣泛的反饋判決檢測演算法，提出了一種基於最小均方誤差準則的寬線性反饋判決集中式mimo信號檢測演算法;同時，結合第三章的內容，對分佈mimo信號如何採用寬線性檢測提出了一套解決方案，通過計算機模擬，給出了幾種分佈mimo檢測演算法的性能;結果表明，在採用最優檢測順序的情況下，兩
  6. In accordance with the phase - shift miscalibration and detector nonlinearity, the error - compensating phase - shifting algorithms based averaging technique are proposed. and in order to solve the problems brought by traditional linearity scanning unwrapping algorithm, which leads to incorrect phase unwrapping, a correlative region algorithm for phase unwrapping is developed

    針對相移器的相移不準給相位求解帶來的誤差，提出採用基於平均技術的誤差補償移相演算法；針對傳統線掃描位相去包絡演算法不能對含有較大噪聲的位相圖進行正確去包絡的問題，提出了區域相關位相去包絡演算法。
  7. The experimental results of low - order modes correction for wave - front error and the enhancement of strehl ratio in detector and the improvement of wave - front tilt are also established

    通過低階校正模式波前誤差提高了探測器接收光強，並有效校正了波前傾斜。
  8. Secondly, the performance of the acousto - optic steering system is deteriorated as a result of the coupling because of nonlinear of quadrant detector and the pointing error introduced by satellite platform vibration. for this problem, this paper introduces the model reference adaptive control system, and presents the perfect model. the model reference adaptive controller is designed to force the output of the acousto - optic steering system following the output of the perfect model to improve the system performance

    其次，針對聲光偏轉系統由於器件的非線性造成的耦合和平臺振動造成的指向誤差導致系統性能惡化問題，引入了模型參考自適應控制系統，提出了理想的模型，設計了模型參考自適應控制器，強迫性能惡化的聲光偏轉系統的輸出跟隨理想模型的輸出，使其性能改善，利用超穩定性理論確定自適應參數以保證系統的穩定性。
  9. Summarizing the development statement of monitoring technology for bridge, based on principle of pulse laser ranger detection and fiber - optic strain measurement, in view of the problem affected by single - chip inherent feature, integrating the goodness of cpld device and single - chip, using a / d converter to measure the count quantization error, a strain measurement system is worked out. the above system chiefly consists of light source, optic fiber sensor, photo detector and signal processing circuit

    本文綜述了國內外橋梁監測技術的發展概況，在深入研究脈沖激光測距和光纖應變測試原理的基礎上，針對單片機固有計數頻率低、計數量化誤差大和延時不固定等不足，結合cpld計數頻率高、延時小而固定和單片機控制功能強的優勢，並採用模數轉換技術設計計數量化誤差測量電路，提出了基於激光脈沖時間測量法的光纖應變測量的方案。
分享友人
分享到 Line

分享到臉書