diameter of wire 中文意思是什麼

diameter of wire 解釋
導線直徑
  • diameter : n. 1. 直徑。2. （顯微鏡等的）放大倍數。
  • of : OF ＝Old French 古法語。
  • wire : n 1 金屬線，銅絲，鐵絲，鋼絲；【電學】導線；線路；金屬絲網；【造紙】抄網。2 電信；〈口語〉電報。3...
  1. Measure the diameter of wire with 0. 01mm micrometer

    用分度值為0 . 01的千分尺測量外徑。
  2. The center wire is usually of tungsten or stainless steel and is about 0. 1 mm in diameter.

    中心絲通常是鎢絲或不銹鋼絲，直徑約為01毫米。
  3. Stainless spring steel wire diameter and tensile strength of spring wire

    線徑及拉力列表
  4. Reynolds numbers ( based on average velocity at passage inlet and hydraulic diameter of the passage ) are changing from 20000 to 80000 and the extraction ratios ( suction ratios, sr ) are changing from 0. 30 to 0. 60 for each test model. so the influences of reynolds numbers, suction ratios and etc. on the discharge coefficients and pressure loss characterist ics are also presented. flow fields of typical passages are visualized with the flow visualization techniques and measured with hot - wire anemometer

    對每一種通道結構，實驗在不同通道進口雷諾數（ re = 20000 、 40000 、 60000 、 80000 ）和不同通道總出流比（ sr = 0 . 30 、 0 . 45 、 0 . 60 ）下進行，以研究這兩個流動參數及其它相應變化的參數（氣膜孔的雷諾數re _ h 、氣膜孔與通道的動量比i等）對出流特性和流阻特性的影響規律。
  5. This operation consisted of drawing wire through a die to reduce it to the desired diameter.

    這項作業通過拉線模，把鋼絲拉成符合要求的直徑。
  6. Transitional feature of the arc and metal droplet in the welding process with steam shielded arc is investigated by means of analysing the waveforms of welding voltage and current under different welding regimes and it is found that there are two types of arc process behavor ? " arc starting - arc blowing out - short - circuiting " and " arc - starting - short - circuiting ". under the condition of constant diameter of welding wire and its feeding speed, the arc process behavor can be changed by adjusting the inductance of welding circuit as well as the voltage of power supply. if arc process behaves as alternative process of " arc starting - arc blowing out - short - circuiting " with minimum time duration of arc blowing out and maximum frequency of short - circuit transition, the welding process will be stable with less spatter and smooth weld bead

    通過分析不同焊接規范下的焊接電壓和電流的波形.研究了水蒸氣保護下電弧及熔滴過渡的特點，發現其電弧過程行為有「燃弧?熄弧?短路」和「燃弧?短路」兩種形式.在焊絲直徑和送絲速度一定的情況下，通過調節焊接迴路中的電感量和電源電壓，可以改變電弧的過程行為形式.若電弧過程呈「燃弧?熄弧?短路」交替進行，並且熄弧時間最短時，短路過渡頻率最高，在這種情況下，飛濺小，焊道成型好，焊接過程穩定
  7. Maximum hold largest diameter of power wire

    -掌握最大的線徑電源線
  8. Guide to the choice of aperture size and wire diameter combinations for industrial wire screens and woven wire cloth - general

    工業用金屬絲網篩和金屬絲編織篩布的孔徑尺寸和線徑的組合選擇指南.第1部分:總則
  9. Guide to the choice of aperture size and wire diameter combinations for industrial wire screens and woven wire cloth - preferred combinations for woven wire cloth

    工業用金屬絲網篩和金屬絲編織篩布的孔徑尺寸和線徑的組合選擇指南.第2部分:金屬絲編織篩布的優選組合
  10. Small diameter smooth plug gauge of standard tapping ring for wire thread insert

    鋼絲螺套用標準螺孔環小徑的光滑塞規
  11. Through the man - machine interaction system which consisted of lcd ( liquid crystal display ) and keyboards, we can select welding parameters, such as the way of welding, diameter of the wire, wire feed speed, current, voltage and so on

    主要過程是:通過lcd （ liquidcrystaldisplay ）與鍵盤組成的人機交互系統選擇已存儲在單片機flash中的焊接參數，包括焊接方法、焊絲直徑、送絲速度、焊接電流、焊接電壓等。
  12. Standard test method for measuring diameter of fine wire by weighing

    用稱量法測定細金屬絲直徑的測試方法
  13. Pure copper h90, h88 h85, brass h68, h65, h62, round wire and foreign wire with diameter of 0. 1 - 12mm, as well as special flat copper wire for zipper manufacturer, electrical appliance manufacturer and watch belt manufacturer and international standard zinc - base alloy for injection

    1 2 ，紅銅h90 h88 h85黃銅h68 h65 h62 ，直徑0 . 1 - 12mm規格圓線異型線，以及拉鏈廠電器廠表帶廠等的專用紅黃銅扁線各種注塑用國際標準牌號鋅基合金。
  14. Study on technological process of middle diameter rope wire

    中粗規格制繩鋼絲生產工藝方法的研究
  15. When there are 3 ground wires, they were put between main wire cores, which not increase outer diameter of finished cable

    個地線時分別放在主線芯之間，不增加成纜外徑。
  16. In order to systematically evaluate the process technics, sensing ability to strain and application techniques of the suggested distributed micro - bend strain sensor adopting the winded structure of optical fiber around a small - diameter steel wire rope, some tensile tests of sensor and 3 - point bend tests of concrete beams were conducted

    針對所提出的纏繞式分佈應變光纖傳感器結構，進行了拉伸試驗和三點彎曲混凝土梁試驗，對傳感器的製作工藝、應變反應特性和應用技術進行了系統論證。
  17. Our annual consumption of steel rod at diameter of 6. 5mm is more than 6500mt and our daily productive capacity of woven wire mesh is over 5000 square meters

    年消耗直徑6 . 5盤條6500噸以上，日生產處理各種機織網5000平方米以上的生產能力。年創產值3600萬元人民幣。
  18. We must gauge the diameter of wire first

    我們必須先測量電線的直徑。
  19. A unit of length equal to one thousandth ( 10 - 3 ) of an inch ( 0. 0254 millimeter ), used, for example, to specify the diameter of wire or the thickness of materials sold in sheets

    密耳長度單位，等於一英寸的千分之一（ 10 3 ） （ 0 。 0254毫米） ，如用來標明電線的直徑或按頁出售的材料的厚度
  20. Ferrocement is a type of thin layer to reinforce concrete structure, where usually hydraulic cement is reinforced with layers of continuous and relatively small diameter steel wire mesh. the mesh can be made of metallic materials or other suitable materials

    鋼絲網復合砂漿是以鋼絲網或鋼絲網和加筋為增強材料，水泥砂漿為基材組成的薄層結構，鋼絲網也可以用其它合適的金屬材料代替。
分享友人
分享到 Line

分享到臉書