differential cooling 中文意思是什麼

differential cooling 解釋
差溫致冷作用
  • differential : adj 1 差別的，區別的；特定的。2 【數學】微分的。3 【物、機】差動的，差速的，差示的。n 1 （鐵路不...
  • cooling : n. ,adj. 冷卻（的）。
  1. This article choosed out organic phase change materials, and, the solid - liquid - equilibrium of eleven binary system including fatty alcohol / fatty acid, n - octadecane / fatty acid, n - octadecane / fatty alcohol system were determined by cooling curve, and, t - x phase diagrams of these systems were drawn. the result shows that all these systems are simple eutectic, at the same time, the entropy of phase change of every system in the eutectic point is determined by using differential scanning calorimetry ( dsc ). and n - octadecane / fatty acid systems were calculated theoretically

    本文初選出部分有機相變貯能材料，採用步冷曲線法測定了12醇-羧酸系列、 18烷-羧酸系列、 18烷- 12醇體系共11組體系的二元固液相平衡關系，繪制了這11組體系的t - x相圖，測定結果表明，這幾組體系均為簡單低共熔體系；同時利用差熱掃描量熱法（ dsc ）對上面各組體系低共熔點處的相變焓進行了測定；並對18烷-羧酸系列進行了熱力學理論預測。
  2. Their properties have been investigated by using scanning electronic microscopy ( sem ), differential scanning calorimetry ( dsc ), x - ray diffraction ( xrd ), thermogravimetry - differential thermal analysis ( tg - dta ), infrared spectroscopic analysis ( ir ), and gas chromatography ( gc ), etc. the effects of the mulser ' s stirring rate and the emulsifier concentration on the properties of encapsulated pcms have been systematically studied, and nanopcms have been obtained by increasing the stirring rate or the emulsifier concentration. the influences of different nucleating agents on micropcm performances have also been investigated in detail to search for a suitable nucleating agent to prevent micropcms from super - cooling

    首先，系統研究了乳化機轉速和乳化劑濃度對膠囊性能的影響，並通過提高轉速或乳化劑濃度獲得相變材料納膠囊；其次，系統研究了不同成核劑對微膠囊性能的影響，找到合適的成核劑抑制了相變材料微膠囊的過冷現象；再次，詳細研究了環己烷對膠囊性能的影響，並通過添加適量環己烷提高了相變材料微膠囊及納膠囊的耐熱溫度。
  3. Abstract : the distribution of cooling air which is in the grille - brick of the inner combustion hot air stove has been simulated with three dimension turbulent mathematical model so as to find a method which is used to improve the distribution of cooling air in hot air stove. the influence of differential horizontal plates on the distribution of cooling air is discussed. the results show that original big circle round field of flow in the pillar - cavity is changed into full one - way field of flow and edges gas flow, at the same time, is increased by horizontal plates. there is a different function with horizontal plates and vertical plates. to make the uniform distribution of cooling air in the hot air stove, it is necessary that horizontal plates and vertical plates are used in a combined way

    文摘:應用紊流三維數學模型模擬內燃式熱風爐內冷風在格子磚柱中的分佈，尋求改善其分佈的途徑.討論了加設不同布置的水平導流板對氣流分佈的影響.模擬結果表明，在支柱空腔內加設水平導流板改變了原有大迴旋流場，使迴旋流變成大面積的單向流.通過在支柱空腔內加設水平導流板可以發展邊緣氣流，這恰好與加設豎直導流板的作用相反，水平導流板和豎直導流板的結合使用有望實現冷風在格子磚柱中的均勻分佈
  4. A simple and easy operating criterion is put forward in accordance with the relation between positive - sequence component and negative - sequence component of stator current when the motor is in unbalance and single phase broken. based on analyzing the traditional inverse time - lag overloading protection of motors, an inverse time - lag operating equation with accumulating stator current is achieved, according to the differential equation of the heating and cooling while the current flows into the conductor

    在分析電動機傳統的反時限過負荷保護的基礎上，根據導體中流過電流時的發熱、散熱微分方程得到了累加定子電流的反時限過負荷保護動作方程，經簡化后得到累加定子電流的實用的反時限特性遞推公式。
  5. The input of the heater is controlled with proportional - integral - differential ( pid ) logic. the flux of the cooling fluid is regulated by electronic expansion valve

    系統採用pid演算法控制導電鍍膜的加熱量，同時使用電子膨脹閥調節冷卻介質的流量。
  6. Standard test method for temperature calibration on cooling of differential scanning calorimeters

    差示掃描量熱計製冷的溫度校準的標準試驗方法
分享友人
分享到 Line

分享到臉書